Microsoft Word C056070e doc ICS 53 100 Ref No ISO 12117 2 2008/Cor 1 2010(E) © ISO 2010 – All rights reserved Published in Switzerland INTERNATIONAL STANDARD ISO 12117 2 2008 TECHNICAL CORRIGENDUM 1 P[.]
INTERNATIONAL STANDARD ISO 12117-2:2008 TECHNICAL CORRIGENDUM Published 2010-04-01 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION • МЕЖДУНАРОДНАЯ ОРГАНИЗАЦИЯ ПО СТАНДАРТИЗАЦИИ • ORGANISATION INTERNATIONALE DE NORMALISATION Earth-moving machinery — Laboratory tests and performance requirements for protective structures of excavators — Part 2: Roll-over protective structures (ROPS) for excavators of over t TECHNICAL CORRIGENDUM Engins de terrassement — Essais de laboratoire et exigences de performance des structures de protection des pelles — Partie 2: Structures de protection au retournement (ROPS) pour pelles de terrassement de plus de t RECTIFICATIF TECHNIQUE Technical Corrigendum to International Standard ISO 12177-2:2008 was prepared by Technical Committee ISO/TC 127, Earth-moving machinery, Subcommittee SC 2, Safety, ergonomics and general requirements Page 14, 6.2.1 Replace the second paragraph of the subclause with the following: The LDD shall not contact a ROPS structural member beyond H Page 20, Table Add a second Note to the table (the first then becomes “NOTE 1”): NOTE The formulas given in this table are for information only ICS 53.100 © ISO 2010 – All rights reserved Published in Switzerland Ref No ISO 12117-2:2008/Cor.1:2010(E)