standard specification for curing concrete
ASTM a106 2004 standard specification for seamless
... oflengths),
3 For referenced ASTM standards, visit the ASTM website, www .astm. org, or
contact ASTM Customer Service at service @astm. org. For Annual Book
of
ASTM
Standards volume information, ... Materials
49 CFR 192.113
ASTM A106: Standard Specification for Seamless
Carbon Steel Pipe for High-Temperature Service
~
A 106/A 106M - 04b
3.1.2 Name
of
material...
AIA specification for precast concrete section 34102
... Division 3 Section “Architectural Precast Concrete. ”
2. Division 3 Section “Cast-in-Place Concrete for placing connection anchors in concrete
and structural topping.
3. Division 3 Section Precast ... Owner.
23
Issue Date 9/28/04
SECTION 03410
Structural Precast Concrete
PCI GUIDE SPECIFICATION FOR STRUCTURAL PRECAST
CONCRETE
Guide Specification Development:...
ASTM D975 Standard Specification for Diesel Fuel Oils
... Specification for Diesel Fuel Oils
40 CFR 1065.701
American Society for Testing and Materials
~
Designation: D 975 - 07
'u
117
INTERNATIONAL
Standard Specification
for
Diesel Fuel Oils
1 ... Method for Ash from Petroleum
Products
) For referenced ASTM standards, visit the ASTM website, www .astm. org, or
contact
ASTM Customer Service at service @...
commentary on standard practice for design and construction of concrete silos and stacking tubes for storing gran
...
313R-1
This Commentary presents some of the considerations and assumptions of
ACI Committee 313 in developing the provisions of the Standard Practice
for Design and Construction of Concrete Silos and Stacking ... and curing
Chapter 4 Design, p. 313R-4
R4.1—Notation
R4.2—General
Commentary on Standard Practice for Design and Construction
of...
standard practice for design and construction of concrete silos and stacking tubes for storing granular materials
... protection and curing
3.8—Lining and coating
Standard Practice for Design and Construction of Concrete Silos
and Stacking Tubes for Storing Granular Materials (ACI 313-97)
ACI 313-97
Mostafa H. ... con-
crete silos and stacking tubes for storing granular materials.
Silos for storing of ensilage have different requirements and
are no...
standard practice for the use of shrinkage- compensating concrete
... re-
lieves the expansive strains caused by the initial expansion of
the shrinkage -compensating concrete.
1.3—Scope and limits
T
his standard practice is directed mainly toward the use of
shrinkage -compensating ... gage into the plastic concrete. The reinforcement prevents
further embedment of the gage, and depth of cover is indicated
by the wet concrete...
standard method for determining fire resistance of concrete and masonry construction assemblies
... thickness of flanged, ribbed, and undu-
lating panels
FIRE RESISTANCE OF CONCRETE AND MASONRY CONSTRUCTION 216.1-5
ers of concrete, concrete masonry and/ or clay masonry, de-
termine the fire resistance ... criteria of 2.2.5.1, and consisting
of two or more layers of different types of concrete, or of lay-
Fig 2.1 Fire resistance of two-layer...
standard practice for selecting proportions for normal, heavyweight, and mass concrete
... in Concrete
and Mortars
Standard Specification for Chemical
Admixtures for Use in Producing
Flowing Concrete
Standard Test Method for Temperature
of Freshly
Mixed
Portland-Cement
Concrete
Standard ... 494-86
C 496-86
Standard Practice for Concrete
Highway Bridge Deck Construction
Standard Test Method for Unit Weight
and Voids in Aggregate
Standard Method...
standard specification for cold weather concreting
... approved for use by agen-
cies of the Department of Defense and for listing in
306.1-90
the
DoD
Index of Specifications and Standards.
(Reapproved 2002)
Standard Specification for Cold Weather Concreting ... Tuthill*
Harold B. Wenzel
Arthur T. Winters
This Standard Specification gives requirements for cold weather con-
creting. It includes cold weather requir...
standard specification for curing concrete
... for Sheet Materials for
(1986) Curing Concrete
C 309-94
Standard Specification for Liquid Membrane—
Forming Compounds for Curing Concrete
C 1074-93 Practice for Estimating Concrete Strength by
the ... part of this Standard Specification.
1.4.1.1 ACI standards
306.1-90 Standard Specification for Cold Weather Con-
creting
1.4.2 ASTM standards
C 31-91 Standard...
standard specification for bonding hardened concrete, steel, wood, brick, and other amaterials
... adhesive for bonding hardened
concrete, steel, wood, brick, and other materials to
hardened concrete shall conform to all requirements
of Standard Specification for Bonding Hardened
Concrete, Steel, ... Standard Specification for Bonding Hardened
Concrete, Steel, Wood, Brick, and Other
Materials to Hardened Concrete with a
Multi-Compone...
standard specification for bonding plastic concrete to hardened concrete with a multi-component epoxy adhesive
... epoxy adhesive for bonding plastic con-
crete to hardened concrete shall conform to all re-
quirements of Standard Specification For Bonding
Plastic Concrete To Hardened Concrete with a
Multi-
Component ... procedures, materials, and performance
criteria for which alternatives are permitted or for which
provision is not made in Standard Specifica...
standard specification for latex
... 380-89
C 685-90
Standard Practice for Making and Curing
Concrete Test Specimens in the Field
Standard Specification for Concrete Aggre-
gates
Standard Specification for Portland Ce-
ment
Standard Test ... serve
to make Standard Specification
ACI
548.4 an official
part of the project specification:
The latex- modified concrete overlay shall meet the requirements of...
standard specification for producing a skid-resistant surface on concrete by the use of a multi-component epoxy s
... epoxy system skid-resistant sur-
face on concrete shall conform to all requirements of
Standard Specification for Producing a Skid-Resistant
Surface on Concrete by the Use of a Multi-Com-
ponent ... This standard specification covers the producing
of a skid-resistant surface on hardened concrete by the
application of a multi-co...
standard specification for repairing concrete with epoxy mortars (aci 503.4-92, reapproved 1997, 2003)
... Standard Specification for Repairing Concrete
with Epoxy Mortars
(ACI 503.4-92,
Reapproved 1997, 2003)
Reported by ACI Committee 503
R.W. Gaul ... mortars shall conform
to all requirements of Standard Specification for
Repairing Concrete with Epoxy Mortars
(ACI
503.4),”
published by the American Concrete Institute, De-
troit,
Mich.,
except...
Từ khóa: