Tài liệu Study Guide Switching 3 0 (Building Cisco Multilayer Switched Networks) Version 1 1 pptx

... Category 3, 4,5 UTP 2 10 0 m 10 0 BaseT4 EIA/TIA Category 3, 4,5 UTP 4 10 0 m 10 0 BaseFX Multimode fiber (MMF) with 62.5 micron core; 1 30 0 nm laser 1 400 m (half-duplex) 2 ,00 0 m (full-duplex) Single-mode ... TABLE 1. 1: TABLE 2 .1: TABLE 2.2: TABLE 2 .3: TABLE 2.4: TABLE 5 .1: TABLE 7 .1: TABLE 8 .1: TABLE 10 . 1: TABLE 11 .1: TABLE 12 .1: TABLE 12 .2: T...

Ngày tải lên: 10/12/2013, 17:15

... 7.5 .1 MLS Caching 6 40- 604 Switching 3. 0 www.testking.com - 1 - 6 40- 604 Study Guide Switching 3. 0 (Building Cisco Multilayer Switched Networks) Version 1. 1 6 40- 604 Switching 3. 0 ... 1. 4 .1. 1 Data Encapsulation 1. 4 .1. 2 Layer 2 Switching 1. 4 .1 .3 Layer 3 Switching 1. 4 .1. 4 Layer 4 Switching 1. 4 .1. 5 Multi-L...

Ngày tải lên: 16/10/2013, 13:15

... 400 0–4xxx 500 0–5xxx Telnet (binary mode) 600 0–6xxx 700 0–7xxx Xremote 900 0–9xxx 10 0 00 10 xxx TABLE 3. 3: Standard AT Commands Command Result AT&F Loads factory default settings ATS0=n Auto ... high_ip_pool_address 6 40- 605 Remote Access 3. 0 www.testking.com - 1 - 6 40- 605 Study Guide Remote Access 3. 0 (Building Cisco Remote Access Net...

Ngày tải lên: 10/12/2013, 17:15

... Components 2 .1 Choosing WAN Equipment 2 .1. 1 Central office Router Selection 2 .1. 1 .1 The 36 00 Router Series 2 .1. 1.2 The 400 0 Router Series 2 .1. 1 .3 The AS5X 00 Router Series 2 .1. 1.4 The 7 200 Router ... 400 0–4xxx 500 0–5xxx Telnet (binary mode) 600 0–6xxx 700 0–7xxx Xremote 900 0–9xxx 10 0 00 10 xxx TABLE 3. 3: Standard AT Commands Command Result AT&F...

Ngày tải lên: 18/10/2013, 18:15

... http://www .cisco. com/en/US/products/sw/iosswrel/ps1 8 31 /products_configuration _guide_ chapter0 918 6a 008 00 7ff07.html# 10 0 0946 QUESTION NO: 51 What is the maximum time that a voice package should be allowed to cross a network? A. 90 milliseconds B. 1 20 milliseconds ... infrastructure Reference: http://www .cisco. com/en/US/netsol/ns1 10 / ns2 21/ ns2 23/ ns2...

Ngày tải lên: 26/10/2013, 23:15

... m Thicknet (10 Base5) 10 Mbps 500 m Category 3 (10 BaseT) 10 Mbps 10 0 m for both half duplex and full duplex. Category 5 ( 10 0 BaseT and 10 0 BaseTX) 10 0 Mbps and 10 0 m for both half duplex ... duplex and full duplex. Category 5e ( 10 0 0BaseT and 10 0 0BaseTX) 10 0 0 Mbps 10 0 m for both half duplex and full duplex. Multimode fiber (MMF) (10 BaseFL) 10 Mbps 2...

Ngày tải lên: 10/12/2013, 17:15

... cylinder as shown FRONT TOP RIGHT A _1 Involute Gears Pro/ENGINEER Wildfire 3. 0 Tips and Tricks Page 12 COPYRIGHT    200 8 CADQUEST INC. Task 11 : Create an extruded cut. • Create ... Figure 1 Figure 2 Figure 3 Figure 4 Figure 5 Involute curve Figure 6 Pro/ENGINEER Wildfire 3. 0 Tips and Tricks Involute Gears COPYRIGHT    200 8 CADQUEST INC....

Ngày tải lên: 20/01/2014, 04:20

... m Thicknet (10 Base5) 10 Mbps 500 m Category 3 (10 BaseT) 10 Mbps 10 0 m for both half duplex and full duplex. Category 5 ( 10 0 BaseT and 10 0 BaseTX) 10 0 Mbps and 10 0 m for both half duplex ... duplex and full duplex. Category 5e ( 10 0 0BaseT and 10 0 0BaseTX) 10 0 0 Mbps 10 0 m for both half duplex and full duplex. Multimode fiber (MMF) (10 BaseFL) 10 Mbps 2...

Ngày tải lên: 24/01/2014, 10:20

... Theo khai báo Units angle (đơn vị thể hiện góc. Vd: 15 d 20 30 ’…) + Dấu chấm. (Vd: 15 . 20 . 30 . 20 - độ phút giây cách nhau bởi dấu chấm. 15 . 2 01 2 - độ) + Dấu tab - Công cụ đo đạc . Toàn đạc điện ... TRÌNH TOPO 3. 0 TOPO 3. 0 1 Mô hình a hình sđị ố 1 Biên t p b n ậ ả đồ 1 Bình đồ 1 I_Nh p s li uậ ố ệ 2 1. Nh p d li u i m oậ ữ ệ để đ 3 2_Nh p theo t p v n b n to...

Ngày tải lên: 26/01/2014, 13:20