Introduction to Modern Liquid Chromatography, Third Edition part 26 pptx

... heating, microparticles of silica spherical composit e Figure 5.10 Aggregation of microparticles to form totally porous particles. 212 THE COLUMN and the particles are strengthened by sintering. Small particles ... sol particles. Small, silica-sol particles are used to prepare particles with smaller pores; larger pores are formed from larger silica sol-particles. This aggregation method c...

Ngày tải lên: 04/07/2014, 01:20

... most laboratories that deal with a need for analyzing chemical mixtures are equipped for HPLC; it is often the first choice of technique Introduction to Modern Liquid Chromatography, Third Edition, ... as mobile phase; Equation (2 .26) k 0 value of k for a solute at the start of gradient elution LC × LC comprehensive two-dimensional liquid chromatography LLE liquid liquid ext...

Ngày tải lên: 04/07/2014, 01:20

... Chrommatogr., 5 (1967) 183. 25. J. J. Kirkland, ed., Modern Practice of Liquid Chromatography, Wiley-Interscience, New York, 1971. 26. T. Braumann, G. Weber, and L. H. Grimme, J. Chromatogr., 261 ... Switching, 79 2.7.7 Retention Predictions Based on Solute Structure, 80 Introduction to Modern Liquid Chromatography, Third Edition, by Lloyd R. Snyder, Joseph J. Kirkland, a...

Ngày tải lên: 04/07/2014, 01:20

... Quadrupoles and Ion Traps, 188 4.14.3 Other MS Detectors, 190 4.15 OTHER HYPHENATED DETECTORS, 191 Introduction to Modern Liquid Chromatography, Third Edition, by Lloyd R. Snyder, Joseph J. Kirkland, ... 158 4.3 INTRODUCTION TO INDIVIDUAL DETECTORS, 160 4.4 UV-VISIBLE DETECTORS, 160 4.4.1 Fixed-Wavelength Detectors, 163 4.4.2 Variable-Wavelength Detectors, 164 4.4.3 Diode-Arr...

Ngày tải lên: 04/07/2014, 01:20

... 5,5-diphenylhydantoin; 3, acetophenone; 4, benzonitrile; 5, 5-phenylpentanol; 6,anisole;7, toluene; 8, cis-chalcone; 9, ethylbenzene; 10, trans-chalcone. Conditions: 150 × 4.6-mm (5-μm) columns; 45% acetonitrile-water; ... 5, 3,4-dichloroaniline; 6, 2-nitrotoluene; 7, 3-nitrotoluene; 8, toluene; 9,3-nitro-o-xylene; 10, 4-nitro-m-xylene. Conditions: 250 × 4.6-mm (5-μm) C 8 column; acetonitrile...

Ngày tải lên: 04/07/2014, 01:20

... to ±1.5 unit for higher concentrations of the buffer). The buffer capacity of the mobile phase is proportional to buffer concentra- tion, which typically falls within a range of 5 to 25 mM. To ... reader may wish to skip this digression, proceed to Section 7.2.1.2, andreturntothepresent section as needed. We can define the ‘‘effective buffer capacity’’ of the mobile phase to mean...

Ngày tải lên: 04/07/2014, 01:20

... sulfonate concen- tration of 6 to 7 mM would provide maximum resolution of peaks 4 to 7 (placing peak 5 midway between peaks 4 and 6, but without moving peak 7 too close to peak 6). Figure 7.15d–f ... C 8 column (3-μmparti- cles); 15% methanol- buffer (pH-3.2); 35 ◦ C; 2.0 mL/min. Chromatograms recreated from data in [48]. 338 IONIC SAMPLES: REVERSED-PHASE, ION-PAIR, AND ION-EXCHANGE CH...

Ngày tải lên: 04/07/2014, 01:20

... required to achieve the desired retention range of 1 ≤ k ≤ 10, as well as to take advantage of solvent-strength selectivity. At the conclusion of exploratory TLC studies with silica plates, we need to ... often tolerate lower values of N (Section 15.4.1.1). 8.6 HYDROPHILIC INTERACTION CHROMATOGRAPHY (HILIC) Hydrophilic interaction chromatography (HILIC) can be regarded as normal-phase c...

Ngày tải lên: 04/07/2014, 01:20

... behavior can make it extremely difficult to obtain reproducible isocratic separations of macromolecules in different laboratories, or even within the same laboratory. Furthermore the isocratic separation ... separations by RPC (with fixed run times, for automated analysis) are only practical by means of gradient elution and are commonly used to assay combinatorial libraries [3], as well as...

Ngày tải lên: 04/07/2014, 01:20

... need to be applied to this value before the final sample concentration is reported. 11.4 QUANTITATIVE ANALYSIS 521 it in water or buffer to make a primary stock. This stock then is added to the ... Detector (CLND) The CLND (Section 4.9) responds to the nitrogen content of the analyte. Because the detector response is proportional to the molar content of nitrogen in the sample, the...

Ngày tải lên: 04/07/2014, 01:20