lab 4-8 inter-area & external route summary

Lab 9.3.5 Troubleshooting Routing Issues with show ip route and show ip protocols

Lab 9.3.5 Troubleshooting Routing Issues with show ip route and show ip protocols

... 3.0 - Lab 9.3.5 Copyright  2003, Cisco Systems, Inc. Lab 9.3.5 Troubleshooting Routing Issues with show ip route and show ip protocols Objective ã Use the show ip route and show ip ... Examine the routing table a. After an unsuccessful ping, check the routing table with the show ip route command. From the Gadsden router, type...
Ngày tải lên : 23/10/2013, 00:15
  • 6
  • 333
  • 1
Configure an External Router to Route Inter-VLAN Traffic

Configure an External Router to Route Inter-VLAN Traffic

... interface connected to the router to trunk with the router. You may recall that the router is already set to trunk with the VLAN subinterfaces. The default is ISL and therefore the command switchport ... represents a router here). 2. The first router to be configured will be the ISP router. Access the router through the console port and then enter privileged mode....
Ngày tải lên : 23/10/2013, 00:15
  • 9
  • 528
  • 1
Interior Route Redistribution Lab

Interior Route Redistribution Lab

... Interior Route Redistribution by Ronald Trunk Lab Scenario Discussion Incomplete Router Configurations Helpful Hints Solution Lab Scenario Please refer to Figure 1. The challenges of this lab ... the routers from the remaining address space, using a 24-bit mask. 3. Mutually redistribute routes between the domains. OSPF routes should be given a metric of 6 in the RIP domain. RIP...
Ngày tải lên : 27/10/2013, 07:15
  • 2
  • 146
  • 0
Lab 9.3.5 Troubleshooting Routing Issues with show ip route and show ip Protocols

Lab 9.3.5 Troubleshooting Routing Issues with show ip route and show ip Protocols

... Lab 9.3.5 Troubleshooting Routing Issues with show ip route and show ip Protocols Router Designation Router Name FastEthernet 0 Address Interface ... the routing table a. After an unsuccessful ping, check the routing table with the show ip route command. From the Gadsden router, type the following: GAD #show ip route 2 - 6 CCNA...
Ngày tải lên : 27/10/2013, 07:15
  • 6
  • 419
  • 0
Tài liệu Route Optimization Challenge Lab doc

Tài liệu Route Optimization Challenge Lab doc

... v2.0 - Lab 7.6.1 Copyright  2001, Cisco Systems, Inc. Implementation Requirements ã All RIPv2 networks will be redistributed into OSPF. Summarize, if appropriate. ã Use default routes ... ã SanJose1 will always be the DR in the core network. ã Minimize the number of routes exchanged between core routers. Implementation Completion Tests ã Successful pings from all hosts ... ap...
Ngày tải lên : 21/12/2013, 19:15
  • 2
  • 192
  • 0
Tài liệu Lab 9.1.1 Using Show IP Route to Examine Routing Tables doc

Tài liệu Lab 9.1.1 Using Show IP Route to Examine Routing Tables doc

... Systems, Inc. Lab 9.1.1 Using Show IP Route to Examine Routing Tables Objective ã Setup IP an addressing scheme using class B networks. ã Configure RIP and IGRP on routers. ã Examine the impact ... _________________________________________________ d. Stop the debug with no debug ip rip. Step 5 Show the routing tables for each router a. Examine t...
Ngày tải lên : 18/01/2014, 05:20
  • 6
  • 424
  • 0
Tài liệu Lab 9.1.1 Using Show IP Route to Examine Routing Tables ppt

Tài liệu Lab 9.1.1 Using Show IP Route to Examine Routing Tables ppt

... 6 CCNA 2: Routers and Routing Basics v 3.0 - Lab 9.1.1 Copyright  2003, Cisco Systems, Inc. Lab 9.1.1 Using Show IP Route to Examine Routing Tables Router Designation Router Name ... _________________________________________________ d. Stop the debug with no debug ip rip. Step 5 Show the routing tables for each router a. Examine the rout...
Ngày tải lên : 18/01/2014, 05:20
  • 6
  • 362
  • 0
Tài liệu Lab 9.1.8 Last Route Update docx

Tài liệu Lab 9.1.8 Last Route Update docx

... 1 - 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 9.1.8 Copyright  2003, Cisco Systems, Inc. Lab 9.1.8 Last Route Update Objective ã Gather information about routing updates and routing ... The router is ready for the assigned lab to be performed. 5 - 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 9.1.8 Copyright  2003, Cisco Systems, Inc. Router Interfa...
Ngày tải lên : 24/01/2014, 19:20
  • 5
  • 254
  • 0
Tài liệu C++ Lab 4 Review, Summary & Building Skill Dr. John Abraham Professor, UTPA docx

Tài liệu C++ Lab 4 Review, Summary & Building Skill Dr. John Abraham Professor, UTPA docx

... cout <<endl << "The area of the circle is: " << area << "cm²" <<endl; cout <<"The perimeter of the circle is: " <<perimeter ... file used? 2.7. What is the purpose of sizeof()? Lab 4 Review, Summary & Building Skill Dr. John Abraham Professor, UTPA You learned quite a bit over...
Ngày tải lên : 20/02/2014, 08:20
  • 4
  • 321
  • 0
CCNP ROUTE lab manual

CCNP ROUTE lab manual

... 1587133032 _CCNP_ ROUTE_ Student.indb 30 10/20/10 2:26 PM CCNP ROUTE Lab Manual vi About This Lab Manual This is the only authorized Lab Manual for the Cisco Networking Academy CCNP version 6 ROUTE ... 11 00:02:01 5 200 0 6 1587133032 _CCNP_ ROUTE_ Student.indb 17 10/20/10 2:26 PM CCNP ROUTE Lab Manual 12 Router Interface Summary Table Router Interface Summary...
Ngày tải lên : 30/05/2014, 13:52
  • 384
  • 1.2K
  • 0
lab 4-8 inter-area & external route summary

lab 4-8 inter-area & external route summary

... Lab 4-8: INTER-AREA & EXTERNAL ROUTE SUMMARY Mô tả Cisco cho phép các địa chỉ tóm tắt, để tiết kiệm tài nguyên hạn chế số lượng route quảng cáo giữa các vùng. ... các router ABR RouterB, RouterC có thể thu gọn các mạng thành một mạng 152.1.1.0/24, thêm các lệnh sau trong tiến trình OSPF trên các router. RouterB(config)#router ospf 64 RouterB(config-router)#area ... 255.255...
Ngày tải lên : 16/11/2014, 19:45
  • 7
  • 170
  • 0
lab 6-3 sử dụng route-map

lab 6-3 sử dụng route-map

... configure, ta sử dụng các lệnh như sau: ISP2(config) #route-map ospf-to-rip deny 10 ISP2(config -route-map) #match tag 200 ISP2(config -route-map) #route-map ospf-to-rip permit 20 Sử dụng route-map ospf-to-rip ... Lab 6-3: SỬ DỤNG ROUTE-MAP Mô tả Bài thực hành này hướng dẫn cách sử dụng lệnh route-map trong quá trình phân phối route giữa các giao ... ISP2 và sử dụng...
Ngày tải lên : 16/11/2014, 19:45
  • 17
  • 480
  • 1
lab 8-4 bgp route reflector và route filter

lab 8-4 bgp route reflector và route filter

... Lab 8-4: BGP ROUTE REFLECTOR VÀ ROUTE FILTER Mô tả Trong bài thực hành này, chúng ta sẽ cấu hình IBGP giữa các router sử dụng route reflector và cấu hình route filter đơn giản Mạng ... trò là một route reflector server: SaiGon3(config)#router bgp 100 SaiGon3(config-router)#neighbor 192.168.1.5 route- reflector- client SaiGon3(config-router)#neighbor 172.24.1.18...
Ngày tải lên : 16/11/2014, 19:45
  • 13
  • 466
  • 1
lab 1-3 cấu hình nat động dùng route-map để kiểm soát nat

lab 1-3 cấu hình nat động dùng route-map để kiểm soát nat

... Lab 1-3: CẤU HÌNH NAT ĐỘNG DÙNG NHIỀU DÃY ĐỊA CHỈ VÀ DÙNG ROUTE- MAP ĐỂ KIỂM SOÁT QUÁ TRÌNH NAT Mô tả Trong bài thực hành này, chúng ta sẽ cấu hình NAT động với nhiều dãy địa ... Trước khi cấu hình route map, ta bỏ một vài lệnh đã cấu hình trước như sau : SanJose1#undebug ip nat SanJose1#clear ip nat translation * SanJose1#configure terminal SanJose1(config)#no ip...
Ngày tải lên : 16/11/2014, 19:46
  • 11
  • 533
  • 4