Tài liệu Fundamentals Of Corporate Finance docx

Ngày tải lên: 20/12/2013, 17:15

Ngày tải lên: 22/02/2014, 06:20

... cost/performance trade-offs than those using current costs. The caption of Figure 1.3 discusses some of the long-term trends in DRAM cost. FIGURE 1.3 Prices of four generations of DRAMs over time ... instruction formats, and a large number of registers. Figure 2.30 shows the ratio of the number of instructions executed, the ratio of CPIs, and the ratio of performance measu...

Ngày tải lên: 22/12/2013, 10:16

... influence the level of interest rates. a) Investors' expected rate of return d) Preference of potential investors for consumption versus savings 5. The offered rate of interest reflects ... TIME VALUE OF MONEY INTRODUCTION We know that money has two general purposes: it serves as a store of value and as a medium of exchange. The term time value of money refers to all aspe...

Ngày tải lên: 22/12/2013, 16:15

... Marcus Wallace E. Carroll School of Management Boston College with additional material from Fundamentals of Corporate Finance, Alternate Fifth Edition Essentials of Corporate Finance, Second Edition Stephen ... material from Fundamentals of Corporate Finance Third Edition Richard A. Brealey Bank of England and London Business School Stewart C. Myers Sloan School of M...

Ngày tải lên: 31/03/2014, 22:21

... torque of 5 KN-m. The material has a yield point of 350 MPa. Find the required diameter using (a) Maximum shear stress theory (b) Maximum distortion energy theory Take a factor of safety of 2.5. ... Summary of this Lesson Different types of loading and criterion for design of machine parts subjected to static loading based on different failure theories have been demonstra...

Ngày tải lên: 25/12/2013, 23:18

... However, in the presence of notches and cracks determination of total strain is difficult. 3.4.1.2F- Plots of strain amplitude vs number of stress reversals for failure. ... At the end of this lesson, the students should be able to understand • Design of components subjected to low cycle fatigue; concept and necessary formulations. • Design of...

Ngày tải lên: 25/12/2013, 23:18

... (8.1.1) Where, M : Bending moment at the point of interest d o : Outer diameter of the shaft k : Ratio of inner to outer diameters of the shaft ( k = 0 for a solid shaft because ... Kamalesh, Design of Machine Elements, Prentice Hall of India, New Delhi, 2003. Version 2 ME , IIT Kharagpur Module 8 Design of Shaft...

Ngày tải lên: 23/01/2014, 04:20

... of the converted power that is defined as mec tp ω = (13) in terms of other known powers and derivation of the equation for motion of rotating masses in terms of known parameters and inputs of ... winding is placed in slots of the stationary stator and/or in slots of rotational rotor. The winding consists of an appropriate number of turns. A turn is composed of two condu...

Ngày tải lên: 23/01/2014, 06:20

... junctions we ld weld 9.2.2.4F- Method of construction of multilayered cylinder 3. Autofrettage In some applications of thick cylinders such as gun barrels no inelastic deformation ... find the radial displacements of the cylinder walls at the contact we consider that ( r u1 rE θθ ) ε == σ−νσ. This gives the radial displacement of the inner wall of the...

Ngày tải lên: 27/01/2014, 14:20