IEC 62026 3 2014/COR1 2015 – 1 – IEC 2015 INTERNATIONAL ELECTROTECHNICAL COMMISSION COMMISSION ÉLECTROTECHNIQUE INTERNATIONALE IEC 62026 3 Edition 3 0 2014 08 Low voltage switchgear and controlgear[.]
IEC 62026-3:2014/COR1:2015 IEC 2015 –1– INTERNATIONAL ELECTROTECHNICAL COMMISSION COMMISSION ÉLECTROTECHNIQUE INTERNATIONALE IEC 62026-3 Edition 3.0 IEC 62026-3 2014-08 Édition 3.0 2014-08 Low-voltage switchgear and controlgear – Controller-device interfaces (CDIs) – Appareillage basse tension – Interfaces appareil de commande-appareil (CDI) – Part 3: DeviceNet Partie 3: DeviceNet CORRIGENDUM 5.2.4.4.2 Communication message protocols faulted 5.2.4.4.2 Protocoles de messages de défaut de communication Delete, in the second existing paragraph, "Error! Reference source not found." Supprimer, dans le deuxième alinéa existant, "Error! Reference source not found." 5.2.4.5.3 Identify response message – Multicast protocol Delete, in the first existing paragraph, "Error! Reference source not found." 5.2.7 Duplicate protocol MAC ID detection IEC 62026-3:2014-08/COR1:2015-03(en-fr) Replace "Error! Reference found." by the following: source not IDENTIFIER BITS 10 MAC ID Destination MAC ID Message 5.2.4.5.3 "identification" – multidestinataire de Supprimer, dans le premier alinéa existant, "Error! Reference source not found." 5.2.7 Protocole de détection duplication d’adresse MAC ID La correction seulement concerne MESSAGE ID MEANING Group message ID Group messages 1 réponse Protocole Duplicate MAC ID check message IEC Figure 35 – Duplicate MAC ID check CAN identifier field de l'anglais –2– 5.5.3.3.2 Request parameters service data field Delete, in the second existing paragraph, "Error! Reference source not found." IEC 62026-3:2014/COR1:2015 IEC 2015 5.5.3.3.2 Paramètres du champ données de service d’une requête La correction seulement concerne des l'anglais Figure 46 – Predefined master/slave explicit messaging connection state transition diagram Replace the existing figure by the following new figure (without modifying its title): Non-existent Release/delete Child instance deleted or transitions to timed out and no other child instances are in the established state Release/delete Allocate Inactivity/watchdog time-out and watchdog_time-out_action = deferred delete and at least one child instance is in the established state Deferred Inactivity/watchdog time-out watchdog_time-out_action = auto delete or this attribute to deferred delete and no child instances are in the established state Established Receive data/reset Get_attribute Set_attribute Reset IEC Figure 46 – Diagramme de transition d’états pour la connexion de messagerie explicite mtre/esclave prédéfinie Remplacer la figure existante par la nouvelle figure suivante (sans modifier le tableau de traduction ni son titre): Non-existent Release/delete Child instance deleted or transitions to timed out and no other child instances are in the established state Release/delete Allocate Inactivity/watchdog time-out and watchdog_time-out_action = deferred delete and at least one child instance is in the established state Deferred Inactivity/watchdog time-out watchdog_time-out_action = auto delete or this attribute to deferred delete and no child instances are in the established state Established Receive data/reset Get_attribute Set_attribute Reset 7.1.2.2 Thin cable 7.1.2.2 Câble fin Replace, in the existing first paragraph, "1,5 A" by "3 A" Remplacer, dans le premier existant, "1,5 A" par "3 A" IEC alinéa