211-04-1 Steering Column 211-04-1 SECTION 211-04 Steering Column VEHICLE APPLICATION: 2011.50 Ranger CONTENTS PAGE REMOVAL AND INSTALLATION Steering Wheel (13 524 0) Steering Column (13 542 0) 211-04-2 211-04-3 211-04-2 Steering Column 211-04-2 REMOVAL AND INSTALLATION Steering Wheel(13 524 0) General Equipment Adhesive Tape Removal CAUTION: Make sure that the steering wheel lock is engaged Refer to: Driver Air Bag Module (501-20 Supplemental Restraint System, Removal and Installation) Torque: 40 Nm NOTE: Removal steps in this procedure may contain installation details CAUTION: Make sure that the clockspring rotor does not rotate General Equipment: Adhesive Tape Installation To install, reverse the removal procedure 2011.50 Ranger G1269921en 211-04-3 Steering Column 211-04-3 REMOVAL AND INSTALLATION Steering Column(13 542 0) General Equipment Ford Diagnostic Equipment Removal NOTE: This step is only necessary when installing a new component Torque: 25 Nm NOTE: Removal steps in this procedure may contain installation details Refer to: Steering System Health and Safety Precautions (100-00 General Information, Description and Operation) Refer to: Ignition Switch (211-05 Steering Column Switches, Removal and Installation) Refer to: Steering Wheel (211-04 Steering Column, Removal and Installation) Torque: Nm 2011.50 Ranger G1269924en 211-04-4 Steering Column 211-04-4 REMOVAL AND INSTALLATION Vehicles with driver lower air bag Refer to: Driver Lower Air Bag Module (501-20 Supplemental Restraint System, Removal and Installation) Vehicles without driver lower air bag 2011.50 Ranger G1269924en 211-04-5 Steering Column 211-04-5 REMOVAL AND INSTALLATION 10 Torque: 2.5 Nm 12 Refer to: Lifting (100-02 Jacking and Lifting, Description and Operation) 13 If necessary Torque: 23 Nm Torque: 23 Nm All vehicles 11 NOTE: Make sure that the nuts are not tightened with tilt lever released in position during installation Torque: 22 Nm Torque: 15 Nm 14 NOTE: Make sure that the plastic caps are removed 2011.50 Ranger G1269924en 211-04-6 Steering Column 211-04-6 REMOVAL AND INSTALLATION Torque: Nm Refer to: Clockspring Adjustment (501-20 Supplemental Restraint System, General Procedures) Configure the steering column module General Equipment: Ford Diagnostic Equipment Installation To install, reverse the removal procedure CAUTION: Take extra care not to shorten the shaft NOTE: Do not shorten the shaft until the groove is covered Replace it, if the shaft has been shortened 2011.50 Ranger G1269924en