... Q(h) and D(h) are the amount of load that is not satisfied and demand power in h th step, respectively and H is the number of time steps (here H=8760). Renewable Energy – Trends and Applications ... level. So, some of the demand is lost and ELF index is equal to 0.5 (Fig. 11). Renewable Energy – Trends and Applications 236 In the state of charge, amoun...
Ngày tải lên: 19/06/2014, 08:20
... over the DTV band (1), and is significantly larger than in the case of narrow band cellular energy harvesting. Sustainable Energy Harvesting Technologies – Past, Present and Future 238 ... spectrums for DTV and Cellular signals are presented as shown in Fig. 1 to show on the potential for energy- harvesting in Sustainable Energy Harvesting Technologies...
Ngày tải lên: 19/06/2014, 08:20
Thermodynamics Interaction Studies Solids, Liquids and Gases Part 13 potx
... Gibbs free energy and C p isobaric heat capacity. 720 Thermodynamics – Interaction Studies – Solids, Liquids and Gases Thermodynamics – Interaction Studies – Solids, Liquids and Gases 756 surface ... inertia I = n ∑ 1 m i r 2 i , 722 Thermodynamics – Interaction Studies – Solids, Liquids and Gases Thermodynamics – Interaction Studies – So...
Ngày tải lên: 19/06/2014, 08:20
Expert Systems for Human Materials and Automation Part 13 pot
... (Juuso, 1993). Thus a compact equation for the output Z ij is: 362 Expert Systems for Human, Materials and Automation Expert Systems for Human, Materials and Automation 378 Output decisions, ... bit/s Table 1. Parameters for the simulations. 366 Expert Systems for Human, Materials and Automation 26 Expert Systems IEEE International Workshop o...
Ngày tải lên: 19/06/2014, 10:20
Power Quality Monitoring Analysis and Enhancement Part 13 potx
... compensation–unbalance at bus 30 Power Quality – Monitoring, Analysis and Enhancement 306 important power quality problems in the power distribution system. IEEE 519-1992 and IEEE 1159-1995 describe ... 0. 0132 0. 0136 0.0150 Total Power Loss (MW) 6.0795 Table 4. Three phase bus voltages for the unbalanced case.2: other degree of unbalance Power Qualit...
Ngày tải lên: 19/06/2014, 11:20
Solar Cells New Aspects and Solutions Part 13 potx
... E vac . Solar Cells – New Aspects and Solutions 414 Yan, B.; Yue, G.; Xu, X.; Yang, J.; and Guha, S. (2010). High efficiency amorphous and nanocrystalline silicon solar cells, Physica Status ... efficiency micromorph tandem silicon solar cells on glass and plastic substrates: Issues and potential. Solar Energy Materials & Solar Cells, Vol.95, No.1,...
Ngày tải lên: 19/06/2014, 11:20
TRIBOLOGY - LUBRICANTS AND LUBRICATION Part 5 potx
... Science and Engineering Technology, Vol. 30, No. 9, pp. 53 3 -5 41 Tribology - Lubricants and Lubrication 74 bearing damage by white etching crack (WEC) formation (Harada et al., 20 05; Hiraoka ... Chap. 2, pp. 6 6-7 5, College of Judea and Samaria, Ariel, Israel, September 1 1-1 5, 2006 Gegner, J.; Hörz, G. & Kirchheim, R. (1996). Hydrogen Interaction wit...
Ngày tải lên: 21/06/2014, 05:20
TRIBOLOGY - LUBRICANTS AND LUBRICATION Part 9 pot
... r 2 , 0). Tribology - Lubricants and Lubrication 160 of the presence of elastic soil the difference between the results of the analytical and finite- element calculations and the calculation ... σ t and radial σ r directions under the action of internal pressure (1) for fixing absent at the outer surface and at the contact between the the pipe and soil (1), (8)....
Ngày tải lên: 21/06/2014, 05:20
TRIBOLOGY - LUBRICANTS AND LUBRICATION Part 13 pot
... Tribology - Lubricants and Lubrication 248 Toney, M. F., Mate C. M., & Pocker, D. (1991). IEEE. Trans. mag., Vol.34, pp. 177 4-1 776, ISSN 001 8-9 464 Tribology - Lubricants and Lubrication ... 2009, pp. 749, ISBN 97 8-4 -9 90 013 9-9 -8 Tadokoro, N., Pannakarn, S., Khraikratoke S., Kamura, H., & Iwata, N. (2010). Proc. the 8th ICCG8, pp. 3...
Ngày tải lên: 21/06/2014, 05:20
TRIBOLOGY - LUBRICANTS AND LUBRICATION Part 16 potx
... 0.06M 1 5-5 pH+Cr-Ref 1 5-5 pH+Al-Bronze 1 5-5 pH+NiCrBSi 1 5-5 pH+WCCoCr 0 -1 -2 -3 -4 -5 -6 -7 -8 -9 -1 0 1 ì10 1 ì10 1 ì10 1 ì10 1 ì10 1 ì10 1 ì10 1 ì10 1 ì10 1 ì10 1 ì10 log l -0 .750 -0 .500 -0 .250 ... 4 h 1 5-5 pH+ HCP (Ref) 1 5-5 pH+Al-Bronze 1 5-5 Ph+NiCrBSi 1 5-5 pH+WCCoCr 0 10 20 30 40 50 60 70 80 90 -2 -1 0 1 2 3 4 5...
Ngày tải lên: 21/06/2014, 06:20
Lubricants and Lubrication Part 1 pot
... 316 11 .4 .13 .11 Water Content (Karl Fischer method) 316 11 .4 .13 .12 Aging Stability (Baader method) 316 11 .4 .13 .13 Aging Stability (TOST test) 317 11 .4 .13 .14 Neutralization Number 317 11 .4 .13 .15 ... 978-3-527- 314 97-3 XVIIContents 11 .4 .13 .5 Gas Solubility, Cavitation 312 11 .4 .13 .6 Air Release 314 11 .4 .13 .7 Foaming 314 11 .4 .13 .8 Demulsification 315 11 .4 .1...
Ngày tải lên: 11/08/2014, 10:22
Lubricants and Lubrication Part 6 potx
... Test Units Requirements Test Method or Standard Viscosity grade 22 32 46 68 100 ISO 3448 Biodegradability k), m) %60 6 060 6 060 ISO14593or ISO 9439 Toxicity h) Acute fish toxicity, LL 50 ,min. Acute ... activated. On the other hand, a mini- mum viscosity is required to reduce leakages and to guarantee adequate lubrication of the pump and other moving parts [11.2–11 .6] . Any change i...
Ngày tải lên: 11/08/2014, 10:22
Lubricants and Lubrication Part 9 pot
... 0.3 0 .95 0 .9 to 0.2 0.31 Hobbing; head-hight, < 1.5 m from the machinig point 40 to 3 18.1 21 to 0.2 7 .9 Grinding; head-hight, < 1.5 m from the grinding point 99 to 2 19. 4 21 to 0.2 6 .9 Automatic ... 196 1 and in the field of car- bide machining since 198 0. Health and safety studies show that the highest cobalt concentrations are found in ultra-fine dusts (1.4–3.8 lm) [14...
Ngày tải lên: 11/08/2014, 10:22
Lubricants and Lubrication Part 13 pot
... mechanical lubricants, soaps, and chemically active lubricants (Sections 17.1.1 to 17.1.4, respectively). 17 Solid Lubrication Christian Busch Lubricants and Lubrication. 2nd Ed. Edited by Th. Mang and ... Containing Solid Lubricants of black solid lubricants such as graphite and MoS 2 also have a beneficial effect on run- ning-in processes and the capacity to withstand...
Ngày tải lên: 11/08/2014, 10:22
Lubricants and Lubrication Part 14 pot
... different load, speed, and temperature conditions. Lubricants are exposed to conditions of load and speed of bearings and gears encountered in standard transmissions, and in a spray lubrication device, ... pump O and K specification 19.9 Other Standardized and Non-Standardized Test Methods and Test Machines for Lubricants In addition to the test machines and test methods...
Ngày tải lên: 11/08/2014, 10:22