Microsoft Word C043553e doc ICS 83 080 01 Ref No ISO 16012 2004/Cor 1 2005(E) © ISO 2005 – All rights reserved Published in Switzerland INTERNATIONAL STANDARD ISO 16012 2004 TECHNICAL CORRIGENDUM 1 Pu[.]
INTERNATIONAL STANDARD ISO 16012:2004 TECHNICAL CORRIGENDUM Published 2005-12-01 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION • МЕЖДУНАРОДНАЯ ОРГАНИЗАЦИЯ ПО СТАНДАРТИЗАЦИИ • ORGANISATION INTERNATIONALE DE NORMALISATION Plastics — Determination of linear dimensions of test specimens TECHNICAL CORRIGENDUM Plastiques — Détermination des dimensions linéaires des éprouvettes RECTIFICATIF TECHNIQUE Technical Corrigendum to ISO 16012:2004 was prepared by Technical Committee ISO/TC 61, Plastics, Subcommittee SC 2, Mechanical properties Page 4, Subclause 5.7 `,,```,,,,````-`-`,,`,,`,`,,` - In the second line of the second paragraph, replace “7 µm to 10 µm” by “7 mm to 10 mm” ICS 83.080.01 Ref No ISO 16012:2004/Cor.1:2005(E) © ISO 2005 – All rights reserved Published in Switzerland Copyright International Organization for Standardization Provided by IHS under license with ISO No reproduction or networking permitted without license from IHS Not for Resale