1. Trang chủ
  2. Kỹ Thuật - Công Nghệ

ASME BPVCode XI 2015 inspection of nuclear power plant components

686 1.9K 0
ASME BPVCode XI 2015 inspection of nuclear power plant components

Đang tải... (xem toàn văn)

Tài liệu hạn chế xem trước, để xem đầy đủ mời bạn chọn Tải xuống

Thông tin tài liệu

.. .2015 ASME Boiler & Pressure Vessel Code 2015 Edition July 1, 2015 RULES FOR INSERVICE INSPECTION OF NUCLEAR POWER PLANT COMPONENTS ASME Boiler and Pressure Vessel Committee on Nuclear. .. for Inspection and Testing of Components of Gas‐Cooled Plants 588 Rules for Inspection and Testing of Components of Liquid‐MetalCooled Plants... Construction of High Pressure Vessels IX Welding, Brazing, and Fusing Qualifications X Fiber-Reinforced Plastic Pressure Vessels XI Rules for Inservice Inspection of Nuclear Power Plant Components XII

Ngày đăng: 21/02/2017, 19:58

Xem thêm: ASME BPVCode XI 2015 inspection of nuclear power plant components , ASME BPVCode XI 2015 inspection of nuclear power plant components , IWB-3620 Acceptance Criteria for Ferritic Components Less than 4 in. (100 mm) in Thickness, I-2200 Vessels not Greater than 2 in. (50 mm) in Thickness and All Piping Welds, IWA-3390-1 Multiple Aligned Planar Flaws (1/2 in. = 13 mm), IWA-4623.2-1 Automatic or Machine (GTAW) Temper Bead Welding, IWA-4643.2-1 Automatic or Machine (GTAW) Temper Bead Welding of Cladding, IWB-2500-1 (B-G-1) Examination Category B-G-1, Pressure-Retaining Bolting, Greater Than 2 in. (50 mm) in Diameter, IWB-2500-1 (B-G-2) Examination Category B-G-2, Pressure-Retaining Bolting, 2 in. (50 mm) and Less in Diameter, IWC-2500-1 (C-D) Examination Category C-D, Pressure-Retaining Bolting Greater Than 2 in. (50 mm) in Diameter, A-3620-1 Coefficients G0 Through G4 for Flat Plate Surface Crack With Flaw Aspect Ratio, a/ℓ = 0.0

Từ khóa liên quan

Mục lục

  • Table of Contents

  • List of Sections

    • INTERPRETATIONS

    • CODE CASES

    • Foreword

    • Statement of Policy on the Use of the Certification Mark and Code Authorization in Advertising

    • Statement of Policy on the Use of ASME Marking to Identify Manufactured Items

    • Submittal of Technical Inquiries to the Boiler and Pressure Vessel Standards Committees

      • 1 Introduction

      • 2 Inquiry Format

      • 3 Code Revisions or Additions

      • 4 Code Cases

      • 5 Code Interpretations

      • 6 Submittals

      • Personnel

      • Preface to Section XI

        • Introduction

        • General

        • Inservice Testing of Pump and Valves

        • Owner Responsibilities

        • Duties of the Authorized Nuclear Inservice Inspector

        • Organization of Section XI

          • 1 Divisions

          • 2 Subsections

Tài liệu cùng người dùng

  • Đang cập nhật ...

Tài liệu liên quan