Manual installation eCut for Corel Draw Copy macros file :Website: https://www.facebook.com/tiutproyoutube - https://www.youtube.com/channel/UCc-2 FZxjOIy59YglHE0dMQAw?sub_confirmation=1 - https://tiutproyoutube.blogspot.com - https://zalo.me/g/fginbu149 - https://twitter.com/tiutpro 5- https://facebook.com/tiutproyoutube If installer found your CorelDRAW version, skip this stage and go to Importing eCut toolbar in CorelDRAW But if your CorelDRAW version is not checked, then you have to copy GMS file manually GMS (macros) file for launching eCut is located int this folder:C:\eCut\eCut6\CorelDRAW GMS CorelDRAW setup folder you have to find out from your system administrator, and after that copy eCut GMS file to this folder:{CorelDRAW}\Draw\GMS Importing eCut toolbar in CorelDRAW To import eCut toolbar to CorelDRAW workspace you have to this simple steps: Open Tools/Customization Select Workspace Press Import In new window select Brows In Open Dialog you have to open CorelDRAW toolbar All eCut toolbars are in this folder: C:\eCut\eCut6\CorelDRAW Toolbar Each CorelDRAW version has own toolbar - select folder, that contains your toolbar version There are few languages available: RUS(russian) and ENG(english) After you select toolbar file, press Next Next again Next again And Finish Now press OK and save all changes To show eCut toolbar you have to last thing: click right mouse button on emty space in CorelDRAW toolbar area (see image) And in PopUp menu find eCut and click on it Here it is! If you did everything as shown - you'll get it, but if you can not see eCut in toolbars, start over again this tutor ... CorelDRAW toolbar All eCut toolbars are in this folder: C: eCut eCut6CorelDRAW Toolbar Each CorelDRAW version has own toolbar - select folder, that contains your toolbar version There are few... folder:C: eCut eCut6CorelDRAW GMS CorelDRAW setup folder you have to find out from your system administrator, and after that copy eCut GMS file to this folder:{CorelDRAW}DrawGMS Importing eCut. .. CorelDRAW version, skip this stage and go to Importing eCut toolbar in CorelDRAW But if your CorelDRAW version is not checked, then you have to copy GMS file manually GMS (macros) file for launching eCut