Tài liệu hướng dẫn sửa chữa hệ thống khóa cửa trên xe Hilux 2015 2018 manual door lock he thong khoa cua . Cung cấp các thông tin cần thiết cho Kỹ thuật viên tiến hành chẩn đoán, sửa chữa nhanh chóng, chính xác
12/3/17, 12(13 am DOOR LOCK DOOR CONTROL BATTERY COMPONENTS ILLUSTRATION *1 DOOR CONTROL BATTERY - - N*m (kgf*cm, ft.*lbf): Specified torque - - https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000M25A.html Page of 12/3/17, 12(13 am DOOR LOCK DOOR CONTROL BATTERY INSPECTION PROCEDURE 8598A 1.INSPECT DOOR CONTROL BATTERY a Inspect the door control battery i Measure the resistance according to the value(s) in the table below Standard Resistance: *a Tester Connection 5(BATB) 11(DRLY) Condition Specified Condition Voltage is not applied between terminals (IG) and (ACTG) Below Ω Battery positive (+) - (IG) Battery negative (-) - (ACTG) 10 kΩ or higher Component without harness connected (Door Control Battery) If the result is not as specified, replace the door control battery ii Measure the voltage according to the value(s) in the table below Tester Specified Condition Connection Condition 11(DRLY) Battery negative (-) (EDOR) Battery negative (-) Battery positive (+) - (IG) Battery negative (-) - (ACTG) 11 to 14 V If the result is not as specified, replace the door control battery https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000M25B.html Page of Service Information - Toyota Service Information 12/3/17, 12(14 am HILUX > GGN12#,GGN13#,GUN11#,GUN12#,GUN13#,KUN11#,KUN12#,KUN13#,LAN12#,TGN11#,TGN12#,TGN13# > 2016.01 Keyword Help Search EWD YOKOGUSHI Repair Manual Results NCF BRM RM3250E WIRELESS DOOR LOCK BUZZER(for RHD) COMPONENTS REMOVAL INSTALLATION DOOR LOCK DOOR CONTROL BATTERY INSTALLATION CAUTION / NOTICE / HINT DOOR CONTROL RELAY ON-VEHICLE INSPECTION HINT: DOOR CONTROL RELAY(w/ Double Locking System) · COMPONENTS · REMOVAL Use the same procedure for RHD and LHD vehicles The procedures listed below are for LHD vehicles INSTALLATION DOOR CONTROL BATTERY PROCEDURE COMPONENTS REMOVAL 1.INSTALL DOOR CONTROL BATTERY INSPECTION 8598A INSTALLATION THEFT DETERRENT / KEYLESS ENTRY a LIGHTING (INT) METER / GAUGE / DISPLAY MIRROR (INT) SUPPLEMENTAL RESTRAINT SYSTEMS © 2012 TOYOTA MOTOR CORPORATION All Rights Reserved SEAT SEAT BELT https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/pgm/service.html Page of 12/3/17, 12(13 am DOOR LOCK DOOR CONTROL BATTERY REMOVAL CAUTION / NOTICE / HINT HINT: · · Use the same procedure for RHD and LHD vehicles The procedures listed below are for LHD vehicles PROCEDURE PRECAUTION (w/ Airbag System) CAUTION: Be sure to read Precaution thoroughly before servicing for Type A: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type A)>PRECAUTION for Type B: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Airbag System) CAUTION: · · Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system If the airbag deploys for any reason, it may cause a serious accident NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION 3.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000M258.html 55302A Page of 12/3/17, 12(13 am Click hereVehicle Interior>INTERIOR PANELS / TRIM>UPPER INSTRUMENT PANEL>REMOVAL 55303B 4.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY Click hereVehicle Interior>INTERIOR PANELS / TRIM>LOWER INSTRUMENT PANEL>REMOVAL 8598A 5.REMOVE DOOR CONTROL BATTERY a Remove the bolts b Detach the hook and remove the door control battery c Disconnect the connector Bolt Connector https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000M258.html Page of 12/3/17, 12(10 am DOOR LOCK DOOR CONTROL RECEIVER COMPONENTS ILLUSTRATION *A w/ Entry and Start System *B w/o Entry and Start System *1 DOOR CONTROL RECEIVER *2 SMART DOOR CONTROL RECEIVER ASSEMBLY https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000M251.html Page of 12/3/17, 12(11 am DOOR LOCK DOOR CONTROL RECEIVER INSTALLATION CAUTION / NOTICE / HINT HINT: · · Use the same procedure for RHD and LHD vehicles The procedures listed below are for LHD vehicles PROCEDURE 1.INSTALL DOOR CONTROL RECEIVER (w/o Entry and Start System) a Connect the connector b Attach the guide to install the door control receiver with the nut 89741 Nut Connector 2.INSTALL SMART DOOR CONTROL RECEIVER ASSEMBLY (w/ Entry and Start System) a Connect the connector b Attach the guide to install the smart door control receiver assembly with the nut https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000M252.html 89740A Page of 12/3/17, 12(11 am Nut Connector 3.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY 55302A Click hereVehicle Interior>INTERIOR PANELS / TRIM>UPPER INSTRUMENT PANEL>INSTALLATION KEY REGISTRATION (w/o Entry and Start System) Click hereVehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Entry and Start System)>REGISTRATION 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Airbag System) NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION 6.CHECK SRS WARNING LIGHT (w/ Airbag System) for Type A: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type A)>DIAGNOSIS SYSTEM for Type B: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>DIAGNOSIS SYSTEM https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000M252.html Page of 12/3/17, 12(11 am DOOR LOCK DOOR CONTROL RECEIVER REMOVAL CAUTION / NOTICE / HINT HINT: · · Use the same procedure for RHD and LHD vehicles The procedures listed below are for LHD vehicles PROCEDURE PRECAUTION (w/ Airbag System) CAUTION: Be sure to read Precaution thoroughly before servicing for Type A: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type A)>PRECAUTION for Type B: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Airbag System) CAUTION: · · Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system If the airbag deploys for any reason, it may cause a serious accident NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION 3.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000M253.html 55302A Page of 12/3/17, 12(11 am Click hereVehicle Interior>INTERIOR PANELS / TRIM>UPPER INSTRUMENT PANEL>REMOVAL 4.REMOVE DOOR CONTROL RECEIVER (w/o Entry and Start System) a Remove the nut b Detach the guide and remove the door control receiver c Disconnect the connector 89741 Nut Connector 5.REMOVE SMART DOOR CONTROL RECEIVER ASSEMBLY (w/ Entry and Start System) a Remove the nut b Detach the guide and remove the smart door control receiver assembly c Disconnect the connector 89740A Nut Connector https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000M253.html Page of