COFFEEͳBREAK ORIGAMI 23 Turn the model over so Pick up the right edge Bring the mountain fold Pick up the left edge that it looks like the position shown in the next step releasing the flap underneath to the vertical crease and press the new fold flat releasing the flap underneath 12 Turn the model over so 13 Make a little valley fold that it looks like the position shown in the next step at the top right corner Fold the front flap (it will be the beak) to the right 10 Bring the mountain fold to the vertical crease and press the new fold flat 11 Fold the bottom corner up to the indicated point (Note: the point that is referred to is located approximately halfway between the horizontal crease and the top corners of the front flaps.) 16 Cut a rectangle from 14 Make a little valley fold at the top left corner Stand the flap (that will be the beak) up at a right angle Ori for Busy People_INT 00-96 27jul.indd 23 15 Pull down the bottom back flap to an angle that is a little less than a right angle card stock or medium weight bond paper that you will use as a place card and then insert the card under the flap of the model Your Placard Bird is ready for company Barry B Miller is interested in science and protecting the enviroment He likes antique microscopes, exotic houseplants, and mineral collecting 7/27/11 3:54:44 PM