Bishop, Robert H - The Mechatronics Handbook [CRC Press 2002] Part 1 pps

... I wish to express my heartfelt thanks to all the contributing authors. Taking time in otherwise busy and hectic schedules to author the excellent articles appearing in the Mechatronics Handbook ... January 9, 2002 11 :38 AM ©2002 CRC Press LLC 1 What is Mechatronics? 1. 1 Basic Definitions 1. 2 Key Elements of Mechatronics 1. 3 Historical Perspective 1. 4 The...

Ngày tải lên: 10/08/2014, 01:22

... switching at high frequency; if the ground point of the high energy side of the circuit is directly connected to the ground of the low energy side of the circuit, switching noise may propagate through ... from the positive terminal to the negative terminal. The supply is through the brushes, which make contact with the commutator segments. From Faraday’s laws of electrom...

Ngày tải lên: 10/08/2014, 01:22

... falls to a particularly low value FIGURE 20.59 The shunt-wound motor load characteristics. FIGURE 20.60 The shunt-wound torque–speed characteristics. FIGURE 20. 61 The series-wound motor. Applied ... falls to a particularly low value FIGURE 20.59 The shunt-wound motor load characteristics. FIGURE 20.60 The shunt-wound torque–speed characteristics. FIGURE 20. 61...

Ngày tải lên: 10/08/2014, 01:22

... to hold constant the value of the signal being converted. At the instance the sample is to be taken, the T /H holds the sample value even if the signal is still changing. Once the conversion has ... of the transducer (the measurement) is not linear, it is linearized by the signal conditioner.] The element of the transducer which senses the controlled output is call...

Ngày tải lên: 10/08/2014, 01:22

... with an electron is rather small. This, of course, has to do with the size of the unit we use to measure charge, the coulomb (C), named after Charles Coulomb. However, the definition of the ... chapter. The fundamental electric quantity is charge , and the smallest amount of charge that exists is the charge carried by an electron, equal to (11 .1) As you can see,...

Ngày tải lên: 10/08/2014, 01:22

... either voltage or current sources and (respectively) either FIGURE 11 .24 Basic principle of mesh analysis. FIGURE 11 .25 Use of KVL in mesh analysis. FIGURE 11 .26 One-port network. 0066_Frame_C 11 ... either voltage or current sources and (respectively) either FIGURE 11 .24 Basic principle of mesh analysis. FIGURE 11 .25 Use of KVL in mesh analysis. FIGURE 11 .26 One-port network. 00...

Ngày tải lên: 10/08/2014, 01:22

... 10 -1 1 to 5 × 10 -1 2 5 × 10 -1 1 to 5 × 10 -1 2 1 × 10 -1 2 Noise floor, σ y ( τ ) 1 × 10 -9 ( τ = 1 to 10 2 s) 1 × 10 -1 2 ( τ = 1 to 10 2 s) 1 × 10 -1 2 ( τ = 10 3 to 10 5 s) 1 × 10 -1 4 ( τ ... 10 -1 0 to 5 × 10 -1 2 5 × 10 -1 2 to 1 × 10 -1 4 1 × 10 -1 2 to 1 × 10 -1 3 Warm-Up pe...

Ngày tải lên: 10/08/2014, 01:22