... Routers and Routing Basics v 3.0 - Lab 9.2.6 Copyright 2003, Cisco Systems, Inc. Lab 9.2.6 Troubleshooting Using Ping and Telnet Objective • Use knowledge of OSI Layers 1, 2 and 3 to diagnose network ... according to the chart. This will introduce some errors. Team member 2 should test the configuration using physical inspection, ping and Telnet. Note: Go to the erase and reload instr...
Ngày tải lên: 19/10/2013, 02:15
Using Samba-9. Troubleshooting Samba-P1
... troubles: trace and tcpdump. 9.1.3.1 Using trace The trace command masquerades under several different names, depending on the operating system that you are using. On Linux it will be strace, on ... chars" For anyone using Windows for Workgroups and older clients. They will fail to connect to shares with long names, producing an overflow message that sounds confusingly like a memory...
Ngày tải lên: 20/10/2013, 10:15
Lab 9.3.4 Troubleshooting using Traceroute
... Routers and Routing Basics v 3.0 - Lab 9.3.4 Copyright 2003, Cisco Systems, Inc. Lab 9.3.4 Troubleshooting using Traceroute 2 - 3 CCNA 2: Routers and Routing Basics v 3.0 - Lab 9.3.4 Copyright ... the configurations on the host and directly connected router. Step 4 Test Layer 3 connectivity Using the command prompt enter ping and the IP address of all routers interfaces. This will t...
Ngày tải lên: 23/10/2013, 00:15
Using Samba-9. Troubleshooting Samba-P2
... passwords aren't actually needed unless you're using Internet Explorer 4.0 without a firewall, so it's reasonable to keep using unencrypted passwords on your own networks. * If you ... address of all ones). If this draws responses, the broadcast address you've been using before is wrong. Troubleshooting these is discussed in the Section 9.2.9.2, Broadcast addresses...
Ngày tải lên: 24/10/2013, 09:15
... Intermediate Routing v 3.0 - Lab 1.2.6 Copyright 2003, Cisco Systems, Inc. Lab 1.2.6 Troubleshooting RIP v2 using Debug Objective • Configure RIP v2 on both routers • Use debug commands to ... RIP routing updates a. From the enable privileged EXEC mode, examine the routing table entries using command debug ip rip command on each router. b. What are the three operations tha...
Ngày tải lên: 21/12/2013, 19:15
Tài liệu Lab 1.2.6 Troubleshooting RIP Version 2 using Debug doc
... Lab 1.2.6 Troubleshooting RIP Version 2 using Debug Objective • Configure RIPv2 on both routers • Use debug commands to ... routing updates. a. From the enable privileged exec mode: b. Examine the routing table entries using the debug ip rip command on each router. c. What are the three operations that take place
Ngày tải lên: 21/12/2013, 19:15
Tài liệu Troubleshooting a NIC Using the Ping Command doc
... IT Essentials I v2.0 - Lab 9.7.2 Copyright 2002, Cisco Systems, Inc. Lab 9.7.2: Troubleshooting a NIC Using the Ping Command Estimated time: 15 Minutes Objective Upon completion of this ... there are utilities that allow a technician to begin troubleshooting a problem without leaving the office. There are a wide variety of troubleshooting tools available to a technician. Ma...
Ngày tải lên: 21/12/2013, 19:15
Tài liệu TCP/IP Sleuthing – Troubleshooting TCP/IP Using Your Toolbox pptx
... RIP information captured from the network using a protocol analyzer. Knowledge of UDP and RIP are required to successfully use this infor- mation for troubleshooting. Here is another example. ... T raining LLC. All rights reserved. Page 11 Troubleshooting OSI Layers 5, 6, and 7 As mentioned earlier, the higher you go in the OSI model, the more complex the troubleshooting process becom...
Ngày tải lên: 17/01/2014, 06:20
Recovering mailbox user using dial tone recovery
... Temp Recovering Mailbox User Using Dial-Tone Recovery http://msopenlab.com/index.php?option=com_content&view=article&id= 7 of 26 6/17/2011 1:47 PM Loading Recovering Mailbox User Using Dial-Tone ... System Sharepoint Server Network Security Virtualization Technologies Other Technology Recovering Mailbox User Using Dial-Tone Recovery http://msopenlab.com/index.php?option=com_co...
Ngày tải lên: 14/08/2012, 08:51
Using Net Beans 5.0
... Using NetBeansTM 5.0 IDE 1Using NetBeansTM IDE 5.0Your Guide to Getting Work Done in NetBeans IDEWelcome to the Using NetBeans™ IDE 5.0 guide. This guide ... .................................................................2 2Using File Templates ........................................................2 2Using GUI Templates .......................................................23Editi...
Ngày tải lên: 17/08/2012, 09:18