all in one cisco ccie lab study guide second edition phần 6 ppsx

... exercise: One Cisco router with one serial interface• One Cisco router with an Ethernet interface• One Cisco router with two serial interfaces• One Cisco router with one Ethernet and two serial interfaces• ... receiving the route to network 152.1.3.0/24 . 466 One Cisco router with an Ethernet interface• One Cisco router with two serial interfaces• One Cisco ro...

Ngày tải lên: 14/08/2014, 13:20

... chap ppp multilink ! no ip classless dialer−list 1 protocol ip permit ← Define interesting traffic ! line con 0 line aux 0 line vty 0 4 password cisco login ! end Monitoring and Testing the Configuration Let's ... 192.1.5.0 255.255.255.0 1 96. 1.1.1 dialer−list 1 protocol ip permit ← Define interesting traffic ! line con 0 exec−timeout 60 0 password cisco login line aux 0 line v...

Ngày tải lên: 14/08/2014, 13:20

... con 0 line 1 16 transport input all line aux 0 transport input all line vty 0 4 login ! end RouterC version 11.2 service udp−small−servers service tcp−small−servers ! hostname routerc ! interface ... 500000 ! line con 0 line aux 0 line vty 0 4 password cisco login Monitoring and Testing the Configuration To test the configuration, ping RouterB (195.1.1.3) and, using the extended pin...

Ngày tải lên: 14/08/2014, 13:21

... value for traffic shaping frame−relay mincir 1000 ← Define a minimum CIR value for traffic shaping ! line con 0 line aux 0 line vty 0 4 login ! end Monitoring and Testing the Configuration Let's ... classless ! ! line con 0 line aux 0 line vty 0 4 login ! end Monitoring and Testing the Configuration Let's begin by connecting to the router FrameSwitch and verifying that it is work...

Ngày tải lên: 14/08/2014, 13:20

... as a subinterface type point−to−point. A subinterface is a logical way of defining an interface. The same physical interface can be split into multiple logical interfaces; this was originally created ... protocols Routing Protocol is "igrp 64 " Sending updates every 5 seconds, next due in 1 seconds Invalid after 15 seconds, hold down 15, flushed after 30 Outgoing update filter l...

Ngày tải lên: 14/08/2014, 13:20

... routing information. Lab #44: Passive Interface Configuration Equipment Needed The following equipment is needed to perform this lab exercise: Two Cisco routers with one serial port• One Cisco ... is "eigrp 64 " Outgoing update filter list for all interfaces is not set Incoming update filter list for all interfaces is not set Default networks flagged in outgoin...

Ngày tải lên: 14/08/2014, 13:20

... service tcp−small−servers ! hostname Cisco3 62 0 ! enable password cisco ← Enable Password ! no ip classless ! line con 0 password cisco ← Login Password login line aux 0 line vty 0 4 login ! 723 Let's ... 3332232 c 362 0−i−mz_113−8_T1.bin ← Single IOS image in the router's flash [33322 96 bytes used, 13444920 available, 167 772 16 total] ← 16MB flash total, 3.3MB us...

Ngày tải lên: 14/08/2014, 13:20

... procedure involves creating the tunnel interface on both routers and defining the tunnel endpoints. For this lab, the serial interfaces of both routers are the endpoints of the tunnel. The following ... engine connection active. The following is the output from the command. Notice there are two IPSec SAs: one for incoming traffic (2000) and one for outgoing traffic (2001). At this point,...

Ngày tải lên: 14/08/2014, 13:20

... establishes and maintains sessions between an AppleTalk client and a server. • Zone Information Protocol: The Zone Information Protocol maintains network number to zone name mappings in zone information ... appletalk zone accounting ← Define the primary AppleTalk zone to be accounting appletalk zone service ← Define the secondary AppleTalk zone to be service appletalk zone TopSecret ← De...

Ngày tải lên: 14/08/2014, 13:21