GE Grid Solutions MiCOM P40 Agile P342, P343, P344, P345, P346, P348 P391 Technical Manual Generator Protection Relay Hardware version P (P342), M (P3434568), A (P391) Software version 38 (P342. Xác định hãm phần trăm cho dòng hãm dưới Lower Break (BREAK 1). Cài đặt này xác định mức độ nhạy của relay với những sự cố ở bên trong dòng thấp. Cài đặt này phải đủ lớn để bao trùm dòng so lệch giả tạo ra do sự bảo hòa CT khi vận hành ở chế độ tuyến tính khi ở trong chế độ man tải và sự cố bên ngoài.
GE Grid Solutions MiCOM P40 Agile P342, P343, P344, P345, P346, P348 & P391 Technical Manual Generator Protection Relay Hardware version: P (P342), M (P343/4/5/6/8), A (P391) Software version: 38 (P342/3/4/5/6/8), 37 (P348) Publication reference: P34x-EN-M-Ia8 CONTENTS Safety Section P34x/EN SS/Ia8 SS Update Documentation P34x/EN AD/xxx N/A Section Introduction P34x/EN IT/Ia8 IT Section Technical Data P34x/EN TD/Ia8 TD Section Getting Started P34x/EN GS/Ia8 GS Section Settings P34x/EN ST/Ia8 ST Section Operation P34x/EN OP/Ia8 OP Section Application Notes P34x/EN AP/Ia8 AP Section Programmable Logic P34x/EN PL/Ia8 PL Section Measurements and Recording P34x/EN MR/Ia8 MR Section Firmware Design P34x/EN FD/Ia8 FD Section 10 Commissioning P34x/EN CM/Ia8 CM Section 11 Maintenance P34x/EN MT/Ia8 MT Section 12 Troubleshooting P34x/EN TS/Ia8 TS Section 13 SCADA Communications P34x/EN SC/Ia8 SC Section 14 Symbols and Glossary P34x/EN SG/Ia8 SG Section 15 Cybersecurity P34x/EN CS/Ia8 SG CS Section 16 Installation P34x/EN IN/Ia8 IN Section 17 Firmware and Service Manual Version History P34x/EN VH/Ia8 VH Safety Section P34x/EN SS/Ia8 SS SAFETY SECTION P34x/EN SS/Ia8 SS Safety Section Safety Section P34x/EN SS/Ia8 (SS) - CONTENTS OVERVIEW HEALTH AND SAFETY SYMBOLS INSTALLING, COMMISSIONING AND SERVICING 4.1 Lifting Hazards 4.2 Electrical Hazards DECOMMISSIONING AND DISPOSAL 12 REGULATORY COMPLIANCE 13 6.1 EMC Compliance: 2014/30/EU 13 6.2 LVD Compliance: 2014/35/EU 13 6.3 R&TTE Compliance: 2014/53/EU 13 6.4 UL/CUL Compliance 13 SS P34x/EN SS/Ia8 (SS) - SS Safety Section Safety Section P34x/EN SS/Ia8 (SS) - OVERVIEW This chapter provides information about the safe handling of the equipment The equipment must be properly installed and handled in order to maintain it in a safe condition and to keep personnel safe at all times You must be familiar with information contained in this chapter before unpacking, installing, commissioning, or servicing the equipment SS P34x/EN SS/Ia8 Safety Section (SS) - HEALTH AND SAFETY Personnel associated with the equipment must be familiar with the contents of this Safety Information SS When electrical equipment is in operation, dangerous voltages are present in certain parts of the equipment Improper use of the equipment and failure to observe warning notices will endanger personnel Only qualified personnel may work on or operate the equipment Qualified personnel are individuals who are: • familiar with the installation, commissioning, and operation of the equipment and the system to which it is being connected • familiar with accepted safety engineering practises and are authorised to energise and de-energise equipment in the correct manner • trained in the care and use of safety apparatus in accordance with safety engineering practises • trained in emergency procedures (first aid) The documentation provides instructions for installing, commissioning and operating the equipment It cannot, however cover all conceivable circumstances In the event of questions or problems, not take any action without proper authorisation Please contact your local sales office and request the necessary information ... Settings P34x/ EN ST/Ia8 ST Section Operation P34x/ EN OP/Ia8 OP Section Application Notes P34x/ EN AP/Ia8 AP Section Programmable Logic P34x/ EN PL/Ia8 PL Section Measurements and Recording P34x/ EN... Design P34x/ EN FD/Ia8 FD Section 10 Commissioning P34x/ EN CM/Ia8 CM Section 11 Maintenance P34x/ EN MT/Ia8 MT Section 12 Troubleshooting P34x/ EN TS/Ia8 TS Section 13 SCADA Communications P34x/ EN... avoid potentially lethal voltages Data communication cables with accessible screens and/or screen conductors, (including optical fibre cables with metallic elements), may create an electric shock