Xe ô tô hyundai excel toàn tập hyundai excel - P2

... lb)R-12, 85 0-1 ,000 (3 0-3 5, 1. 9-2 .2)3,300 (13,000)DKS - 15BH6 cylinders, 1537,000 rpmElectromagnetic, single-plate dry clutchDC 12V, 45W85 0-9 00 rpmFin mounted thermostatOFF: - 1° - 1°C (30° - 34°F)ON: ... thermostatOFF: -1 ° - 1°C (30° - 34°F),ON: 3° - 5°C (38° - 41°F)SERVICE STANDARDSAir-conditioningAmount of deflection of V beltEngine idling...

Ngày tải lên: 23/10/2012, 08:48

... Connect one lead of a self-powered test light or ohmmeter toone end of the part of the circuit you wish to test.3. Connect the other lead to the other end.4. If the self-powered test light glows, ... this at convenient point (about six inches apart)while watching the self-powered test light or ohmmeter.5.When the self-powered test light glows, or ohmmeter registers,there is a short to ground...

Ngày tải lên: 23/10/2012, 08:48

... bolt3 5-4 24 6-5 14 3-5 33 0-3 43 0-3 4 8-9 .51 5-2 11 5-2 11 9-2 21 0-1 11 5-2 12 0-2 62 0-2 612 8-1 38 8-9 .5 4-5 .51 7-2 0 8-9 .51 0-1 12 0-2 61 0-1 11 5-2 1 4-5 .5 8-9 .51 0-1 1 5-6 .5 3-4 .536 0-4 3046 0-5 3043 0-5 5030 0-3 5030 0-3 508 0-1 0015 0-2 2015 0-2 2019 0-2 3010 0-1 2015 0-2 2020 0-2 7020 0-2 701,30...

Ngày tải lên: 23/10/2012, 08:48

... anchorage3 6-4 236 0-4 202 6-3 01 3-2 6 13 0-2 60 9-1 92 8-3 5 28 0-3 5020. 2-2 5.32 8-3 5 28 0-3 5020. 2-2 5.32 2-2 722 0-2 701 6-1 9.52 2-2 722 0-2 701 6-1 9.5 7-9 7 0-9 0 5-6 .5 7-9 7 0-9 0 5-6 .5 7-9 7 0-9 0 5-6 .52 2-2 722 0-2 701 6-1 9.52 2-2 722 0-2 701 6-1 9.515. 4-1 9.015. 4-1 9.015. 4-1 9.015. 4-1 9.03 0-4 4...

Ngày tải lên: 23/10/2012, 08:48

... headlight.4. Re-check target alignment on both aimers and readjust horizon-tal aim if necessary.5. Remove aimers by pressing “vacuum release” button located onpiston handle.9 0-1 6 LIGHTING SYSTEMHEADLIGHT ... connectors could troubles. Make sure that the connec-tors are connected securely. GENERALWhen disconnecting a connector, be sure to pull only the con-nector, not the harness.Disconnec...

Ngày tải lên: 23/10/2012, 08:48

... 7 0-9 0 5. 1-6 .51 3-1 713 0-1 709. 4-1 21 2-1 6 12 0-1 608. 7-1 17. 8-1 28 0-1 20 5. 8-8 .77 8-9 3 80 0-9 50 5 8-6 95 9-7 8 60 0-8 00 4 3-5 84 9-5 9 50 0-6 00 3 6-4 32 2-3 122 0-3 20 1 6-2 33 4-4 435 0-4 502 5-3 26 4-7 4 65 0-7 50 4 7-5 44 9-5 950 0-6 003 6-4 37. 8-1 2 ... hubLeading-trailing drum brakeWheel cylinderBraking pl...

Ngày tải lên: 23/10/2012, 08:49

... mounting bolts3 0-3 4 30 0-3 50 2 2-2 5Clutch to flywheel 1 5-2 115 0-2 10 1 1-1 54 1-2 GENERALSPECIAL TOOLSTool(Number and name)0941 1-1 1000Clutch disc guide0941 4-1 1100Lock pin installer0941 4-1 1000Lock pin ... discRevet sink18 7-1 92 mm (7. 4-7 .6 in.)2 0-3 0 mm (0. 8-1 .2 in.)145 mm (5.7 in.) 5-6 mm (0.2 0-0 .24 in.)0.3 mm (0.012 in.)TIGHTENING TORQUENm...

Ngày tải lên: 23/10/2012, 08:49

... mounting)2 0-2 6Water pump pulley 8-1 0Water temperature gauge unit2 9-3 9Water temperature sensor2 9-3 9Engine oil cooler bolt2 9-3 420 0-2 5012 0-1 5012 0-1 5020 0-2 708 0-1 0030 0-4 0030 0-4 0030 0-3 501 4-1 8 9-1 1 9-1 11 4-2 0 6-7 2 2-2 92 2-2 92 2-2 52 5-3 GENERALSPECIAL ... coolerQuantityPerformanceWater-cooled, pressurized,Forced circulatio...

Ngày tải lên: 23/10/2012, 08:49

... shaftnut19 6-2 55 2,00 0-2 ,600 14 5-1 88Knuckle to strut7 4-8 8 75 0-9 00 5 4-6 5Lower arm to ball joint9 3-1 18 95 0-1 ,200 6 9-8 7Lower arm to strut bar9 3-1 18 95 0-1 ,200 6 9-8 7Knuckle totie rod1 5-3 3 15 0-3 40 1 1-2 5LUBRICANTSB.J. ... knuckle inside surfaceOil seal lip6 0-9 0 gr. (2. 1-3 .2 oz.)As requiredAs requiredAs required4 9-2 GENERALSPECIAL...

Ngày tải lên: 23/10/2012, 08:49

... the blow-by gases areback up into the air cleaner through the breather hose.Flow CharacteristicsVacuum(mmHg)Flow Quantity (lit./min )-5 0 0-4 0 0-3 0 0-2 00 -1 0 0-5 014±314.5±320±3 25±428±428±42 9-1 1 CRANKCASE ... (HC)HC from fuel tankOpen -Closed-is absorbed into thecanisterBelow 1450Closed-rpmClosedAbove 1450OpenHC from canister is-rpmled into carburetorHC from fuel tank is...

Ngày tải lên: 23/10/2012, 08:49