Part 1 Code of practice for dead and imposed loads doc

... 11 NOTE 1. Designated stadia are those requiring a safety certificate under the Safety of Sports Ground Act 19 75.  BSI 19 96 1 BS 6399 : Part 1 : 19 96 Code of practice 1 Scope 1. 1 This Part of ... 6399 : Part 1 : 19 96  BSI 19 96 i Contents Page Committees responsible Inside front cover Foreword ii Code of practice 1 Scope 1 2 References 1 3 D...

Ngày tải lên: 08/07/2014, 22:20

... 11 0 4 .15 Web openings 11 2 4 .16 Separators and diaphragms 11 4 4 .17 Eccentric loads on beams 11 4 Section 5. Continuous structures 11 5 5 .1 General 11 5 5.2 Global analysis 11 6 5.3 Stability out -of- plane ... 355 or S 460 15 0 63 — BS EN 10 137-2 S 460 — 15 0 — BS EN 10 155 J0WP or J2WP 40 16 — J0W, J2W or K2W 10 0 10 0 — BS EN 10 210 -1 All — — 65 BS EN 10 219 -1...

Ngày tải lên: 08/07/2014, 22:20

... 12 7.0 12 8.0 12 8.0 12 9.0 12 9.0 13 0.0 13 0.0 13 0.0 13 1.0 13 1.0 13 0 10 9.0 11 0.0 11 0.0 11 0.0 11 1.0 11 1.0 11 1.0 11 2.0 11 2.0 11 2.0 11 2.0 14 0 94.9 95.3 95.6 95.9 96.2 96.4 96.7 96.9 97 .1 97.3 97.5 15 0 ... 215 .0 217 .0 218 .0 220.0 2 21. 0 222.0 223.0 10 0 17 5.0 17 6.0 17 7.0 17 8.0 18 0.0 18 1.0 18 1.0 18 2.0 18 3.0 18 4.0 18 4.0 11 0...

Ngày tải lên: 08/07/2014, 22:20

... 2.2.3). 2.2.2 Dead, imposed and wind loading Reference should be made to BS 6399 -1: 1984, BS6399-3 :19 88 and CP 3:Chapter V-2 :19 72 for the determination of the dead, imposed and wind loads. The weight of ... 5). Table 1 — Values of g f for ultimate limit states Combination Type of load g f Dead and imposed load Dead load (see note) Maximum Minimum 1...

Ngày tải lên: 08/07/2014, 22:20

... on formability BS 14 49 -1- 1.8 HS 3 or HS 4 (17 0) 2 (280) 2 14 0 Hot rolled low carbon steel sheet for cold forming BS EN 10 111 DD 11 or DD 12 (17 0) 2 Ð 14 0 Hot rolled high yield strength steel for ... 0.997 39 0. 414 10 0.9 91 40 0.407 11 0.980 41 0.400 12 0.9 61 42 0.394 13 0.935 43 0.388 14 0.903 44 0.382 15 0.868 45 0.376 16 0.8 31 46 0.3 71 17 0.794 47 0.366...

Ngày tải lên: 08/07/2014, 22:20

... L E /r K L E /r K 14 1. 000 70 0.703 13 0 0.283 20 0.984 80 0. 610 14 0 0.247 30 0.953 90 0.5 21 150 0. 217 40 0.905 10 0 0.444 16 0 0 .19 3 50 0.852 11 0 0.379 17 0 0 .17 1 60 0.786 12 0 0.326 18 0 0 .15 4 NOTE L E ... Code of practice for design of composite columns and frames; — Part 4: Code of practice for design of floors with profiled steel sheeting;...

Ngày tải lên: 08/07/2014, 22:20

... ¶ 1 Factor ¶ 1 Case (1) : sheeting Case (2): decking 2 0 .13 1. 0 1. 0 3 0.30 1. 0 1. 0 4 0.44 1. 04 1. 11 5 0.58 1. 13 1. 25 6 0. 71 1.22 1. 40 7 0.84 1. 33 1. 56 8 0.97 1. 45 1. 71 9 1. 10 1. 56 1. 88 10 1. 23 1. 68 ... 0.872 1. 113 1. 345 1. 569 1. 806 2 .12 5 2. 710 4.4 41 0.4 1. 076 1. 453 1. 826 2 .18 7 2.535 2. 910 3.446 4.498 8.057 0.5 1. 644 2 .17 1...

Ngày tải lên: 08/07/2014, 22:20

... +9.0 m/s 10 20 30 40 50 60 61 245 552 9 81 1530 2 210 74 270 589 10 30 15 90 2280 88 297 628 10 80 16 60 2360 10 4 324 668 11 30 17 20 2430 12 0 353 709 11 90 17 90 2 510 13 8 383 7 51 1240 18 50 2590 15 7 414 794 13 00 19 20 2670 17 7 447 839 13 50 19 90 2750 19 9 4 81 885 14 10 2060 2830 2 21 516 932 14 70 213 0 2920 P ... 88 BS 6399-2 :19 97 22 © BSI 10 -...

Ngày tải lên: 08/07/2014, 22:20

... Specification for SI units and recommendations for the use of their multiples and of certain other units 1) . BS 6399, Loading for buildings. BS 6399 -1, Code of practice for dead and imposed loads. BS ... roofs BRITISH STANDARD BS 6399-3: 19 88 Incorporating Amendments Nos. 1 and 3 and Implementing Amendment No. 2 Loading for buildings — Part 3:...

Ngày tải lên: 08/07/2014, 22:20

... cm in. cm 2 2 0-8 1. 4 650 34 220 1 2.5 15 8 -16 2.6 12 00 40 260 2 5 10 16 -20 3.2 14 50 47 300 3 8 6 20-adult 4.0 18 00 64 410 4 10 4 20-adult 4.8 2200 70 450 4 10 4 Cage sizes for other weights ... normal supplies of feed or water are interrupted in emergency situations. Recommended code of practice for the care and Recommended code of practice for the car...

Ngày tải lên: 31/03/2014, 08:20