1. Trang chủ
  2. » Kỹ Thuật - Công Nghệ

CHAPTER 14: Nonsinusoidal Oscillators pps

19 80 0

Đang tải... (xem toàn văn)

Tài liệu hạn chế xem trước, để xem đầy đủ mời bạn chọn Tải xuống

THÔNG TIN TÀI LIỆU

Thông tin cơ bản

Định dạng
Số trang 19
Dung lượng 446,22 KB

Nội dung

CHAPTER 14 Nonsinusoidal Oscillators Objectives Describe and Analyze: • Operation of the 555 IC • Inverter oscillators • Schmitt oscillators • Wave-shaping • Sawtooth oscillators • Troubleshooting Introduction • There are other ways to make an oscillator besides phase-shifters and resonators. • The term astable covers a group of oscillator circuits, many based on hysteresis in one form or another. It also covers chips designed for the purpose, such as the 555. • The old term “multivibrator” is also used to name these circuits. It goes back to vacuum tube days when they actually used electromechanical vibrators in circuits. Square-Wave Oscillators Square wave from a “free-running” 555 circuit. The “Internals” of a 555 Frequency set by R A , R B , and C. Functions of the 555 • The 555 is still popular after all these years because it is easy to use. It performs two functions: – Square-wave oscillator (astable) – One-shot (monostable) • Strictly speaking, a square-wave has a 50% duty cycle. But unless the duty cycle is low, astables are called square-wave oscillators even if it’s not 50%. • A one-shot produces a fixed-width output pulse every time it is “triggered” by a rising or falling edge at its input. 555 Oscillator f OSC = 1.44 / [(R A + 2R B )  C] 555 One-Shot t = 1.1RC Inverter Oscillator f OSC depends on the number of inverters (must be odd). A Calculation • For the circuit of the previous slide, find the frequency range if each inverter has a delay of 10 ns  1 ns. Period T = delay  2  # of inverters, so T LONG = 11 ns  2  3 = 66 ns and T SHORT = 9 ns  2  3 = 54 ns So f LO = 1 / 66 ns  15.2 MHz and f HI = 1 / 54 ns  18.5 MHz [...]... at a rate of V / t = I / C So t = (C / I) V • The period T = (0.1 F / 10 A)  10 Volts = 0.1 sec • So f = 1 / T = 10 Hertz Troubleshooting • As always, check all DC voltages • Typically, these oscillators either work or they do not; they do not tend to drift • Frequencies are not precise (except for crystal stabilized) so oscilloscope measurements are OK • Though not often used, if an aluminum . CHAPTER 14 Nonsinusoidal Oscillators Objectives Describe and Analyze: • Operation of the 555 IC • Inverter oscillators • Schmitt oscillators • Wave-shaping • Sawtooth oscillators. vacuum tube days when they actually used electromechanical vibrators in circuits. Square-Wave Oscillators Square wave from a “free-running” 555 circuit. The “Internals” of a 555. square-wave has a 50% duty cycle. But unless the duty cycle is low, astables are called square-wave oscillators even if it’s not 50%. • A one-shot produces a fixed-width output pulse every time

Ngày đăng: 08/08/2014, 16:22

w