... to hopefully restore the registry • If it was an NT machine, hopefully the user had a NT Emergency Boot Disk specific to that unit and I would use it and go the "Repair" route Page 28 200 ways ... to boot (not allowing it to spin up to full RPM), the amperage required to spin the motor is more than what the motherboard draws/needs even if it has a full bus Also, I've even seen some ISA, ... hard drive Page 200 ways to revive a hard drive www.techrepublic.com 3) I could take the hard drive out of your machine, plug into my Secondary IDE controller, and boot up Hopefully, I can see...