... http://www.dotnetspider.com/tutorials/BestPractices.aspx To develop reliable and maintainable applications, you must follow coding standards and best practices The naming conventions, coding standards and best practices ... License, Copyrights and Disclaimer Revision History Introduction Purpose of coding standards and best practices How to follow the stand...
Ngày tải lên: 18/08/2012, 08:47
... 36 technical Societies q The IEEE Standards Association administers the standards process within the IEEE The American National Standards Institute (ANSI) accredits the IEEE and oversees the standards ... and oversees the standards process Many IEEE standards become ANSI standards q The Computer Society is responsible for the IEEE 802 series of standards through its LAN/M...
Ngày tải lên: 13/09/2012, 11:16
Vietnam standard tcvn 5945 _ 1995 Industrial waste water Discharge standards
... surroundings 2.7 Standard methods of analysis of parameters and concentration of substances in industrial waste waters are specified in available current TCVNs Table _ Industrial waste water Limit ... 2.6 Industrial waste water containing the values of parameters and concentrations of substances which are greater than those specified in the column C (table 1) shall not b...
Ngày tải lên: 10/04/2013, 09:48
Hoàn thiện quy trình kiểm toán chu trình tiền lương và nhân viên do Công ty HVAC thực hiện
... Thu Thuỷ 47A Lớp : Kiểm toán Chuyên đề thực tập Khoỏ lun tt nghip Khỏch hng ca HVAC l cỏc cụng ty TNHH, cỏc cụng ty c phn ,cỏc cụng ty liờn doanh hay cú u t nc ngoi hoc cỏc cụng ty nh nc S a dng ... chia tỏch doanh nghip, chuyn quyn s hu, quyn qun lớ hoc quyn s dng ti sn doanh nghip thỡ ngi s dng lao ng k tip phi chu trỏch nhim tr lng v cỏc quyn li khỏc ca ngi lao ng t doanh...
Ngày tải lên: 17/07/2013, 15:36
ENGINEERING DRAWING STANDARDS MANUAL
... d ENGINEERING DRAWING STANDARDS MANUAL X-673-64-1F REV 001 DEC ‘94 G O D D AR D S P AC E F L I G H T C E N T E R , G r e e n b e l t , M a r y l a n d ENGINEERING DRAWING STANDARDS MANUAL DRAWING ... a n d x X-673-64-1F ENGINEERING DRAWING STANDARDS MANUAL G O D D AR D S P AC E F L I G H T C E N T E R , G r e e n b e l t , M a r y l a n d ENGINEERING DRAWING STA...
Ngày tải lên: 14/08/2013, 08:05
Establishment of Effluent Standards for Industrial Wastewaters in Korea: Current Issues and Suggestions for Future Plan
... the current state of effluent standards in Korea and the considerations to be used in revising effluent standards and the framework referring to the cases of developed countries The purpose of ... changed in setting the effluent standards Table - Pollutants regulated under the effluent standards in Korea (Ministry of Government Legislation in Korea, 200...
Ngày tải lên: 05/09/2013, 10:15
CO2e emissions from HVAC equipment and lifetime operation for common U.S. building types
... the GHG emissions, both lifetime operational and M&P, from commercial buildings’ HVAC equipment in different geographical locations and climate regions; and, for various building types and fuel ... type emissions Figure CO2e GHG emissions for all buildings in Miami (1A) Figure 10 CO2e GHG emissions for all buildings in Seattle (4C) Figure 11 CO2e GHG emi...
Ngày tải lên: 05/09/2013, 15:28
Increasing energy efficiency of HVAC systems of buildings using phase change material
... 2012, pp.667-686 669 1.4 Phase change material layers The addition of a phase change material (PCM) into the external wall of a building has been shown to reduce the amount of energy required to cool ... Handbook on Low -Energy Buildings and District -Energy Systems: Fundamentals, Techniques and Examples Earthscan, London, 2006 [9] Salyer I O., Sircar A K., A Review...
Ngày tải lên: 05/09/2013, 15:28
An experimental investigation of heat transfer and fluid flow in a rectangular duct with inclined discrete ribs
... rib arrangements on heat transfer and flow behavior in a rectangular rib roughened passage” International Journal of Heat and mass transfer; 123: 675-681, 2001 [6] Lau S.C., McMillin R.D and Han ... studies of augmented heat transfer and friction in asymmetrically heated rectangular ducts with ribs on the heated wall in transverse, inclined, V-continu...
Ngày tải lên: 05/09/2013, 16:10
Development of DMC controllers for temperature control of a room deploying the displacement ventilation HVAC system
... develop a controller for temperature control inside a room within a desired band of temperatures for comfort The details of the geometry of the room and the HVAC system based on displacement ventilation ... disadvantages of the DMC controller First, the DMC controller is a local controller which can only guarantee the stability of the...
Ngày tải lên: 05/09/2013, 16:11
Standards for multimedia communications
... that are to be used to perform the particular function such as • How to format the source information stream • How to detect transmission errors • How to handle errors • For each function, both ... defined protocol for that layer, passes the remaining information up to the protocol layer immediately above it CYH/MMT/Std/p.7 CYH/MMT/Std/p.8 5.3 Standards relating to interpersonal commun...
Ngày tải lên: 06/09/2013, 07:50
Adding Standards to Queries
... applications to send a much more limited number of queries to SQL Server, queries that show up again and again, and that don’t need to be recompiled every time Implementing Standard Queries The ... parameters to the command and sends it to the database for processing Run the program On the Customer Management form, select a customer from the list of customers and then click Re...
Ngày tải lên: 03/10/2013, 00:20
HVAC Systems Design Handbook part 6
... website Design Procedures: Part Design Procedures: Part 165 Figure 6. 9 shows flow versus head loss (pressure drop per 100 ft) and velocity in schedule 40 steel pipe This is for water at 60 ЊF, but ... the Terms of Use as given at the website Design Procedures: Part Design Procedures: Part TABLE 6. 8 169 Iron and Copper Elbow Equivalents See Table 6. 7 for equivalent length...
Ngày tải lên: 17/10/2013, 22:15