SolidWorks 2010- P9 pot

... Below the Type field, the second new field is used to specify the thread. In previous versions of SolidWorks, you were required to manually enter the thread size. Unless you already knew the size ... specify, you would need to look up the thread that worked with the diameter of the boss selected. In SolidWorks 2010, based on the diameter of the selected edge, the Size field should already...

Ngày tải lên: 01/07/2014, 22:20

... computer is able to support SolidWorks and it is installed onto your system, you can launch it by selecting Start ➢ Programs ➢ SolidWorks 2010 ➢ SolidWorks 2010 SPX.X ➢ SolidWorks 2010. NOte ... time launching SolidWorks for the first time, becoming familiar with the SolidWorks interface, and working with the CommandManager. Start SolidWorks Before installing and running...

Ngày tải lên: 01/07/2014, 22:20

... part itself, the reader of the drawing can make potentially expensive mistakes. Sometimes dimensions having to be placed in less than desirable spots on the drawing are unavoidable, but they ... continuous smooth line is created. Splines have many uses in SolidWorks, and you will be using them throughout your career as a SolidWorks designer. But in this section, you will be using the...

Ngày tải lên: 01/07/2014, 22:20

... drawing template and save the template in the templates folder referenced by SolidWorks. If you are unsure as to which folder SolidWorks uses for templates, check the folder path by selecting Tools ... left button of the mouse, a new explode step appears listed in the Explode PropertyManager, and SolidWorks is ready to accept a new selection to create the next exploded step. Click t...

Ngày tải lên: 01/07/2014, 22:20

Ngày tải lên: 30/10/2012, 08:48

... somewhere to keep your personal home page, you might want to carefully consider which of these spots has the aura you like. They definitely differ quite a bit! The following listing doesn’t ... Dead, the Well ( http://www.well.com ), which was created by the Whole Earth Access team, is the spot for you. Web page hosting is inexpen­ sive here (starting at $15 per month for each 10MB of

Ngày tải lên: 24/12/2013, 04:15

... information, in SolidWorks see Help, About. Other portions of SolidWorks 2009 are licensed from DS SolidWorks licensors. All Rights Reserved. Pre-Release DRAFT Do not copy or distribute Lesson 1 SolidWorks ... Tips On/Off Pre-Release DRAFT Do not copy or distribute SolidWorks 2010 Lesson 1 SolidWorks Basics and the User Interface 13 The SolidWorks User Interface The SolidWork...

Ngày tải lên: 06/01/2014, 22:28

... 13.2 Aufbereiten von eDrawings-Dateien aus SolidWorks 244 14 FE Analyse mit SolidWorks SimulationXpress 251  14.1 SolidWorks SimulationXpress und SolidWorks Simulation 251 14.2 Durchführen ... Fragen rund um SolidWorks Hilfe erhalten. Zum einen hat SolidWorks für den Ausbildungsbereich ein Forum eingerichtet, an dem Sie als registrierter Anwender teilhaben können (www.fo...

Ngày tải lên: 08/01/2014, 16:28

Ngày tải lên: 25/02/2014, 19:20

Ngày tải lên: 26/02/2014, 09:20