Intermediate Trophy Bowl Created by Marcia Joy Miller Trophy Bowl can be used as a candy dish or a presentation piece The model is a modular design made from three units You can create the modules during coffee breaks and connect them at lunchtime PAPER: Create the model from the three sheets of designated folding paper included in the back of the book starting on page 151 You can also, if you are planning to use Trophy Bowl as a candy dish, make it from three 8½-inch squares of medium weight bond paper in different colors When the model is created from shiny paper-backed foil, the colors of its faces reflect and mix with each other giving a pretty effect To make the model from foil, you will need three 6-inch squares of shiny medium weight paper-backed foil in different colors Experienced folders can also create the model from other types of paper BASIC TECHNIQUES: See Chapter for the Waterbomb Base exercise Start with a completed Waterbomb Base (If you are using the included folding paper, begin the Waterbomb Base with the solid-color side facing you.) First, mountain fold the left front flap as indicated Next, valley fold the right front flap as shown First, mountain fold and then unfold the bottom of the right front flap as shown Next, mountain fold the bottom of the left front flap as indicated Stand the two front flaps at a right angle to the rest of the model Make two more units from the remaining squares Position two units as shown Insert the large top flap of the bottom unit into the large right flap of the top unit Notice that on the right side of the upright flap of the top unit, there are two pockets You will be using the rightmost of these pockets Tuck the indicated tab of the bottom unit inside this pocket Slide both units together as far as possible Ori for Busy People_INT 00-96 27jul.indd 64 7/27/11 3:57:00 PM