Failure Analysis Case Studies II Episode 1 pot

... BOLTS DETAIL 1 I SCALE 11 0 1 DETAIL 2 I SCALE 1. 10 1 PANELLING ELEVATION VIEWING FROM SOUTH I SCALE 11 5 I DETAIL 3 I SCALE 1. 10 1 SECTION A-A Fig. 1. B!C firewall: ... from the centre r (mm) HV ~TS (MW k, (MPa) 0 350 11 20 700 10 360 11 52 720 17 .5 375 12 00 750 22.5 400 12 80 800 Case 880 2 816 17 60 measured hardness at the centre...

Ngày tải lên: 13/08/2014, 15:22

... 12 14 16 PH Fig. AI. Zn02 1- h 5. c. e 0-+. Zn(0H)j passivation -+ . corrosion zn2+ - - . ._ corrosion -I - Zn immunity IIIIIIIII -2 0 2 4 6 8 10 12 14 16 ... S 316 03 0.03 2.00 1 .oo 0.045 0.030 16 .& ;18 .0 10 .0 -14 .0 2.W3.00 maximum maximum maximum maximum maximum Reprinted from Engineering Failure Analysis 4 (4), 287-29 1...

Ngày tải lên: 13/08/2014, 15:22

... at 20 "C Weight % acetone 8.0 16 .5 25.3 27 .1 84 .1 85.3 87.7 Lower layer Upper layer E NaCl Der 10 0 cm3 of solution 27 .18 23 .10 19 .32 18 .05 0.45 0.43 0.25 324 Fig. 9. Close ... shown in Figs 12 and 13 , confirms the presence of a network of crazing cracks extending into the button. Failure Analysis Case Studies II D.R.H. Jones (Editor) 0 20...

Ngày tải lên: 13/08/2014, 15:22

... 11 .5 76 1. 6 16 'En 51& quot; 635 8 50 -1 000 AISI 4 31& apos; - 12 10 -15 15 AISI 4 313 10 30 13 70 16 AISI 4 314 10 80 13 60 23 ' British standard specification BS 970 (950-1O2O0C, ... 41. 24 35.48 3.06 1. 33 0. 61 0.22 Faiilrre Analysis Case Studies 11 D.R.H. Jones (Editor) 0 200 1 Elsevier Science Ltd. All rights reserved 365 PIk...

Ngày tải lên: 13/08/2014, 16:20

... (a) ~~ 9 40 -14 0 16 5 575 10 +30 90 -13 0 62 2500 11 +27 75 -15 0 35 5500 11 +25 85 -14 5 13 5 785 12 95 -14 0 46 3800 12 +50 65 50 3400 6.9 3.8 1. 4 3.9 2.5 3.0 where Ay = pipe ... State University, 19 41. thermosetting resin) pipe. ASTM, Vol. 08.04 Plastic pipe and building products. Failure Analysis Case Studies I1 D.R.H. Jones (Editor) 8 2...

Ngày tải lên: 13/08/2014, 15:22

... 1 11 .75 x 10 .2 0.28 21. 7 Good weld, Sample 2 1 1. 8 x 10 .4 0.32 20.8 Poor weld, Sample 1 11 .6x9.8 0.20 20.7 0.30 21. 3 0. 21 20.4 Poor weld, Sample 2 11 .6~ 10 .5 0. 21 20 .1 ... Ref polymer IC1 GWM 10 1 16 4.8 16 2.2 16 3.74 16 5 .13 16 2.24 16 4 .10 16 6.73 Heat of fusion (mJ mg-') 53.48 54.85 53 .18 50 .11 49. 21 50.96 48.69...

Ngày tải lên: 13/08/2014, 15:22

... stress and strain. 6th ed. 19 89. p. 516 . [5] Lange’s Handbook of chemistry. 10 th ed. p. 11 50. [6] Peterson RE. Stress concentration factors. 19 74. Figure 12 8. p. 19 5; also in Pilkey WD Peterson’s ... Part 1) . 11 3 Baginn der Alte~ng 20 40 60 80 oc 10 0 Temperatur Fig. A5. Creep modulus of polypropylene (PP) Type 2 at 25 years (Fig. 26 from DVS 2205...

Ngày tải lên: 13/08/2014, 15:22

... Values of C, cu j=O 1 2 3 i=O i=2 i=3 i=4 1. 118 1. 405 3.8 91 8.328 -0 .17 9 -20.370 5.902 21. 895 -0.339 0 .13 0 -9.057 3.032 23. 217 -7.555 - 36.992 12 .676 13 4 Secondary initiation ... failures. TWI Research Members Report 512 /19 95, June 19 95. Failure Analysis Case Studies N D.R.H. Jones (Editor) 0 20 01 Elsevier Science Ltd. All r...

Ngày tải lên: 13/08/2014, 15:22

... Chemical analysis of three bolts Bok no. Mn S P Si Cr Mo Ni Cu AI Fe 2 0.43 0.89 0.0 21 0. 013 0.22 0.34 0.29 0. 01 0. 01 0.036 Balance 16 0.50 0.69 0.030 0. 013 0.26 0.37 0.26 0. 01 0. 01 ... Structure, 14 ,579-590 (19 91) . comet I fuselage. R&M 3248, HMSO, London, 19 62. 19 1 rear corner of the rear ADF window on Yoke Peter, and that this grew to f...

Ngày tải lên: 13/08/2014, 15:22

... Mean 15 67 502 2 310 13 0 42 19 1 17 32 630 2420 14 3 52 200 17 80 583 216 9 14 7 48 1 80 2024 575 2288 16 8 48 18 9 19 70 620 2222 16 3 51 18 4 15 82 625 215 6 13 1 52 17 9 17 76 589 22 61 14 7 ... stress (pa) (pa) (MPa) (MPa) SI 13 28 16 85 I10 I40 s2 14 08 16 28 I17 13 5 53 15 24 16 02 12 6 13 3 s4 14 52 15 97 12 1 13 2 s5 13 86 15 4...

Ngày tải lên: 13/08/2014, 15:22