1. fold side in to center unfold. 1/3 1/3 1/3 2. fold up aprox. 1/3 up. 3. Fold up and leave up. 4. Fold model in half. 5. fold both sides back on the crease lines. 6. Fold all layers up to bottom of the top layer then unfold to step 4. 1 2 3 7. Fold up on the crease made in previos fold. in order. 8. fold down the tip of the top. then fold on the diagonal creases to make a triangular base. 9. use the pockets created by folds in top and bottom to lock the model together, and you have a Vase, just right for 1 kawasaki rose. (the Rose stem goes into on of the inside flaps on the bottom.) Finished Note, to make the vase sturdier you can glue the over lapping sides together. Simple Vase for Kawasaki Rose Perry Bailey 1998 . for 1 kawasaki rose. (the Rose stem goes into on of the inside flaps on the bottom.) Finished Note, to make the vase sturdier you can glue the over lapping sides together. Simple Vase for Kawasaki