Configuring the Platform

... check your configuration in the log file. The log file resides in the temp directory. Click Run, type %temp% in the Open box, and then click OK. CHAPTER 1 ■ CONFIGURING THE PLATFORM1 4 Creating User ... want the home directory to reside. Microsoft uses Local Disk (C:) in the tutorials. If this site is the entry point for the SCA, deselect the Allow Anonymous Access to...

Ngày tải lên: 05/10/2013, 14:20

... launched the IDE. You can determine the current user directory in the About dialog box. Choose Help > About and then click the Detail Tab. The tab lists the location of the User Dir as well as other ... selecting the Miscellaneous category in the left pane and clicking the Ant node in the right pane. You can specify the following properties: ■ Ant Home. The instal...

Ngày tải lên: 03/10/2013, 03:20

... while viewing the graphical output on another computer, connected to the first via a network. With the advent of the Internet, which interconnected a sizable fraction of the computers on the planet, ... idea to write these down so that you remember to observe them even after they've scrolled off the screen. Figure 5.14: The selected card definition Next, you must specify...

Ngày tải lên: 07/11/2013, 10:15

... menu to save the document to an enhanced folder in the workspace. Use the File menu to check in the document. Open the Web folders view of the workspace to view and then change the document's ... using the Web folders view of the workspace 1. In the Web folders view of the workspace window, click Up three times, and then double-click Management. 2. In the...

Ngày tải lên: 10/12/2013, 16:15

... 17 Configuring Application Filters 24 Lab A: Configuring the Firewall 35 Review 45 Module 6: Configuring the Firewall Module 6: Configuring the Firewall 45 Review  Securing the ... between the networks. Note Module 6: Configuring the Firewall 9 Configuring the Perimeter Network The Microsoft Web Proxy service and the network address translation...

Ngày tải lên: 10/12/2013, 16:16

... also emphasizes the difference between the output of ifconfig and the routing table. ifconfig shows the address of the interface, the address needed to reach our system. Forthe Ethernet interface, ... tun0 These decisions are the basis of routing .The implementation performs them with the aid of a routing table,which tells the system which addresses are available where. We’v...

Ngày tải lên: 11/12/2013, 00:15

... 4  Configuring the Windows 2000 Environment As shown in Figure 4.15, the MMC console contains two panes: a console tree on the left and a details pane on the right. The console tree lists the ... account the service uses, and the computer’s recovery response if the service fails. This utility also shows any dependencies that the service requires. FIGURE 4.13 The Se...

Ngày tải lên: 17/01/2014, 07:20

... combination can be used. Please refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output used in ... interfaces according to the chart. Finally, configure the IP hostnames. Do not configure the routing protocol until specifically told to. If there are any problems con...

Ngày tải lên: 18/01/2014, 04:20

... Processes • The dynamic parameter LOG_ARCHIVE_MAX_PROCESSES controls the number of archive processes started at instance startup. • A maximum of ten ARCn processes can be specified. • The number ... the Archive Log Destination • Use LOG_ARCHIVE_DEST_n to specify up to ten archival destinations. • Use LOG_ARCHIVE_FORMAT to include the log sequence number and thread number as...

Ngày tải lên: 23/03/2014, 00:20

... rock-solid foundation in the C# programming language (including a full discussion of OOP) and the critical aspects of the .NET 4 platform. Once you digest the information presented in the book you hold ... count 544ppi THE EXPERT’S VOICE ®  IN .NET Exploring the .NET universe using curly brackets Andrew Troelsen Pro C# 2010 .NET 4 Platform FIFTH EDITION and the Pro C# 2010 a...

Ngày tải lên: 04/10/2013, 14:07