Program C Ansi Programming Embedded Systems in C and C++ phần 5 ppsx

Programming Embedded Systems in C and C ++ docx

... Programming Embedded Systems in C and C+ + - 44 - you should see is the C source code for main, with a cursor indicating that the embedded processor's instruction pointer is at the entry point ... initial breakpoint at main and instruct the debug monitor to execute the program until that point is reached. So the next thing Programming Embedded Systems in C and C+ + - 10 - Personal Comments ... Working with Serial Ports 142 9 .5 The Zilog 852 30 Serial Controller 149 Chapter 10. Optimizing Your Code 151 10.1 Increasing Code Efficiency 151 10.2 Decreasing Code Size 154 10.3 Reducing...

The 8051 microcontroller and embedded systems using assembly and c 2nd ed

...  8 051 Hardware Connection and Hex File  8 051 Timer/Counter Programming in Assembly and C  8 051 Serial Port Programming in Assembly and C  Interrupts Programming in Assembly and C  ... 8 051 Interfacing to External Memory  8 051 Real World Interfacing I: LCD,ADC AND SENSORS  LCD and Keyboard Interfacing  8 051 Interfacing with 8 255 Department of Computer Science and ... 8 051 Assembly Language Programming  Branch Instructions  I/O Port Programming  8 051 Addressing Modes  Arithmetic & Logic Instructions And Programs  8 051 Programming in C ...

Tài liệu Programming Embedded Systems II pptx

... Shared-clock scheduling 154 Overview of this seminar 155 Review: What is ‘RS-232’? 156 Review: Basic RS-232 Protocol 157 Review: Transferring data to a PC using RS-232 158 PATTERN: SCU SCHEDULER ... One-Shot ADC 45 PATTERN: One-Shot ADC 46Using a microcontroller with on-chip ADC 47Using an external parallel ADC 48Example: Using a Max 150 ADC 49Using an external serial ADC 51 Example: Using an ... using PID and CAN 251 Overview of this seminar 252 Single-processor system: Overview 253 Single-processor system: Code 254 Multi-processor design: Overview 255 Multi-processor design: Code (PID...

Tài liệu Programming Embedded Systems II doc

... requires TWO consecutive instructions on 8 0c5 15 / 8 0c5 05 - to avoid accidental triggering. E.g: PCON |= 0x01; PCON |= 0x20; */ } COPYRIGHT © MICHAEL J. PONT, 2001-2007. Contains material ... 8 051 DevicePort 2VccULN2803A9P2.0 - Pin 8P2.1 - Pin 7P2.2 - Pin 6P2.3 - Pin 5 P2.4 - Pin 4P2 .5 - Pin 3P2.6 - Pin 2P2.7 - Pin 1Pin 11 - LED 0Pin 12 - LED 1Pin 13 - LED 2 Pin 14 - ... enter critical section// - Wait for lock to become clear// (FOR SIMPLICITY, NO TIMEOUT CAPABILITY IS SHOWN)while(Lock == LOCKED);// Lock is clear// Enter critical section// Set the lockLock...

Tài liệu Programming Embedded Systems II ppt

... Max 150 ADC 49Using an external serial ADC 51 Example: Using an external SPI ADC 52 Overview of SPI 53 Back to the example … 54 Example: Using an external I2 C ADC 55 Overview of I 2C 56 Back ... 30Reducing power consumption/* */void SCH_Go_To_Sleep() { PCON |= 0x01; /* Enter idle mode (generic 8 051 version) */ /* Entering idle mode requires TWO consecutive instructions on 8 0c5 15 / ... using a modern, high-level programming language ( C ), and 3. Understand more about the effect that software design and programming designs can have on the reliability and safetyof multi-processor...

Programming Embedded Systems I pot

... /26000)/(OSC_PER_INST)))#define T _50 micros_H (T _50 micros / 256 )#define T _50 micros_L (T _50 micros % 256 ) /* Define initial Timer 0 / Timer 1 values for ~10 msec delay */#define T_10ms ( 655 36 - ... performancethat a modern 8 051 device can provide.• The electromagnetic interference (EMI) generated by acircuit increases with clock frequency.• In most modern (CMOS-based) 8 051 s, there ... 57 The need for pull-up resistors 58 Dealing with switch bounce 59 Example: Reading switch inputs (basic code) 61Example: Counting goats 68Conclusions 74Preparation for the next seminar 75 VISeminar...

Programming Embedded Systems II pot

... microcontrollers have support for CAN?Available devices include:• Dallas 8 0c3 90. Two on-chip CAN modules, eachsupporting CAN 2.0B.• Infineon C5 0 5C. Supports CAN2.0B.• Infineon C5 1 5C. Supports ... AT89S531234 5 6789181716 15 1413121110MCP 251 0RxTxSI SCKSO/CS/RSTVccOSC11234876 5 PCA8 2C2 50 CANLCANHRXDTXDTo CAN bus12 MHz/INT[Note: code for this hardware will be discussed in Seminar 6] C OPYRIGHT © MICHAEL ... - Pin 5 P2.4 - Pin 4P2 .5 - Pin 3P2.6 - Pin 2P2.7 - Pin 1Pin 11 - LED 0Pin 12 - LED 1Pin 13 - LED 2 Pin 14 - LED 3Pin 15 - LED 4 Pin 16 - LED 5 Pin 17 - LED 6 Pin 18 - LED 7For 25mA...

Programming Embedded Systems I ppt

... 146 Introducing sEOS 147 Introducing sEOS 148 Tasks, functions and scheduling 153 Setting the tick interval 154 Saving power 157 Using sEOS in your own projects 158 Is this approach portable? ... Central-heating controller 11 Reading from (and writing to) port pins 12 SFRs and ports 13 SFRs and ports 14 Creating and using sbit variables 15 Example: Reading and writing bytes 16 Creating ... VISeminar 4: Adding Structure to Your Code 77 Introduction 78 Object-Oriented Programming with C 79 Example of “O-O C 82 The Project Header (Main.H) 85 The Port Header (Port.H) 92 Re-structuring...

NEW TRENDS IN QUANTUM SYSTEMS IN CHEMISTRY AND PHYSICS ppt

... istry and chemical physics. Progress in Theoretical Chemistry and Physics A series reporting advances in theoretical molecular and material sciences, including theoretical, mathematical and ... molecular and related species and processes arising in chemical systems. The book series Progress in Theoretical Chemistry and Physics aims to report advances in methods and applications in ... geometric and electronic structures of molecular assemblies and polymers, clusters and crystals; surface, interface, solvent and solid-state effects; excited-state dynamics, reactive collisions, and...

particulate systems in nano- and biotechnologies, 2009, p.426

... Thermo Systems Incorporated, Micromeritics, Particle Measuring Systems (with the acquired Royco and HIAC businesses), Quantachrome Corporation, and Microtrac.Consulting activities continue through ... GidaspowResearch Interests:Colloid and Interface Science: Inter-particle force measurement and modeling and colloid stability.Simulation of Flow: In circulating, bubbling, and rotating uidized ... inorganic and organic composites, optical, magnetic and electrical systems adhesion and coagulation.Thin Films and Coatings: Coated particles and bers, chemical vapor deposi-tion, adhesion.center...

Xem thêm