The MEMS Handbook (1st Ed) - M Gad el Hak Part 4 pdf

... cells are also active areas of research. Before multiphase flow in microchannels becomes a reality, however, several fundamental problems that arise from the small dimension of the channels must ... Most of these problems originate from the large curvature of the interface between two phases in these small channels. As a result, capillary effects and other related phenomena dominate in...

Ngày tải lên: 10/08/2014, 02:21

... volume, microelectromechanical systems (MEMS) are typically constructed on the micrometer scale, with some thin layers being perhaps in the nanometer range. As has already been demonstrated by microelectronic ... microelectronic circuits, the lateral dimensions of MEMS are being pushed into the nanometer range as well. This advance has been dubbed “nanoelectromechanical sys- tems,”...

Ngày tải lên: 10/08/2014, 02:21

... Mohamed Gad- el- Hak Introduction • Flow Physics • Fluid Modeling • Continuum Model • Compressibility • Boundary Conditions • Molecular-Based Models • Liquid Flows • Surface Phenomena • Parting ... Parting Remarks 5 Integrated Simulation for MEMS: Coupling Flow-Structure-Thermal-Electrical Domains Robert M. Kirby, George Em Karniadakis, Oleg Mikulchenko, Kartikeya Mayaram...

Ngày tải lên: 10/08/2014, 02:21

... discusses molecular-based models and their relation to the continuum models previously considered. The most fundamental of the molecular models is a deterministic one. The motion of the molecules is ... containing 34 20 0- µ m- wide × 10 0- µ m- deep channels machined into the 20 0- µ m- thick stainless steel foils by the process of direct, high-precision...

Ngày tải lên: 10/08/2014, 02:21

... sensing, computation, actuation, control, communication and power generation within the same microchip. The small size, light weight and high-durability of MEMS, combined with the mass-fabrication ... super-Burnett equations), or moment methods based on taking the moments of the Boltzmann equation with flow variables (leading to Grad’s 13-moment equations or Levermore’ moment equati...

Ngày tải lên: 10/08/2014, 02:21

... slopes of the V-groove are a well-defined 54. 74 , and the actual etch rate R 111 is related to the rate of V-groove widening R v through: (16 .41 ) with R 111 the etch rate in nm/min and R v the groove ... at 80 ± 1° over 24 hours as 9 ± 0.5 m [Peeters, 19 94] . The sidewall slopes of the V-groove are a well-defined 54. 74 , and the actual etch rate R 111 is related t...

Ngày tải lên: 10/08/2014, 02:21

... W. Menz, and W. K. Schomburg, “Micropump Manufactured by Thermoplastic Molding,” Proceedings. IEEE Micro Electro Mechanical Systems (MEMS ’ 94) , Oiso, Japan, January 19 94, pp. 18–21. Desta, Y. M. , ... W. Menz, and W. K. Schomburg, “Micropump Manufactured by Thermoplastic Molding,” Proceedings. IEEE Micro Electro Mechanical Systems (MEMS ’ 94) , Oiso, Japan, January 19 94, pp. 18–21. Des...

Ngày tải lên: 10/08/2014, 02:21