Process Engineering Equipment Handbook 2009 Part 4 pdf
... better time between overhauls (TBOs). See Table C-11. The process data for the compressor in this application are as follows: FIG. C-1 04 Dimensions and performance parameters for D- and E-type ... stage reaches about -50 to 0°C only, both stages have uncooled cylinders. The process data for this compressor are: Gas CH 4 (98%) + N 2 (2%) Suction 1st 1.036 bar -106 to -160°C Discharge 1...
Ngày tải lên: 12/08/2014, 02:20
... Filsorption II process) is used for separation of submicron particles, heavy metals, and toxic hydrocarbons by a combination of filtering, “sorption,” and chemical reaction. The Wetpac ® process is ... they look good as well. A typical system is shown in Figs. A- 64 and A-65. A-62 Air Filtration; Air Inlet Filtration for Gas Turbines FIG. A -49 Drain valve. (Source: Altair Filters Internat...
Ngày tải lên: 12/08/2014, 02:20
... system. Their experience comprises various suppliers of equipment for all types of drivers and most diverse process applications. OEMs commonly offer: C-3 34 Control Systems; Controls ... Elements of Machinery, Process and Personnel,” TMC, 1992. 12. Soares, C. M., “Latest Techniques in Repair Technology,” TMC, 1990. 13. Boyce, turbomachinery course notes, 1979. 14. Soares, C. M., “Co...
Ngày tải lên: 12/08/2014, 02:20
Process Engineering Equipment Handbook 2009 Part 10 pdf
... Comments* Distillate No. 2 42 .7 (18 ,40 0) (1), (2) Kerosene (K-1) 43 .0 (18,500) (2) Jet A 43 .2 (18,600) (2) Naphtha 44 .2 (19,000) (2), (12), (13), ( 14) Condensate fuel 45 .2 (19 ,40 0) (2), (12), (13), ( 14) Methanol ... accordance with IEC 34- 5 and 34- 6, 1983. Degrees of Protection Descriptions IP 21 Protection against contact with live or moving parts inside the machine and d...
Ngày tải lên: 12/08/2014, 02:20
Process Engineering Equipment Handbook 2009 Part 16 pdf
... 200 ft to 1000 psi to 40 0°F to 3600 rpm TABLE P -42 VCR8 Pumps Design Criteria Bowl Sizes Capacity Head (per Stage) Pressure Temperature Speed SI units 300 to 45 0 mm to 47 5 m 3 /h to 60 m 70 bar ... chamber. Where process requirements allow and economy is an important factor, automatic controls and other cooling methods are often utilized. Pumps P-325 P-3 14 Pumps TABLE P -41 VCR8 Pu...
Ngày tải lên: 12/08/2014, 02:20
Process Engineering Equipment Handbook 2009 Part 20 ppt
... in, C- 343 , C- 345 hydrodynamic principle in turbocouplings and, C- 346 to C- 347 limits for, C- 345 malsynchronisation and, C- 344 Safeset coupling in, C- 344 to C-350 short circuits and, C- 344 slip ... C -41 3 thermoelectric cooling process in, C -41 8 to C -42 3 UL/CSA design standards for, C -41 8 cooling towers, C -42 3 to C -42 6, R-8 evaporative, C -42 3 to C -42 6 fans, F -4...
Ngày tải lên: 12/08/2014, 01:21
Process Engineering Equipment Handbook 2009 Part 1 ppsx
... 250 500 1000 2000 40 00 8000 3-mm steel Predicted 16 22 28 34 40 43 35 44 Measured 16 21 27 33 38 39 33 — 6-mm steel Predicted 22 28 34 40 43 35 44 53 Measured 22 27 35 39 44 37 42 — 6-mm aluminum ... Cataloging-in-Publication Data Soares, Claire. Process engineering equipment handbook / Claire Soares. p. cm. Includes index. ISBN 0-07-0596 14- X (acid-free paper) 1. Chemical...
Ngày tải lên: 12/08/2014, 02:20
Process Engineering Equipment Handbook 2009 Part 3 doc
... (kg/tonne) Fuel Wet Kiln Long Dry Kiln Preheater Precalciner Gas 9 7–9.5 5.6 1.7–3 Coal 1.5 4 2 .4 4. 6 1.5–2.8 1 .4 2 TABLE C-10 Comparison of NO x Control Technologies for Cement Kilns Annualized Cost Potential ... on a Siemens 94. 3A (turbine inlet temperature 1300°C and pressure ratio of 15–16) with a triple pressure reheat steam cycle (106 bar/30 bar /4. 5 bar) (Fig. C- 14) . Due to the...
Ngày tải lên: 12/08/2014, 02:20
Process Engineering Equipment Handbook 2009 Part 5 potx
... RIK 140 A 4, 600 4, 480 5,900 6,500 6,700 7,230 8 ,45 0 9,300 10 ,40 0 B 3,800 4, 000 4, 200 4, 400 4, 900 5,270 5,750 6,200 6,500 C 3 ,40 0 4, 100 3,700 4, 000 5,700* 6,600* 7,300* 8,100* 9,000* D 1, 840 2,250 ... 2, 040 2, 140 3,200 3,350 3,800 4, 500 5,000 E 500 560 560 630 630 630 630 710 710 a 800 900 1,000 1,100 1,200 1 ,40 0 1,600 1,800 2,000 b 300 350 40 0 45 0 500 600 700...
Ngày tải lên: 12/08/2014, 02:20
Process Engineering Equipment Handbook 2009 Part 6 pps
... value in terms of Ø Amplitude 1 1.571 1 .41 4 0.500 Average 0.637 1 0.900 0.318 value Root-mean- 0.707 1.111 1 0.3 54 square (rms) value Peak-to-peak 2.000 3. 142 2.828 1 value Ø as a guide only, as ... 0.0833 0.0328 3.28 ft/s 2 in/s 386 12.0 1 0.3937 39.37 in/s 2 cm/s 980 30 .48 2. 540 1 100 cm/s 2 m/s 9.80 0.3 048 0.02 54 0.010 1 m/s 2 Ø TABLE C-19 Conversion Factors for Rotational Veloc...
Ngày tải lên: 12/08/2014, 02:20