all in one cisco ccie lab study guide second edition phần 10 potx
all in one cisco ccie lab study guide second edition phần 10 potx
... Sharing
for Microsoft Networks. We see that our network card on the computer shown in Figure 24 10 is a 3Com
10/ 100 card.
Figure 24 10: Windows networking configuration
Clicking the File and Print ... Windows networking using only
the NetBEUI protocol. Workstations running only NetBEUI can be used to verify that the bridging and
DLSW labs are functioning properly.
Figure 24 10 shows the...
all in one cisco ccie lab study guide second edition phần 5 potx
... perform this lab exercise:
Two Cisco routers with one serial port•
Cisco IOS 10. 0 or higher•
A PC running a terminal emulation program•
Two Cisco DTE/DCE crossover cables•
One Cisco rolled ... routing information.
Lab #44: Passive Interface Configuration
Equipment Needed
The following equipment is needed to perform this lab exercise:
Two Cisco routers with one serial...
all in one cisco ccie lab study guide second edition phần 2 ppsx
... chap
ppp multilink
!
no ip classless
dialer−list 1 protocol ip permit ← Define interesting traffic
!
line con 0
line aux 0
line vty 0 4
password cisco
login
!
end
Monitoring and Testing the Configuration
Let's ... ISDN link. The ISDN link will be brought
up initially to exchange routing information. After initial route exchanges, the link will only be activated
when there is a change...
all in one cisco ccie lab study guide second edition phần 3 pptx
... value for traffic shaping
frame−relay mincir 100 0 ← Define a minimum CIR value for traffic shaping
!
line con 0
line aux 0
line vty 0 4
login
!
end
Monitoring and Testing the Configuration
Let's ... classless
!
!
line con 0
line aux 0
line vty 0 4
login
!
end
Monitoring and Testing the Configuration
Let's begin by connecting to the router FrameSwitch and verifying that it is wo...
all in one cisco ccie lab study guide second edition phần 4 doc
... the
backbone, a virtual link must be configured. Virtual links will be discussed later in the chapter.
All areas inject routing information into the backbone area (area 0), and the backbone propagates ... subinterface type point−to−point. A subinterface is a logical way of
defining an interface. The same physical interface can be split into multiple logical interfaces; this was
originally...
all in one cisco ccie lab study guide second edition phần 6 ppsx
... exercise:
One Cisco router with one serial interface•
One Cisco router with an Ethernet interface•
One Cisco router with two serial interfaces•
One Cisco router with one Ethernet and two serial interfaces• ... following equipment is needed to perform this lab exercise:
One Cisco router with one serial interface•
One Cisco router with one Ethernet interface•...
all in one cisco ccie lab study guide second edition phần 9 pdf
... address 10. 10.3.28 by using a ping command.
RouterA#ping 10. 10.3.28
Type escape sequence to abort.
Sending 5, 100 −byte ICMP Echos to 10. 10.3.28, timeout is 2 seconds:
!!!!!
Success rate is 100 percent ... 1 normal auto auto 10/ 100 BaseTX
5 /10 notconnect 1 normal auto auto 10/ 100 BaseTX
5/11 connected 1 normal a−half a 10 10 /100 BaseTX
5/12 connected 1 normal a−half a 10 10 /...
all in one cisco ccie lab study guide second edition phần 7 ppsx
... con 0
line 1 16
transport input all
line aux 0
transport input all
line vty 0 4
login
!
end
RouterC
version 11.2
service udp−small−servers
service tcp−small−servers
!
hostname routerc
!
interface ... address 10. 1.1.1 255.255.255.0 secondary
ip address 10. 1.1.2 255.255.255.0 secondary
ip address 10. 1.1.3 255.255.255.0 secondary → Secondary IP addresses are used
as test points...
all in one cisco ccie lab study guide second edition phần 8 ppt
... establishes and maintains sessions between an AppleTalk
client and a server.
•
Zone Information Protocol: The Zone Information Protocol maintains network number to zone
name mappings in zone information ... address of 410. 1
appletalk zone accounting ← Define the primary AppleTalk zone to be accounting
appletalk zone service ← Define the secondary AppleTalk zone to be service
appletalk...