20 dirQuest Summer 2004
20 dirQuest Summer 2004
Understanding Guideline Equipment
A
ccident Analysis is a central component of cave training
and all students learn how it applies to both trained and
untrained cave divers. Sheck Exley, in his 1979 booklet
“Blue Print for Survival,” first recounts and then assesses errors
made by divers penetrating overhead environments. In one of
these accounts, he discusses a group of divers who ventured only
a short distance into a cave without a guideline, and never found
the exit again.
Several months ago, three trained cave divers entered Cenote
Mayan Blue, an opening into the Naranjal Cave System, in
Quintana Roo, Mexico. Their dive plan consisted of entering
Introduction toGuideline
Procedures
Part 1:Equipment
By Fred Devos, Chris Le Maillot and Daniel Riordan
tunnel “B,” jumping to tunnel “E” and exiting tunnel “A.”
Though this dive requires the installation of two jump spools and
two primary or penetration reels, this particular team decided they
would not use any reels or spools. They consciously chose not
to maintain a continuous guidelineto the open water. Although
these divers successfully completed their dive, if an emergency
would have occurred, the outcome might have been different.
Many would find it hard to believe that “trained” cave divers
would venture into an overhead environment violating one of the
most basic rules in cave diving. Individuals who train for diving
in overhead environments are all taught the value of maintaining
S. Tittle
20 dirQuest Summer 2004
20 dirQuest Summer 2004
dirQuest Summer 2004 21
a continuous guidelineto the open water; yet surprisingly enough
some choose to ignore this vital safeguard. Why?
In most cases, continuous guidelines are not installed because
of diver overconfidence and/or lack of skill. As cave instructors
and guides, we often see divers struggling with guideline related
skills. Such a lack of skill is often tied to diver training that is
not only cursory, but also lax. A clear pattern exists between the
Mayan Blue divers and divers who choose a fast, and sometimes
neglectful, education.
To improve guideline use, nothing can replace proper training,
practice and the right choice of equipment. It is only through
education and then repetition that divers will be able to cultivate
a skill-set that will become second nature to them, and one that
will help them become both confident and proficient.
A properly installed, continuous guidelineto the open water
is crucial in assuring efficient navigation in a cave and to the
open water, especially when teams are confronted with limited
visibility created by light failures, restrictions, percolation,
tannic acid, hydrogen sulfide, surge or generally poor water
conditions.
What follows is the first of several articles focusing on the
equipment, methods, and simple navigation of guidelines. We
hope to provide divers with a broader view and clearer perspective
of this insufficiently emphasized aspect of diving.
EQUIPMENT
To understand guidelines, one must first become familiar with
the equipment involved.
THE GUIDELINE
Material
Nylon is the material of choice for guidelines. If it were to
come loose, a nylon line will sink in the water. A line lying
on the floor of the cave is much easier to follow than a line
floating on the ceiling. For this reason, polypropylene is not an
acceptable choice for a guideline. Nylon also resists the natural
elements well and can be left in a cave for many years before
any deterioration is seen. Cotton line, on the other hand, will
quickly rot and break apart.
Weave
There are two general types of nylon line weave: twisted and
braided. Although twisted line has a higher tensile strength,
braided line is more abrasion resistant. It is therefore imperative
that penetration reels or spools, with lines that are repeatedly
being installed and removed from the cave, use braided line.
For exploration in no-flow caves, twisted line has been used
successfully. Kermantle line is a combination of the two weaves
with a core of twisted line and a sheath of braided nylon. This
has traditionally been used in mainline passages seeing heavy diver
traffic, or training areas where lines could be put through a lot
of use or abuse.
Thickness
Line thickness is generally measured in gauge. The number of
threads a line has represents its gauge, therefore the thicker the
line, the bigger the number it will have. For most applications,
a 24-gauge, braided line will offer sufficient tensile strength and
abrasion resistance. However,
if abrasion is of great concern,
some divers may prefer to use
a number 36-gauge. At times,
when abrasion resistance is
less of a concern, explorers
will install a high-tensile,
thinner, 18-gauge, twisted
line. However, beware of
thinner lines, as they may not
offer sufficient strength, and
of thicker lines, which require
needlessly large reels or spools.
An additional concern with
thick guidelines is that they
can present a false sense of
security and can coax divers
farther from the line. This
can lead to losing the line as
S. Tittle
S. Tittle
F. Devos
Types of guidelines
F. Devos
Well engineered reel
Cave divers should always maintain a continuous guideline
to the open water
Diver reeling out
22 dirQuest Summer 2004
22 dirQuest Summer 2004
well as increasing the swath of damage caused by cave divers as
they stray from the line.
Color
White is the most reflective color and is the leading choice for
guidelines. At times, mainline passages, or commonly dived
routes, can be distinguished by the use of other reflective colors.
Some divers will also use a peculiar color for the line on their
safety spool, so that during an emergency search for a missing
diver or lost line, they know if they accidentally loop back to their
own line. Keep in mind though, that color is only effective with
good visibility and should never be used as the sole reference.
Knots
Explorers will often pre-tie knots on their line so they have
a means to roughly measure and survey the passage they are
exploring. These knots are usually at 10-ft intervals. The same
procedure can be employed with safety spools, but with knots
tied at shorter intervals. During an emergency search, this can
allow a diver to know the distance they have traveled and to
distinguish their own line even during zero visibility.
REELS AND SPOOLS
Proper training that allows plenty of time for practice is essential
in the understanding and handling of vital equipment such as
a reel… REEL… did we say REEL? For many, the word reel
conjures nightmarish memories of training. A reel in hand is
essential when otherwise good trim and perfect buoyancy control
goes out the window.
Reel Components
Again, understanding the equipment is the first step in becoming
proficient in its use. A reel consists of several parts.
• Frame
All reels have a frame, with an axle where the spool is secured,
and a line guide. On the frame you can find the handle, which
is ideally mounted on the side rather than the top of the frame.
This provides for better streamlining and conforms to the use
of a Goodman handle.
• Spool
A spool is the hub where the guideline is wound. The size of
the spool defines the amount of line able to be stored. Plexiglass
spools are fragile and can easily break, while metal spools can
be bent and hinder rotation on the axle. Metal spools will also
sink faster if accidentally dropped. Delrin, on the other hand, is
lighter and remains rigid, yet is virtually unbreakable.
• Winding Knob
The knob to reel in the line is found on the outside part of the
spool.
• Lock Down Screw
This screw can be located on the side, front, or rear of the frame.
This screw is used to hold the spool in place when the reel is
not in use, thereby preventing line from uncoiling. It should
not be used to adjust line
tension. A screw mounted
on the opposite side of the
line guide is preferred, as it
prevents line entanglement.
The lockdown screw should
not be made of nylon with
threads that can easily be
stripped.
• Attachment
Attachment of the reel can
either be in the form of a bolt
snap or a double-ended bolt
snap. The use of a double-
ender is preferred as it allows
a diver to remove it while the
reel is in use, thus limiting the
places where the line can get
trapped. If a double-ended
bolt snap is used, make sure
it is properly secured to the
frame to avoid it being accidentally opened. A single clip, using
a metal-to-metal attachment to the reel should be avoided as it
offers no alternative if the action of the clip fails to open. Line
catchers such as suicide clips or boat snaps, carabineers and other
“gate action” attachments are not appropriate.
• End Loop
At the start of the line there
should be a loop large enough
to allow the entire reel or
finger spool to pass through.
A small loop should be added
at the end of the main loop
to make it easier to retrieve
the line. With reels, a small
marble attached to the end
can prevent the line from
spinning back inside the
spool.
Types of Reels
• Enclosed Reels
This specific type of reel has
a plastic cover over the spool
section of the reel, covering
the line. The assumption here
is that if the line is enclosed it
will not get tangled. To some
degree this is true, however unfortunately, if the line does become
jammed, there is no way to fix it, since the line is inaccessible.
• Open Reel
This type of reel is preferred, as it allows for easy access to the
line on the spool. Ideally, a reel will have the spool engineered
close to the frame in order to prevent the guideline from spilling
out and ultimately jamming it.
Right way to clip reel
F. Devos
F. Devos
Wrong way to clip reel
Enclosed reel
F. Devos
End loop
F. Devos
22 dirQuest Summer 2004
22 dirQuest Summer 2004
dirQuest Summer 2004 23
• Finger Spool
A spool has no moving parts,
and is without a frame; as a
result, there is no way to jam
a spool. There are no knobs
or other parts to break off or
get entangled and it is low
volume for easy stowing.
SELECTION OF REELS
It is always best to evaluate the amount of line needed when
choosing what size reel or spool to use. Avoid using oversized
reels, which are cumbersome and difficult both to manipulate
and stow. Spools have the advantage of being simple, easy to
deploy, and easy to both manipulate and stow. However, over
long distances, winding the line back onto a spool can be tedious
work. This is when a reel is
more appropriate.
Reels and spools should
be personalized with the
diver’s name or initials.
Engraving the frame of a
reel or the faceplate of a
spool can ensure the reel
is recognizable by touch
during a blind exit.
Reels and Spools can be
defined by their purpose.
• Exploration Reels
An Exploration reel can
accommodate as much as
2,000 feet of line. This
is a specialized piece of
equipment used only during
extended exploration dives,
as the bulkiness of the reel
is impractical for day-to-
day use.
• Penetration Reels
A Penetration, Primary
or Lead reel, is used for
connecting a point of direct
access to the surface with the
beginning of a permanent
cave line. A permanent
cave line may be positioned
a few hundred feet into an
overhead environment and
may require a substantial amount of line to reach it. A typical
penetration reel will have anywhere between 300 feet to 500 feet
of line. Only one penetration reel is necessary per team.
Finger spools
F. Devos
Reel components
F. Devos
Gate action clips
F. Devos
Metal to metal attachment
F. Devos
• Jump and Gap Spools
Jump and Gap spools are spools that are utilized to create a
connection between two permanent lines. They commonly
have 50 feet to 100 feet of line. This is too little line to use in
emergencies and therefore cannot be used as a safety.
• Safety Spools
A Safety spool is the one piece of equipment that every diver needs
to carry with them. It is used only in the event of emergencies,
which could include: lost line, broken line, line entanglement or
lost diver. One hundred and fifty feet of line is recommended and
it is critical that a spool, and not a reel, be used for this purpose.
A reel can jam and be rendered unusable, whereas the simplicity of
a spool ensures its readiness at all times. Your safety spool should
be secured in your bellows pocket, tucked away yet ready to be
deployed in an emergency.
. opening into the Naranjal Cave System, in
Quintana Roo, Mexico. Their dive plan consisted of entering
Introduction to Guideline
Procedures
Part 1: Equipment. emphasized aspect of diving.
EQUIPMENT
To understand guidelines, one must first become familiar with
the equipment involved.
THE GUIDELINE
Material
Nylon is