Robot Manual Full With Electronic Part 12 potx

... 11 D4 1010 10 D3 999 D2 10 3 8 3 3 9 5 22 2 21 4 20 12 4 13 2 14 5 15 1 16 12 17 15 18 14 19 13 23 1 24 12 25 15 26 14 27 13 11 5 2 413141 5121 676767 Enable Motor 1 Direction A Direction B Motor ... E1 6811 Port E3 6811 Port E2 2 4 210 10 2 12 10 3 1 6 3 11 1 14 3 14 3 11 1 6 3 3 1 4 3 2 16 8 816 12 13 15 9 7 11 15 15 1 6 7 3 16 9 1 5 19 9 2 1 5413 12 13 12 5 4 13 8 14 7 17...

Ngày tải lên: 10/08/2014, 02:21

... The 6.270 Robot Builder’s Guide Project Conceived and Developed by: Fred Martin, Pankaj Oberoi, and Randy Sargent This Document Created by: Fred Martin for the 1992 M.I.T. LEGO Robot Design

Ngày tải lên: 10/08/2014, 02:20

... solder into the soldering iron rather than the joint, the solder will ball up, refusing to bond with the improperly heated PC board pad.

Ngày tải lên: 10/08/2014, 02:20

... (+) Tip is negative (-) Heat-shrink tubing RED WIRE BLACK WIRE DC Power Plug Plug Cover ‘‘Use 12 to 16 inches of wire’’

Ngày tải lên: 10/08/2014, 02:20

... or heat gun

Ngày tải lên: 10/08/2014, 02:20

... length. 1 and 2/3 vertical units 2 horizontal units

Ngày tải lên: 10/08/2014, 02:20

... w1 h1" alt="" 8-tooth gear 24-tooth gear full- size stop bush 2x4 flat LEGO plate Sample LEGO Gearbox Design TOP VIEW Output Shaft plug motor to mesh with this gear This gearbox uses only the

Ngày tải lên: 10/08/2014, 02:20

... ya w3 h8" alt=""

Ngày tải lên: 10/08/2014, 02:20

Ngày tải lên: 10/08/2014, 02:20

... solder into the soldering iron rather than the joint, the solder will ball up, refusing to bond with the improperly heated PC board pad.

Ngày tải lên: 10/08/2014, 02:20