Engineering Statistics Handbook Episode 6 Part 11 ppsx
Process Engineering Equipment Handbook Episode 3 Part 11 ppsx
... in, C- 161 to C- 162 rotors in, C- 160 seals in, C-342 servomotors in, C- 161 to C- 162 shaft seals in, C- 162 to C- 163 size vs. performance of, C-154 to C-158 solid coupling in, C- 164 to C- 165 stator ... E-32 expansion joints and, E -60 , E -66 generators and turbogenerators, G -6, G-10 to G -11 MICAFOLD, G -6 MICAREX, G-5 insulation pillows, expansion joints and, E -65 to E -66...
Ngày tải lên: 21/07/2014, 16:21
Process Engineering Equipment Handbook Episode 3 Part 5 ppsx
... 0.80 15.3 1.2 8 .6 0.83 0.08 14.3 0.90 1 .6 0.01 1.5 0.01 0.9 0.00 0.00 1.4 0.01 0 .6 0. 06 0.5 0.02 0.3 0.02 0.09 0.5 0.03 13.3 1.8 12.7 0.94 10.3 0. 06 0.84 12.9 0 .66 36. 1 7 .6 36. 6 7.2 20.5 1.7 1.3 ... 99.9 00000 00000 00000 00000 00000 7.2 11. 5 13.3 7.1 71.9 8.8 9.0 12.5 7.9 74.3 Existing 6. 7 + Expanded 2.1 Existing 6. 9 + Expanded 2.1 New New Existing 49.7 + Expanded 4.2...
Ngày tải lên: 21/07/2014, 16:21
Process Engineering Equipment Handbook Episode 2 Part 10 ppsx
... industrial high-speed-gear unit. See Table P -6. K s c £ - ¥ () ¥ - 10 1 11 4 2 . SF = ¥ ¥ 1 26 000,hp Nd p K W Fd R R t =¥ + 1 Ks CC c om = < ¥ [] ¥ - 10 1 56 4 2 . P- 76 Power Transmission Power Transmission ... the back-to-back test bed: Nominal power: P = 30,000 kW Nominal speed: n = 63 80/15,574 rpm Overspeed 120%: n = 765 6/18 ,68 9 rpm Nominal pitch line velocity: v = 200...
Ngày tải lên: 21/07/2014, 16:22
Process Engineering Equipment Handbook Episode 2 Part 3 ppsx
... voltage is varied directly with the frequency. For instance, a 460 -volt controller would normally be adjusted to provide 460 volts output at 60 Hz and 230 volts at 30 Hz. A controller would typically ... residual TBA was 65 ppm. Schott Glaswerke has a patent on using TBA to prepare a high purity glass powder with a mean particle size of less than 10 mm. Glass powders having a particle size...
Ngày tải lên: 21/07/2014, 16:22
Process Engineering Equipment Handbook Episode 3 Part 6 ppsx
... 12≤ A Face-to-face 17≤ 20≤ 24≤ 26 30≤ 34≤ 38≤ B Approximate overall height 36 38≤ 47≤ 49 1 / 2 ≤ 52 1 / 2 ≤ 60 ≤ 63 ≤ C Body length, seam-to-seam 29≤ 30≤ 36 38≤ 40≤ 46 48≤ D Top head seam centerline inlet ... S-23 Mist particle removal chart. (Source: Peerless.) TABLE S-2 Vane-Type Separators Body Diameter (O.D.) 6 5 / 8 ≤ 8 5 / 8 ≤ 12 3 / 4 ≤ 14≤ 16 18≤ 20≤ In and out line sizes 2≤ 3≤ 4≤...
Ngày tải lên: 21/07/2014, 16:21
Handbook of Corrosion Engineering Episode 2 Part 11 ppsx
... natural material, the skeletons of diatoms, used as a filter medium. Glossary 963 0 765 162 _AppB_Roberge 9/1/99 6: 51 Page 963 Gibbs free energy Thermodynamic function; also called free energy, free enthalpy, ... observed in copper-nickel alloys after extended service in fresh water. 962 Appendix B 0 765 162 _AppB_Roberge 9/1/99 6: 51 Page 962 standard electrode potential The reversibl...
Ngày tải lên: 05/08/2014, 09:20
Process Engineering Equipment Handbook Episode 2 Part 6 potx
... available from 2 in (51 mm) to 48 in (1219 mm) shell diameter. Unit is 42 in (1 066 mm) shell diameter. (Source: Armstrong Engineering Associates.) FIG. H-28 Bottom bundles are sheathed element heater. ... bundle. (Source: Armstrong Engineering Associates.) H-22 Heaters, Electric FIG. H-40 16, 000 kW Dowtherm heater in west coast U.S. chemical plant. (Source: Armstrong Engineering Assoc...
Ngày tải lên: 21/07/2014, 16:22
Process Engineering Equipment Handbook Episode 1 Part 6 pot
... are: Gas CH 4 (98%) + N 2 (2%) Suction 1st 1.0 36 bar -1 06 to - 160 °C Discharge 1st 2.9 bar - 36 to -97°C Suction 2nd 2.9 bar -33 to -93°C Discharge 2nd 6. 8 bar -45 to +35°C Maintenance report on these ... on compressor performance emerges. See Figs. C -111 through C -113 . Dynamic crank throw behavior. This remains a subject of investigation. Compressor parts are not entirely rigid, b...
Ngày tải lên: 21/07/2014, 16:22
Handbook of Mechanical Engineering Calculations ar Episode 2 Part 8 ppsx
... depth of 20 ft (6 m), it would have an annual required area of 1 363 .6 ϫ 27 ft 3 /yd 3 ϭ 36, 817.2 ft 3 /20 ft high ϭ 1840.8 ft 2 (171.0 m 2 ), or 1840.9 ft 2 /43, 560 ft 2 /acre ϭ 0.042 acre ( 169 .9 m 2 ; ... 0.35(15 .61 m) ϩ 0. 067 [27.5 m Ϫ 3(5 m)] ϭ 6. 3 m (20.7 ft); v d ϭ 0.7(5.0 m) ϩ 0. 067 [27.5 m Ϫ 3(5 m)] ϭ 4.34 m. Then, the ambient concentration for chlorine can be found from...
Ngày tải lên: 05/08/2014, 09:20
Handbook of Mechanical Engineering Calculations ar Episode 3 Part 2 ppsx
... to its life in hours, h, by the expression R L ϭ 60 Rh /10 6 , where R ϭ shaft speed, r /min. Solving gives h ϭ 10 6 R L / (60 R) ϭ (10 6 )( 162 )/ [ (60 )(1000)] ϭ 2700-h minimum life. Related Calculations. ... p i2 ϭ 320,000 / 560 ϭ 571 lb / in 2 (3937.0 kPa). For h k ϭ 0.0 06 in (0.152 mm), L s1 ϭ 0.0205 / (0.0 06) 3 ϭ 95,000 lb (422,581.1 N). Then p i1 ϭ 95,000/ 560 ϭ 169 .6, say...
Ngày tải lên: 05/08/2014, 09:20