Microsoft Word C051928e doc ICS 21 060 01; 25 220 40 Ref No ISO 10684 2004/Cor 1 2008(E) © ISO 2008 – All rights reserved Published in Switzerland INTERNATIONAL STANDARD ISO 10684 2004 TECHNICAL CORRI[.]
INTERNATIONAL STANDARD ISO 10684:2004 TECHNICAL CORRIGENDUM Published 2008-07-15 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION • МЕЖДУНАРОДНАЯ ОРГАНИЗАЦИЯ ПО СТАНДАРТИЗАЦИИ • ORGANISATION INTERNATIONALE DE NORMALISATION Fasteners — Hot dip galvanized coatings TECHNICAL CORRIGENDUM Éléments de fixation — Revêtements de galvanisation chaud RECTIFICATIF TECHNIQUE Technical Corrigendum to ISO 10684:2004 was prepared by Technical Committee ISO/TC 2, Fasteners, Subcommittee SC 1, Mechanical properties of fasteners Page 6, Table 1, column 12, bottom row, line Delete “398”, insert “298” A revised version of Table appears overleaf ICS 21.060.01; 25.220.40 © ISO 2008 – All rights reserved Published in Switzerland Ref No ISO 10684:2004/Cor.1:2008(E) a d mm 10 12 16 (14) 20 (18,22) 24 (27) 30 (33) 36 (39) 42 (45) 48 (52) 56 (60) 64 P mm 1,25 1,5 1,75 2,5 3,5 4,5 5,5 0 0 0 0 0 + 310 + 365 + 420 + 530 + 640 + 750 + 860 + 970 + 080 + 190 + 300 + 330 + 335 + 340 + 350 + 360 + 370 + 380 + 390 + 400 + 410 + 420 0 + 255a + 325a − 80 − 75 − 71 − 63 − 60 − 53 − 48 − 42 − 38 − 34 − 32 420 410 400 390 380 370 360 350 340 335 330 325 − 28 105 103 100 98 95 93 90 88 85 84 83 81 µm Maximum coating thickness AZ/h 500 485 471 453 440 423 408 392 378 369 362 353 µm Minimum clearance 125 121 118 113 110 106 102 98 95 92 91 88 µm Maximum coating thickness AZ/g 300 190 080 970 860 750 640 530 420 365 310 255 µm Minimum clearance 325 298 270 243 215 188 160 133 105 91 78 64 µm Maximum coating thickness AX/h 380 265 151 033 920 803 688 572 458 399 342 283 µm Minimum clearance 345 316 288 258 230 201 172 143 115 100 86 71 µm Maximum coating thickness AX/g Minimum clearance and maximum coating thickness for thread combinations (for information) Minimum clearance µm g µm External thread µm h µm AX µm AZ Internal thread Fundamental deviation The fundamental deviations for AZ and AX are calculated according to the formulae given in ISO 965-5 on the basis of the thread dimensions specified in Annex B Nominal thread diameter Pitch Table — Fundamental deviations and upper limits of coating thicknesses for assemblies with nuts tapped oversize ISO 10684:2004/Cor.1:2008(E) © ISO 2008 – All rights reserved