... Pollution Control Act of 1948 and the following Federal Water Pollution Control Act (FWPCA) of 1956, which set funds for research and assisted in state pollution control with construction of wastewater ... (6). Clearly, then, minimization is the first choice and the optimal one from an environmental standpoint. However, society demands a certain standard of living, so f...
Ngày tải lên: 20/06/2014, 03:20
... real risk reduction and performance improvement when information maintenance and management is required. For more active decision-making processes, the described framework for environmental decision ... toward human needs and use of the environment, and therefore addresses the science, engineering, and management practices which will help to conserve environmental resources fo...
Ngày tải lên: 20/06/2014, 03:20
Process Engineering for Pollution Control and Waste Minimization_3 ppt
... biomass, and water. 2.2 Council Directive on Landfill of Waste The aim of the Directive on landfill of waste is, by way of stringent operational and technical requirements on the waste and landfills, ... from landfilling of waste, during the whole life cycle of the landfill. In principle, each landfill shall be classified in one of the following classes: Landfill for hazardous...
Ngày tải lên: 20/06/2014, 03:20
Process Engineering for Pollution Control and Waste Minimization_4 docx
... is as fuel for process heat, and over one-fifth (gross) is in the form of electricity for furnaces, electrolytic processes, and electric motors. Most process heat is delivered in the form of steam, ... agricultural lands, forests, and areas of historical and geological value, and resulted in the dislocation of communities and loss of wildlife (6). Dam failure can cause cat...
Ngày tải lên: 20/06/2014, 03:20
Process Engineering for Pollution Control and Waste Minimization_5 potx
... These practices should include pollution control and waste minimization. Heat transfer equipment is subjected to fouling and corrosion, which are among the major hurdles for the operation. Fouling ... when feasible, in order to eliminate waste generation. Corrosion protection of heat transfer surfaces is a suggested practice for pollution control and waste minimizat...
Ngày tải lên: 20/06/2014, 03:20
Process Engineering for Pollution Control and Waste Minimization_6 ppt
... may not be present for the desired degradation reaction. 3 COMMON BIOPROCESSES USED FOR WASTE CONTROL 3.1 Suspended Growth The most widely studied and used suspended growth process is the activated sludge ... segregated and the biomass acclimated to the specific waste present (111 ,112 ). 3.2 Attached Growth Attached growth systems encompasses processes from biofilms to slime...
Ngày tải lên: 20/06/2014, 03:20
Process Engineering for Pollution Control and Waste Minimization_7 pdf
... Supply and Pollution Control, 5th ed. New York: Harper Collins, 1993. 114 . T. F. Yen, Environmental Chemistry: Essentials of Chemistry for Engineering Processes. New Jersey: Prentice Hall, 1999. 115 . ... of extraction and stripping Copyright 2002 by Marcel Dekker, Inc. All Rights Reserved. 11 Novel Materials and Processes for Pollution Control in the Mining Industry A...
Ngày tải lên: 20/06/2014, 03:20
Process Engineering for Pollution Control and Waste Minimization_8 pot
... zero and develop process flow diagrams for each waste type. A process flow diagram is an overview of the process that generates the waste. Process flow diagrams provide a summary of the processes ... and activities that result in the generation of waste. These diagrams are used to decompose each waste type into specific waste streams. For example, a waste type may be...
Ngày tải lên: 20/06/2014, 03:20
Process Engineering for Pollution Control and Waste Minimization_9 potx
... quantified and the waste streams were prioritized for minimization or prevention action. Process 1 Process 2 Segregate Inflows Path A Path B Process A1 Process B1 Process B2 1 Path A Waste Stream ... are not due until July, and loading and analyzing the data takes about a year. 2 ROLE OF POLLUTION PREVENTION AND DESIGN FOR THE ENVIRONMENT As methodologies for...
Ngày tải lên: 20/06/2014, 03:20
Process Engineering for Pollution Control and Waste Minimization_10 pot
... U)r If waste is further processed by physical, chemical, thermal, and/ or biolog- ical processing to recover secondary raw materials and/ or energy, then processed waste is determined by the waste ... particular pollution prevention effort. Production-adjusted measures of pollution prevention account for changes result- ing from pollution prevention efforts. For production-a...
Ngày tải lên: 20/06/2014, 03:20