FIGURE 2-6. Drilling and cutting guide. FIGURE 2-7. Drilling and cutting guide. BODY FRAMEWORK 19 that piece. The figures depict each piece as if it were laid lengthwise with its two edges on a workbench then flattened so both sides could be seen. All the figures show the locations and diameter of the holes to be drilled. The locations of the 45-degree angle cuts to be made at the ends of many of the aluminum pieces are shown as shaded areas where the alu- minum is to be removed. Most of the figures are duplicates of each other. The dif- ference between the figures are numbers and sometimes let- ters that appear on the sides of each aluminum piece. The numbers are used when the framework is assembled to the two main sections that make up Questor’s body. The letters are used when these sections are joined together by two con- necting pieces to form the completed framework. In both cases the symbols ensure that all the predrilled holes are in their correct locations when the framework is completed. To mark the numbers and letters on the outsides of each FIGURE 2-8. Drilling and cutting guide. 20 CHAPTER TWO FIGURE 2-9. Drilling and cutting guide. BODY FRAMEWORK 21 FIGURE 2-10. Drilling and cutting guide. 22 CHAPTER TWO FIGURE 2-11. Drilling and cutting guide. BODY FRAMEWORK 23 FIGURE 2-12. Drilling and cutting guide. 24 CHAPTER TWO FIGURE 2-13. Drilling and cutting guide. FIGURE 2-14. Drilling and cutting guide. BODY FRAMEWORK 25 FIGURE 2-15. Drilling and cutting guide. FIGURE 2-16. Drilling and cutting guide. 26 CHAPTER TWO FIGURE 2-17. Drilling and cutting guide. FIGURE 2-18. Drilling and cutting guide. BODY FRAMEWORK 27 FIGURE 2-19. Drilling and cutting guide. FIGURE 2-20. Drilling and cutting guide. . of the aluminum pieces are shown as shaded areas where the alu- minum is to be removed. Most of the figures are duplicates of each other. The dif- ference between the figures are numbers and sometimes. let- ters that appear on the sides of each aluminum piece. The numbers are used when the framework is assembled to the two main sections that make up Questor’s body. The letters are used when. then flattened so both sides could be seen. All the figures show the locations and diameter of the holes to be drilled. The locations of the 45-degree angle cuts to be made at the ends of many of