AN1140 USB embedded host stack

Legacy Support for USB Keyboards and Mice and the Host Controller Driver

Legacy Support for USB Keyboards and Mice and the Host Controller Driver

... control of the host controller from the BIOS, the Microsoft host controller driver clears the RS bit to stop the host controller and clears the CF bit USB STATUS (USBSTS) register structure The USBSTS ... OHCI Host Controller The host controller driver is responsible for a per -host controller set of data called device data At startup and shu...

Ngày tải lên: 07/10/2013, 00:20

9 429 0
usb mass storage designing and programming devices and embedded hosts

usb mass storage designing and programming devices and embedded hosts

... USB Mass Storage Designing and Programming Devices and Embedded Hosts Jan Axelson Lakeview Research LLC Madison, WI USB Mass Storage: Designing and Programming Devices and Embedded Hosts ... USB mass- storage protocol Every USB mass- storage device must detect and respond to requests that are specific to the USB mass- storage class • SCS...

Ngày tải lên: 06/07/2014, 15:37

304 375 0
Using Embedded Tools for I2C, SPI, and USB Debugging for the Renesas RX63N RDK

Using Embedded Tools for I2C, SPI, and USB Debugging for the Renesas RX63N RDK

... Correcting the source code and verifying the solution Click Connect in the Application Box 46 Save and rebuild the project referring to the handout Click I2C to LCD to verify the solution © 2012 Renesas ... reserved 7 The Renesas DevCon 2012” message will be displayed on the LCD along with a prompt to reinsert the USB cable Beagle USB 480 Protocol Analyzer Host...

Ngày tải lên: 22/06/2015, 14:17

61 487 0
Using Embedded Tools for I2C, SPI, and USB Debugging for the Renesas RX63N RDK_LabProcedures

Using Embedded Tools for I2C, SPI, and USB Debugging for the Renesas RX63N RDK_LabProcedures

... made to the source code, you will need to save, rebuild, and load the project before moving to the next steps in the presentation Follow the steps below after you have made corrections to the source ... download the module Step Make sure the Renesas Debug “Perspective” (tab) is active, if it wasn’t selected automatically You can switch between the C/C++ and debug persp...

Ngày tải lên: 22/06/2015, 14:17

2 256 0
CMP book embedded systems design

CMP book embedded systems design

... severe in embedded systems than in desktop systems Embedded systems often have power constraints Embedded systems often must operate under extreme environmental conditions Embedded systems have ... Embedded Systems Design An Introduction to Processes, Tools, and Techniques Arnold Berger CMP Books CMP Media LLC 1601 West 23rd Street, Suite 200 Lawrence, Kansas 66046...

Ngày tải lên: 16/08/2012, 09:40

209 808 1
Stack Queue

Stack Queue

... xếp (Stack) Ngăn xếp (Stack)  Khái niệm Stack Hàng đợi (Queue)  Các thao tác Stack  Hiện thực Stack  Ứng dụng Stack Hàng đợi (Queue) Chương 5: Ngăn xếp – Hàng đợi Stack - Khái niệm  Stack ... dung 50   Ngăn xếp (Stack) Hàng đợi (Queue)  Khái niệm Queue  Các thao tác Queue  Hiện thực Queue  Ứng dụng Queue Chương 5: Ngăn xếp – Hàng đợi Queue - Khái niệm 51  Qu...

Ngày tải lên: 17/08/2012, 10:09

89 774 7
Tìm hiểu về Stack

Tìm hiểu về Stack

... Other operations of Stack are similar … Built a List ADT from Stack ADT If the Stack ADT has been built first, List ADT may be inhirited from the Stack Some of its operations call Stack s operations; ... end Node Stack top count end Stack a) Conceptual b) Physical 12 Create Linked Stack Create () Creates an empty linked stack Pre none Post An empty linked stack has ... o...

Ngày tải lên: 20/08/2012, 12:07

31 1.1K 4
Tài liệu về Stack Applications

Tài liệu về Stack Applications

... ReverseList() stackObj stackObj.Create() loop (not stackObj.isFull() and there is more number) read (number) stackObj.Push(number) loop (not stackObj.isEmpty()) stackObj.Top(number) stackObj.Pop() ... GoalSeeking1 (…) stackObj stackObj.Push(StartNode) loop ((not stackObj.isEmpty()) and (Destination is not found)) stackObj.Top(node) stackObj.Pop() if (node is not Destination) Push into stack...

Ngày tải lên: 20/08/2012, 12:07

37 761 3
Kiến thức về USB.doc

Kiến thức về USB.doc

... đun USBD qua yêu cầu cho mô đun HCD Mô đun HCD chia cắt yêu cầu vào giao dịch riêng lẻ, dựa vào kiến thức đờng truyền đặc trng thiết bị USB mà đợc nối tới đờng truyền, hoạch định giao dịch qua đờng ... truyền khám phá tất hàm sử dụng phơng pháp Đặc biệt, Và Quan trọng, Mà đờng truyền yêu cầu không Kiến thức hàm đờng truyền, trạng thái họ, để khám phá hàm khác Một ví dụ đơn giản điều H...

Ngày tải lên: 21/08/2012, 16:17

45 1.5K 4
Hướng dẫn tạo Boot bằng USB

Hướng dẫn tạo Boot bằng USB

... đường dẫn đến ổ ảo A hình sau: - Nhắp OK, sau nhắp Format, thông báo lên, tiếp tục chọn Yes để format USB Quá trình format thành công, USB boot Copy file Ghost.exe thư mục Boot bang USB vào USB ... Chạy chương trình Boot9 8.exe” có biểu tượng thông báo ra, sau nhắp OK: , Cài đặt chương trình “HPUSB” thư mục Boot bang USB - - cách nhắp kép vào biểu tượng Sau cài xong, cắm USB v...

Ngày tải lên: 23/08/2012, 11:55

6 1.3K 5
CẤU TRÚC DỮ LIỆU STACK VÀ ỨNG DỤNG CỦA STACXK TRONG CÁC GIẢI THUẬT ĐỆ QUY.DOC

CẤU TRÚC DỮ LIỆU STACK VÀ ỨNG DỤNG CỦA STACXK TRONG CÁC GIẢI THUẬT ĐỆ QUY.DOC

... động stack ứng dụng stack giải thuật đệ qui III ĐỐI TƯỢNG NGHIÊN CỨU • Lí thuyết cấu trúc liệu trừu tượng Stack • Hoạt động Stack việc áp dụng stack số toán • Đệ qui số giải thuật đệ qui • Việc ứng ... Cấu trúc liệu Stack ứng dụng stack giải thuật đệ qui PHẦN 1: MỞ ĐẦU I LÍ DO CHỌN ĐỀ TÀI Các kiểu cấu trúc liệu stack, queue… v...

Ngày tải lên: 24/08/2012, 15:42

32 4.1K 24
w