ICP design methods for driven piles in sands and clays

... recommended for ring shear testing; (B) worked examples of the ICP method’s use in sands and clays; and (C) the notation and symbols employed ICP design methods for driven piles in sands and clays ... ICP end bearing method in sand .50 Page 5.5 ICP design methods for driven piles in sands and clays Base resistance in clay 53 5.5.1...

Ngày tải lên: 13/08/2015, 10:35

... Theory and Application', Rankine Lecture, Geotechnique 34(2), 365-415 FRICTION COEFFICIENTS FOR PILES IN SANDS AND SILTS 20 21 22 23 24 677 Ridley, A M and Jardine, R J (1992), 'Ring-Shear Interface ... reported in this paper The controlling frictional parameter for piles in sands and silts is the critical state interface angle o~s o~s does not depend on rela...

Ngày tải lên: 13/08/2015, 10:34

... new method for evaluating the axial capacity of driven piles in siliceous sand using CPT qc data The method is shown to provide better predictions than three other published CPT based methods for ... assessment of the axial capacity of driven offshore piles in siliceous sand The review, which is described in detail in Lehane et al (2005a) and...

Ngày tải lên: 13/08/2015, 10:37

... proved Reich’s results hold in reflexive Banach spaces which have a weakly continuous duality mapping In the last ten years or so, the iterative methods for nonexpansive mappings have recently been ... Cite this article as: Wangkeeree and Preechasilp: The modified general iterative methods for nonexpansive semigroups in banach spaces† Fixed Point Theory a...

Ngày tải lên: 20/06/2014, 22:20

... for committing, or securely binding, a cryptographic key for secure transmission over an insecure channel More detailed descriptions of this scheme will be given in Section 2.5 Essentially, for ... F M Bui and D Hatzinakos OUR CONTRIBUTIONS The existing research in BSN using ECG biometric can be classified into two major categories: network topology (via clustering formati...

Ngày tải lên: 22/06/2014, 00:20

... design framework for scalar feedback in MIMO broadcast channels with limited feedback has been presented In order to perform user scheduling, these metrics may contain information such as channel ... vector x, and ∠(x, y) refers to the angle between vectors x and y LINEAR BEAMFORMING WITH LIMITED FEEDBACK Joint linear beamforming and scheduling are performed in a sys...

Ngày tải lên: 22/06/2014, 06:20

... design framework for scalar feedback in MIMO broadcast channels with limited feedback has been presented In order to perform user scheduling, these metrics may contain information such as channel ... vector x, and ∠(x, y) refers to the angle between vectors x and y LINEAR BEAMFORMING WITH LIMITED FEEDBACK Joint linear beamforming and scheduling are performed in a sys...

Ngày tải lên: 22/06/2014, 19:20

... source design environment for embedded systems based on SystemC,” Design Automation for Embedded Systems, vol 9, no 4, pp 293–312, 2004 [14] M Raulet, F Urban, J.-F Nezan, C Moy, O Deforges, ... for example, an FPGA The communication model consists of a RAM for hardware-software communication connected by a system bus, and both processors accommodate local memory units fo...

Ngày tải lên: 22/06/2014, 22:20

... commercial design system for signal processing, and also in the context of target platforms based on the StarCore DSP Retargetability to other algorithm development environments and target platforms ... existing methods In “Optimum wordlength search using sensitivity information,” K Han and B L Evans propose a fast algorithm for searching for an optimum wordlength by trading off ha...

Ngày tải lên: 22/06/2014, 23:20

... markers of acute lung inflammation In patients with acute hypoxaemic respiratory failure, acute respiratory distress syndrome (ARDS) represents the more severe form of acute lung injury (ALI) ... and mini-BAL sampling techniques, indicating that these procedures cannot be used interchangeably for studying the lung inflammatory response in patients with acute...

Ngày tải lên: 13/08/2014, 18:22

... could not be 349 Power of QTL detection methods totally linearised because of the uncertainty of the dam genotype According to the notations of Elsen et al [2], the general form of the likelihood ... (DA) technique to the multitrait detection of QTL As for PCA, a univariate analysis of a linear combination of the traits was conducted, but the calculation of t...

Ngày tải lên: 14/08/2014, 13:22

... Manufacturing Systems 14 2.3 Analytical Models for Performance Evaluation of Multistage Manufacturing Systems 18 2.4 Analytical Studies of Manufacturing Systems with Unreliable Machines ... pertaining to performance evaluation of multistage manufacturing systems is presented in Chapter In Chapter 3, multistage manufacturing systems with machine de...

Ngày tải lên: 11/09/2015, 09:16

... this study and recommendation for future work are given 17 Chapter High- resolution Methods for Multi- fluid Flows with Stiffened Gas Equation of State In this chapter1 , high- resolution methods are ... construct high- resolution methods with AMR, which are very robust and stable Chapter 1.2.3 Introduction and Literature Review Flows Involving Barotropic Compone...

Ngày tải lên: 14/09/2015, 08:44

... Chapter Introduction The modern information technology consists of three parts: information acquiring, information processing, information transferring and information storage In fact, information ... Exploration of In- Situ Diagnosis Methods for the Evaluation of Mechanical and Magnetic Performance of Hard Disk Drives ZHU JIN （B.Eng (hons) HUST, P....

Ngày tải lên: 05/10/2015, 22:15