Modeling and detection for holographic data storage

... of Symbols and Abbreviations xv Introduction 1.1 Motivations for Holographic Data Storage 1.2 Introduction to Holographic Data Storage 1.3 Holographic Data Storage Channel ... increased storage density; however they lead to higher IPI and lower SNR respectively 1.3.1 Detection for Holographic Data Storage Before presenting our survey on signal processing te...

Ngày tải lên: 26/11/2015, 12:31

... basis for our face model and provides a foundation for many further face modeling and rendering operations, we have extended previous surface fitting techniques to allow a generic face to be conformed ... BRDFs of several subjects’ foreheads and include fitted parameters for the BRDF model of Lafortune et al [10], so they provide an excellent starting point for rendering a...

Ngày tải lên: 08/03/2014, 11:20

... Network Modeling and Simulation for the Practicing Engineer Jack Burbank, William Kasch, Jon Ward AN INTRODUCTION TO NETWORK MODELING AND SIMULATION FOR THE PRACTICING ENGINEER Jack Burbank William ... relatively constant over the transmission of the message From Table 2-3, the IEEE 802.11 b and g channel bandwidth both exceeds and is below the...

Ngày tải lên: 02/04/2014, 15:49

... original data segments, and we refer to it as Cooperative Coding and Caching (C ); compre for example Network Coding (NC) and no coding at all (Non-NC ) 3.1 Overview of Cooperative Coding and Caching ... the caching data management This paper takes advantages of coding to facilitate the caching management for streaming data in multihop wireless...

Ngày tải lên: 21/06/2014, 17:20

... based on fuzzy morphological operators specially designed for mode detection (see Section 4) SPATIAL -COLOR COMPACTNESS FUNCTION OF A COLOR IMAGE A color image can be described by the spatial -color ... the colors of the pixels and ignores their spatial location in the image So, in case of nonuniform lighting, the histogram is not always a relevant tool for color im...

Ngày tải lên: 21/06/2014, 22:20

... Meier and Mr T Riehl for performing and evaluating a large number of investigations and testings, Mr W Thomala for valuable discussions, Dr G E Totten, Dr K Funatani, Dr L Xie, and Mr R Johnson for ... International Organization for Standardization: ISO 273: Fasteners—clearance holes for bolts and screws www.iso.ch International Organization for Standardization: ISO 3506...

Ngày tải lên: 10/08/2014, 12:21

... Totten, Lin Xie, and Kiyoshi Funatani 16 5 Structural Analysis of Polymeric Composite Materials, Mark E Tuttle 16 6 Modeling and Simulation for Material Selection and Mechanical Design, George E ... Meadows 11 3 Handbook of Materials Selection for Engineering Applications, edited by G T Murray 11 4 Handbook of Thermoplastic Piping System Design, Thomas Sixsmith an...

Ngày tải lên: 10/08/2014, 12:21

... 1992, 32 , 34 3 77 Shikanai, N.; Kagawa, H.; Kurihara, M.; ISIJ Int 1992, 32 , 33 5 78 Iung, T.; Roch, F.; Schmitt, J.H International Conference on Thermomechanical Processing of Steels and Other Materials; ... Enomoto, M ISIJ Int 1992, 32 , 297 43 Enomoto, M.; Atkinson, C Acta Metall Mater 19 93, 41, 32 37 44 Enomoto, M Tetsu-to-Hagane 1994, 80, 6 53 ˚ 45 Agren, J ISIJ Int 1992, 3...

Ngày tải lên: 10/08/2014, 12:21

... 23,7 64 25,368 21 ,42 9 30,000 26, 343 15.3 64 17 .48 1 18,575 15.737 14. 241 13.713 15.366 10.076 5 .48 1 1.698 16.351 15.2 34 10.050 16.72 40 .881 29.768 0.26 0.22 0. 24 0. 24 0.22 0. 24 0.21 0. 24 0 .42 2.32 ... 0.4C–1.32Mn 0.4C–2 .43 Mn 0.4C–0.2Cr 0.4C–2.1Cr 0.4C–3.6Cr 0.4C–6.7Cr 0.4C–0.37Si 0.38C–1.75Si 0.4C–2.75Si 0.4C 1.4C 1.2C–2.0Mo Q, cal=mol Ln K n 21,532 22, 643 23,599 21,1...

Ngày tải lên: 10/08/2014, 12:21

... MLM ¼ 54 0 À 356 : 25 CÞ À 260:64ðN À 24: 65 NiÞ þ 1:36ðNiÞ2 S À 17:82ðCrÞ þ 1:42ðCrÞ2 À 47 :59 ðMnÞ þ 2: 25 MnÞ2 MA S þ 17 :5 MoÞ þ 21:87ðCoÞ À 16 :52 ðCuÞ ¼ 820 À 603:76ðCÞ þ 247:13ðCÞ2 À 55 :72ðNiÞ þ 3:97ðNiÞ2 ... stresses and micro-residual stresses [1,2] The macro-type depends on the plastic deformation of solid materials due to rapid non-uniform cooling And, the strain and deform...

Ngày tải lên: 10/08/2014, 12:21

... is mm, and two casting speeds are used Vc ¼ 400 and 60 0 mm=sec Calculated Results Simulated results of steady temperature field both in the strip and roll is shown in Fig 44(a) and (b) for the ... alloy with 5 .6% zinc and 2.5% magnesium A quadrilateral finite element mesh pattern of 60 0 elements with 1941 nodes illustrated in Fig 24 is employed for both analyses of temperat...

Ngày tải lên: 10/08/2014, 12:21

... on Physical and Numerical Simulation of Materials and Hot Working (ICPNS’99), 1999; 270 –280 Copyright 2004 by Marcel Dekker, Inc All Rights Reserved 4 Modeling and Simulation of Mechanical Behavior ... England, 2000; Vol 1, 550–556 71 Ju, D.Y.; Liu, C.C Numerical modeling and simulation of carburized and nitrided quenching Proceedings of International Conference on Ad...

Ngày tải lên: 10/08/2014, 12:21

... activation volume For given stress and strain, the value of T lnð_ à =_ Þ is constant for all e e _ temperatures and also for all strain rate values between e0 exp½ÀDG0 = _ ðkTފ and e0 This means ... induced mechanical instability can take place leading to a concentration of deformation, a localization of heat and even to the formation of shear bands An overview of different...

Ngày tải lên: 10/08/2014, 12:21

... two points of each fiber, and a kink band is observed, which is inclined to the load direction [ 59 59] Within the kink band, the matrix suffers high cyclic shear deformation, which may cause ... between the applied stress s and the internal back stress si , the particle deformation resistance sp , the material creep resistance sF and the degree of damage D For long-time creep under...

Ngày tải lên: 10/08/2014, 12:21

... hardening material, high stress multiaxiality, and regions of high porosity [106 ] A Failure Criteria Beside macromechanical empirical failure criteria [107 ,108 ], several mesoscopic mechanical ... investigation of further materials and treatments (Fig 60b) Based on the models of McClintock [128] and of Rice and Tracey, Gurson [112] deduced a yield function for materials with ra...

Ngày tải lên: 10/08/2014, 12:21