design recommendations for precast concrete structures
MEASUREMENT OF ATMOSPHERIC DEPOSITION UNDER FOREST CANOPIES: SOME RECOMMENDATIONS FOR EQUIPMENT AND SAMPLING DESIGN docx
... 1990). Sampling
MEASUREMENT OF ATMOSPHERIC DEPOSITION UNDER FOREST
CANOPIES: SOME RECOMMENDATIONS FOR EQUIPMENT AND
SAMPLING DESIGN
ANNE THIMONIER
Swiss Federal Institute for Forest, Snow and Landscape ... MEASUREMENT OF ATMOSPHERIC DEPOSITION UNDER FOREST CANOPIES 377
Figure 8. Stemflow in forest stands of different tree species and ages: m...
AIA specification for precast concrete section 34102
... Division 3 Section “Architectural Precast Concrete. ”
2. Division 3 Section “Cast-in-Place Concrete for placing connection anchors in concrete
and structural topping.
3. Division 3 Section Precast ... Owner.
23
Issue Date 9/28/04
SECTION 03410
Structural Precast Concrete
PCI GUIDE SPECIFICATION FOR STRUCTURAL PRECAST
CONCRETE
Guide Specification Development:...
Design of concrete structures arthur h nilson
... w0 h0 " alt=""
formwork for concrete structures
... formwork
system for his or her project. The purpose of formwork is to safely
support the reinforced concrete until it has reached adequate strength.
Thus, formwork is a temporary support for ...
the formwork that must be constructed to form the concrete. For most
structures, more time and cost are required to make, erect, and remove
formwork than the time and cost to p...
code requirements for environmental engineering concrete structures (aci 350-01) and commentary (aci 350r-01)
... document.
CODE REQUIREMENTS FOR
ENVIRONMENTAL ENGINEERING
CONCRETE STRUCTURES (ACI 350-01)
AND COMMENTARY (ACI 350R-01)
REPORTED BY ACI COMMITTEE 350
ACI Committee 350
Environmental Engineering Concrete ... intent.
It is the function of the commentary to fill this need.
CODE REQUIREMENTS FOR ENVIRONMENTAL
ENGINEERING CONCRETE STRUCTURES
(A...
considerations for design of concrete structures subjected to fatigue loading
... intended to provide information that will
serve as a guide for design for concrete structures subjected
to fatigue loading.
ASTM 722-90
However, this report does not contain the type of detailed
design ... and
concrete subjected to flexure and axial force and for shear
reinforcement. The shear fatigue capacity of concrete beams
without shear reinforcement...
recommendations for design of beam-column connections in monolithic reinforced concrete structures
...
γ-values
shown in Table 1 assume that extensive inclined cracking
would occur in the joint. Tests indicate that initial inclined
cracking in well-confined interior joints occurs at levels of
nominal shear ... columns; confined
concrete; high-strength concrete; joints; reinforced concrete; reinforce-
ment; reinforcing steel; shear strength; shear stress.
CONTENTS
Chapter 1—Introd...
design recommendations for precast concrete structures
... 550R-1
Recommendations for the design of precast concrete structures are pre-
sented. Design of individual members and of connections for the integra-
tion of members into structures are ... to provide designs for the mem-
bers and/or connections.
PRECAST CONCRETE STRUCTURES
550R-3
The contract documents should show the loads to be con-
sidered in design of the pr...
guide for precast concrete wall panels
... Editorial subcommittee
This guide presents recommendations for precast wall panels. This guide
should be used with ACI 318 “Building Code Requirements for Reinforced
Concrete which may be legally ... designing, manufacturing, and erecting precast
concrete wall panels. Although the focus is on precast
wall panels produced in established precasting plants, site
precas...
guide for the design and construction of fixed offshore concrete structures
...
B.11- Other factors
criteria
PREFACE
Concrete structures have been used in the North Sea and
other offshore areas of the world. With the rapid expansion of
knowledge of the behavior of concrete structures ... for consideration by the designer. The
design of offshore structures requires much creativity of the
designer, and it is intended that th...
guide for the design and construction of externally bonded frp systems for strengthening concrete structures
... Design and Construction of
Externally Bonded FRP Systems for
Strengthening Concrete Structures
ACI 440.2R-02
Fiber-reinforced polymer (FRP) systems for strengthening concrete structures
have emerged ... as to
develop the strength of the FRP system. The development
length is a function of the strength of the substrate and the
rigidity of...
recommendations for design of slab-column connections in monolithic reinforced concrete structures
... Zhang
Recommendations are given for determining proportions and
details
of monolithic, reinforced concrete slab-column connections.
Included are recommendations regarding appropriate uses of
slab-
column ...
slab-
column connections in structures resisting gravity and lateral
forces,
procedures for
determination
of connection design forces, proce-
dures f...
seismic design of liquid-containing concrete structures
... 350
Environmental Engineering Concrete Structures
SEISMIC DESIGN OF LIQUID-CONTAINING CONCRETE STRUCTURES 350.3/350.3R-1
Seismic Design of Liquid-Containing
Concrete Structures (ACI 350.3-01) and
Commentary ... Provi-
sions for Seismic Design, ” in order to provide a set of
thorough and comprehensive procedures for the seismic
analysis and design of all...
design responsibility for architectural precast-concrete projects
... responsibilities for various parties of the
design/ construction team for architectural precast-concrete projects.
Keywords: Architect; architectural concrete; construction; design; design
responsibility; ... their design
responsibilities.
Key design issues for the architect—Buildings using
architectural precast panels are becoming increasingly
DESIGN RESPONSIBILIT...
development of load and resistance factor design for frp strengthening of reinforced concrete structures
...
UNIVERSITY OF CALIFORNIA, SAN DIEGO
Development of Load and Resistance Factor Design for
FRP Strengthening of Reinforced Concrete Structures
A dissertation ... Overview 1
1.2 FRPs for Strengthening of Civil Structures 1
1.2.1 Fiber Reinforced Polymer Composites 1
1.2.2 Strengthening and Repair of Civil Structures 2
1.2....