... packing,
and marking shall be conducted in accordance with Methods
C 50.
9. Keywords
9.1 animal; feed; limestone; mineral; supplement
1
This specification is under the jurisdiction of ASTM Committee ... edition C 706 – 92.
2
Annual Book of ASTM Standards, Vol 04.01.
3
Annual Book of ASTM Standards, Vol 14.02.
TABLE 1 Chemical Requirements
Limestone
Classes
(See C 51)
Cal...
... of Acid Value to Basicity Factor—
Calculate the acid value-basicity factor relationship as follows:
Acid value
Basicity factor
3 0.7691
5 lime or limestone product ~kg! per litre of Acidic Waste.
N
OTE ... contacting ASTM at the above address or at
61 0-8 3 2-9 585 (phone), 61 0-8 3 2-9 555 (fax), or service @astm. org (e-mail); or through the ASTM website (www .astm. org).
C...
... Block
3
C 59 Specification for Gypsum Casting and Molding Plas-
ter
2
C 61 Specification for Gypsum Keene’s Cement
2
C 79 Specification for Gypsum Sheathing Board
2
C 317 Specification for Gypsum Concrete
2
C ... Gypsum Plasters
2
C 35 Specification for Inorganic Aggregates for Use in
Gypsum Plaster
2
C 36 Specification for Gypsum Wallboard
2
C 37 Specification for Gy...
... Hydraulic
Cement
2
C 670 Practice for Preparing Precision and Bias Statements
for Test Methods for Construction Materials
3
C 1005 Specification for Weights and Weighing Devices for
Use in the Physical ... use.
2. Referenced Documents
2.1 ASTM Standards:
C 109 Test Method for Compressive Strength of Hydraulic
Cement Mortars (Using 2-in. or 50-mm Cube Specimens)
2
C 114 Te...
... by contacting ASTM at the above address or at
61 0-8 3 2-9 585 (phone), 61 0-8 3 2-9 555 (fax), or service @astm. org (e-mail); or through the ASTM website (www .astm. org).
FIG. 1 Vicat Apparatus
C 187
2
... Keywords
9.1 consistency; normal consistency; Vicat needles
For additional useful information on details of cement test methods, reference may be made to the “Manual of...
... use.
2. Referenced Documents
2.1 ASTM Standards:
C 911 Specification for Quicklime, Hydrated Lime, and
Limestone for Chemical Uses
2
E 77 Test Methods for the Inspection and Verification of
Thermometers
3
IEEE /ASTM ... Thermostatically control the air temperature within
1
This specification is under the jurisdiction ofASTM Committee C- 1 on Cement
and is the direct responsibility...
... Certification
9.1 When specified in the purchase order a producer’s or
supplier’s certification shall be furnished to the purchaser that
the material is in compliance with this specification.
10. Packaging ... be obtained by contacting ASTM at the above address or at
61 0-8 3 2-9 585 (phone), 61 0-8 3 2-9 555 (fax), or service @astm. org (e-mail); or through the ASTM website (www .ast...
... Cement
2
C 305 Practice for Mechanical Mixing of Hydraulic Cement
Pastes and Mortars of Plastic Consistency
2
C 490 Practice for Use of Apparatus for the Determination
of Length Change of Hardened Cement ... of
Hydraulic Cement Mortars (Using 2-in. or 50-mm Cube
Specimens)
2
C 157 Test Method for Length Change of Hardened Hy-
draulic Cement Mortar and Concrete
3
C 219 Terminol...
... be obtained by contacting ASTM at the above address or at
61 0-8 3 2-9 585 (phone), 61 0-8 3 2-9 555 (fax), or service @astm. org (e-mail); or through the ASTM website (www .astm. org).
C 206
2
... of the responsible
technical committee, which you may attend. If you feel that your comments have not received a fair hearing you should make your
views known to the ASTM Committee...
... described in
Practice C 670.
PMMA cover plate with O-ring seal
Vacuum source connection
12-in. (305-mm) high by 12-in. inside diameter vacuum
chamber (aluminum, PMMA, or other suitable mate-
rial)
Connection ... friction lids) to prevent loss of moisture. Place the
specimens in the sealed containers carefully in a room or
cabinet with forced-air circulation maintained at 100 6 3°F (38
6 2 C...