MODELING AND OPTIMIZATION OF FEED MILL

Modeling and optimization of the forward osmosis process   parameters selection, flux prediction and process applications

Modeling and optimization of the forward osmosis process parameters selection, flux prediction and process applications

... aspects of fulfilling the main objective of this thesis 18 CHAPTER ONE – INTRODUCTION RESEARCH OBJECTIVES Modeling and Optimization of the FO Process: Parameters Selection, Flux Prediction and Process ... this thesis seeks to suggest the use of the forward osmosis (FO) process for the low cost production of clean drinking water and an alternative...

Ngày tải lên: 10/09/2015, 15:48

237 422 0
Some extensions to reliability modeling and optimization of networked systems

Some extensions to reliability modeling and optimization of networked systems

... the reliability modeling and optimization of some networked systems The reliability of a system is usually dependent on the structure of the system and the resources spent on the maintenance and ... As many of today’s systems are large and complicated, the reliability analysis of such systems has drawn much attention, see Cook and RamirezMarquez (2009),...

Ngày tải lên: 10/09/2015, 15:51

188 510 0
Modeling and optimization of liquefied natural gas process

Modeling and optimization of liquefied natural gas process

... MODELING AND OPTIMIZATION OF A LIQUEFIED NATURAL GAS PROCESS M M FARUQUE HASAN (BSc in Chem Engg., Bangladesh University of Engineering & Technology) A THESIS SUBMITTED FOR THE DEGREE OF PHD ... Although natural gas (NG) is the natural choice among fossil fuels, most NG reserves are offshore and away from demand sites Liquefied natural gas (LNG) is the most eco...

Ngày tải lên: 14/09/2015, 08:45

215 556 0
Modeling and optimization of gas networks in refinery

Modeling and optimization of gas networks in refinery

... overall consumption of these utilities/gases in the entire refinery This thesis mainly addresses the modeling and optimization of such gas networks in a refinery The refinery gas networks considered ... process modeling and optimization to minimize the cost of design and operation of the gas networks in the refinery namely the hydrogen networks...

Ngày tải lên: 02/10/2015, 17:14

231 343 0
Modeling and optimization of microbial fuel cells

Modeling and optimization of microbial fuel cells

... 1.3 Microbial Fuel Cells ……………………………………………………………….2 1.4 Microbial Fuel Cells for wastewater treatment and energy recovery ……………… Chapter : Literature Review 2.1 Principle of a Microbial ... 22 2.4 Microbial Fuel Cell Modeling …………………………………………………… 22 Chapter : Theoretical developments 24 3.1 Modeling of our Microbial Fuel Cells …………………………………………….24 3.1.1 Descrip...

Ngày tải lên: 16/10/2015, 15:39

111 800 0
Modeling of tumor growth and optimization of therapeutic protocol design

Modeling of tumor growth and optimization of therapeutic protocol design

... status and achievements of mathematical modeling of both avascular and vascular tumor growth It included the models of avascular tumors, multicellu- 18 2.1 Mathematical modeling of cancer growth ... field of modeling of avascular tumor growth has been quoted extensively and form the basis for most of the future works According to Burton (1966), the tumor...

Ngày tải lên: 10/09/2015, 15:48

204 622 0
A framework for modeling, analysis and optimization of robust header compression

A framework for modeling, analysis and optimization of robust header compression

... work and discussions with Mr Sukanta Kumar Hazra and Mr Wang Haiguang Many others have contributed to making the author’s candidature at the Institute for Infocomm Research a satisfying and enlightening ... either not change throughout a flow, or typically increase with small deltas between consecutive packets of a flow Header compression capitalizes on the behavioral patt...

Ngày tải lên: 16/09/2015, 12:35

89 448 0
High speed milling of titanium alloys  modeling and optimization

High speed milling of titanium alloys modeling and optimization

... HIGH- SPEED MILLING OF TITANIUM ALLOYS: MODELING AND OPTIMIZATION WANG ZHIGANG (B Eng, M Eng) A THESIS SUBMITTED FOR THE DEGREE OF DOCTOR OF PHILOSOPHY DEPARTMENT OF MECHANICAL ENGINEERING ... milling of titanium alloys This chapter introduces an overview of high- speed machining of titanium alloys; then a brief overview of milling process modeling...

Ngày tải lên: 16/09/2015, 17:13

206 306 0
Numerical simulation and optimization of CO2 sequestration in saline aquifers for enhanced storage capacity and secured sequestration

Numerical simulation and optimization of CO2 sequestration in saline aquifers for enhanced storage capacity and secured sequestration

... Algorithms in Search, Optimization & Machine Learning AddisonWesley, Boston, 1989 Zhang Z., Agarwal R.K Numerical Simulation and Optimization of CO2 Sequestration in Saline Aquifers for Vertical and ... [4] Zhang Z., Agarwal R.K Numerical Simulation and Optimization of CO2 Sequestration in Saline Aquifers in: Proceedings of 10th Annual Confer...

Ngày tải lên: 05/09/2013, 16:10

12 577 0
Modeling and Simulation of Microbial Depolymerization Processes of Xenobiotic Polymers

Modeling and Simulation of Microbial Depolymerization Processes of Xenobiotic Polymers

... 12 Modeling and Simulation of Microbial Depolymerization Processes of Xenobiotic Polymers 12.4.2 Analysis of Enzymatic PLA Depolymerization The experimental and analytical study of endogenous depolymerization ... HPLC profiles of PEG before and after the cultivation of the microbial consortium E-1 [11, 12] 289 290 12 Modeling and Simulation of Mic...

Ngày tải lên: 25/10/2013, 08:20

26 522 0
w