Design and fabrication of superjunction power MOSFET devices

... DESIGN AND FABRICATION OF SUPERJUNCTION POWER MOSFET DEVICES CHEN YU (M.Eng., Xi’an Jiaotong University, P.R.China) A THESIS SUBMITTED FOR THE DEGREE OF DOCTOR OF PHILOSOPHY DEPARTMENT OF ... structures of Polysilicon Flanked superjunction, Oxide-bypassed (OB) superjunction and Graded oxide by-passed (GOB) superjunction were designed to overcome the fabrication...

Ngày tải lên: 14/09/2015, 14:12

... Thanh, Nguyen Anh Tuan, Bach Gia Duong, Research, Design And Fabrication Of The 45W And The 200W, L-Band Power Amplifier Using The Modern Microstrip Technology For Application In The National ... have also investigated the S11 factor of the power divider Wilkinson on network analyzer, the result was relatively similar to that of the simulink model Afterthat we have measu...

Ngày tải lên: 22/03/2014, 11:20

... results of dielectric properties of these two varactors and thin films prove the feasibility of application of Bi1.5 Zn1.0 Nb1.5 O7 thin film into microwave tunable devices vii List of Figures ... 29 Lift-off method for fabrication of patterned Ba 0.5 Sr0.5TiO thin films…………………………………………………………… 29 2.3.1 Chapter3 Fabrication of patterned Ba 0.5 Sr0.5TiO thin...

Ngày tải lên: 04/10/2015, 10:26

... Vietnam, information transceiver system working VHF bands have a lot of important applications Therefore, the study of information transceiver systems in the band VHF to understand the structure, the ... buildings can be a problem in urban areas 1.3 Thesis objectives and structure In this thesis,I will clarify the roles and the need of a information...

Ngày tải lên: 27/05/2014, 20:57

... 19 Holland L: Vacuum Deposition of Thin Films Wiley, New York; 1956 doi:10.1007/s11671-010-9744-5 Cite this article as: Zhang et al.: Design and Fabrication of Fiber-Optic Nanoprobes for Optical ... nanoprobe fabrication A thin film of an optically opaque metal such as aluminum, silver, or gold is coated along the outside walls of the tapered optical fiber tip to for...

Ngày tải lên: 21/06/2014, 08:20

... ANALYSIS, DESIGN AND OPTIMIZATION OF OFFSHORE POWER SYSTEM NETWORK PARIKSHIT YADAV (B.Tech (Hons.), MNIT, Jaipur, INDIA) A THESIS SUBMITTED FOR THE DEGREE OF DOCTOR OF PHILOSOPHY DEPARTMENT OF ... most of the optimization based approaches only focus on minimizing the power demanded by the thrusters and ignore the efficiency of the electrical propulsion syste...

Ngày tải lên: 10/09/2015, 09:04

... DESIGN AND FABRICATION OF MICRONEEDLES FOR DRUG DELIVERY JI JING ( B.Eng.,M.Eng., NWPU, CHINA) A THESIS SUBMITTED FOR THE DEGREE OF DOCTOR OF PHILOSOPHY DEPARTMENT OF MECHANICAL ... Many of fabricated microneedles are designed for transdermal therapies to deliver drugs such as insulin and heparin On the other hand, microneedles can also be used for local d...

Ngày tải lên: 14/09/2015, 11:17

... percentages and results of the assay 3-4 Chapter Design of Bead- based Microfluidic Device CHAPTER 4 DESIGN OF BEAD- BASED MICROFLUIDIC DEVICE 4.1 Introduction A microfluidic device offers numerous ... Applications of microfluidic devices and focus of research in this thesis 2) Advantages of microfluidic devices and aim to improve multiplexing capab...

Ngày tải lên: 30/09/2015, 06:04

... 1.6 Motivation and objective of the thesis The goal of this thesis is to design and fabricate 3D nanostructures, QDs and QRs on III- V compound semiconductors The fabrication of the 3D nanostructures ... windows of lowest attenuation, viz 0.85 µm, 1.3 µm and 1.55 µm III- V semiconductor lasers using InGaAsP as an active Figure 1.3: Plot of bandgap against latt...

Ngày tải lên: 30/09/2015, 06:04

... Chapter Reflectivity based optofluidic switch based on cascading prisms Chapter Reflectivity based optofluidic switch based on cascading prisms 3.1 Conceptual design and optical principle for the optofluidic ... [1][3-8] Optofluidic technology also enables the mass implementation of the optics compartments in current state -of- the-art optofluidic devices In the...

Ngày tải lên: 30/09/2015, 06:05

... LECTURE 03: CMOS FABRICATION Fabricating One Inverter Layout & Design Rule Check Stick Diagram Euler path LECTURE 03: CMOS FABRICATION Fabricating One Inverter Layout & Design Rule Check ... the dimensions and separation rules dictated by the process fabrication facility 33 SUMMARY OF TERMINOLOGY (CONT.) 34 LECTURE 03: CMOS FABRICATION Fabricating One Inverter Layo...

Ngày tải lên: 29/07/2014, 16:21

... Suggestions for Future Works 141 Bibliography 143 iv Summary This thesis presents the design and analysis of antennas and rectifying circuits for applications in wireless power transmission ... capable of recycling low RF power A new rectenna with broad-band 1×4 quasi-Yagi antenna array and a dualband rectifier is designed to harvest the ambient RF powe...

Ngày tải lên: 09/09/2015, 11:12

... INVESTIGATIONS INTO DESIGN AND CONTROL OF POWER ELECTRONIC SYSTEMS FOR FUTURE MICROPROCESSOR POWER SUPPLIES Ravinder Pal Singh (B.Tech(Hons), IIT Kharagpur, India) A THESIS SUBMITTED FOR ... requirements, the design of next generation VRMs need a thorough understanding of the performance and design trade-os The supply voltage of the microprocessor w...

Ngày tải lên: 11/09/2015, 10:06