Process Engineering for Pollution Control and Waste Minimization 6 ppt

Process Engineering for Pollution Control and Waste Minimization_1 pdf

Process Engineering for Pollution Control and Waste Minimization_1 pdf

... Pollution Control Act of 1948 and the following Federal Water Pollution Control Act (FWPCA) of 19 56, which set funds for research and assisted in state pollution control with construction of wastewater ... that assimilate it (6) . Clearly, then, minimization is the first choice and the optimal one from an environmental standpoint. However, society demands a certain stan...

Ngày tải lên: 20/06/2014, 03:20

26 501 0
Process Engineering for Pollution Control and Waste Minimization_2 pot

Process Engineering for Pollution Control and Waste Minimization_2 pot

... real risk reduction and performance improvement when information maintenance and management is required. For more active decision-making processes, the described framework for environmental decision ... toward human needs and use of the environment, and therefore addresses the science, engineering, and management practices which will help to conserve environmental resources fo...

Ngày tải lên: 20/06/2014, 03:20

26 379 0
Process Engineering for Pollution Control and Waste Minimization_3 ppt

Process Engineering for Pollution Control and Waste Minimization_3 ppt

... biomass, and water. 2.2 Council Directive on Landfill of Waste The aim of the Directive on landfill of waste is, by way of stringent operational and technical requirements on the waste and landfills, ... from landfilling of waste, during the whole life cycle of the landfill. In principle, each landfill shall be classified in one of the following classes: Landfill for hazardous...

Ngày tải lên: 20/06/2014, 03:20

26 322 0
Process Engineering for Pollution Control and Waste Minimization_4 docx

Process Engineering for Pollution Control and Waste Minimization_4 docx

... agricultural lands, forests, and areas of historical and geological value, and resulted in the dislocation of communities and loss of wildlife (6) . Dam failure can cause catastrophic floods and thousands ... is as fuel for process heat, and over one-fifth (gross) is in the form of electricity for furnaces, electrolytic processes, and electric motors. Most process heat i...

Ngày tải lên: 20/06/2014, 03:20

26 479 0
Process Engineering for Pollution Control and Waste Minimization_5 potx

Process Engineering for Pollution Control and Waste Minimization_5 potx

... These practices should include pollution control and waste minimization. Heat transfer equipment is subjected to fouling and corrosion, which are among the major hurdles for the operation. Fouling ... when feasible, in order to eliminate waste generation. Corrosion protection of heat transfer surfaces is a suggested practice for pollution control and waste minimizat...

Ngày tải lên: 20/06/2014, 03:20

26 472 0
Process Engineering for Pollution Control and Waste Minimization_6 ppt

Process Engineering for Pollution Control and Waste Minimization_6 ppt

... metals processing 13,39–45 Oil processing and refineries 46 49 Paint 50–53 Paper 6, 21,22,54–57 Pesticides 13,18,58 60 Pharmaceutical 61 66 Printing 19,20 ,67 ,68 Soap 46, 69 Tannery 22,70,71 Textiles ... plant and bacterial metabolic pathways ( 166 – 168 ). Lee and Choi ( 169 ) documented the four primary metabolic pathways for the biosynthesis of PHAs. Two pathways involve Rals...

Ngày tải lên: 20/06/2014, 03:20

26 350 0
Process Engineering for Pollution Control and Waste Minimization_7 pdf

Process Engineering for Pollution Control and Waste Minimization_7 pdf

... Toxic Inorganic Mining Processes and Waste Solutions. In N. McPherson and R. Nora, (eds.), Randol Gold Forum Conf. Proc., pp. 143–1 46. Golden CO: Randol Interna- tional, 19 96. Copyright 2002 by ... and F. Giralt, Strategies in Pollution Prevention: Waste Minimization and Source Reduction. AFINIDAD, vol 53, no. 462 , pp. 80–92, 19 96. 5. G. E. Tong, Integration of Biotechn...

Ngày tải lên: 20/06/2014, 03:20

26 455 0
Process Engineering for Pollution Control and Waste Minimization_8 pot

Process Engineering for Pollution Control and Waste Minimization_8 pot

... zero and develop process flow diagrams for each waste type. A process flow diagram is an overview of the process that generates the waste. Process flow diagrams provide a summary of the processes ... and activities that result in the generation of waste. These diagrams are used to decompose each waste type into specific waste streams. For example, a waste type may be...

Ngày tải lên: 20/06/2014, 03:20

26 401 0
Process Engineering for Pollution Control and Waste Minimization_9 potx

Process Engineering for Pollution Control and Waste Minimization_9 potx

... Die 10 8 10 7 10 6 10 5 10 4 10 3 10 2 10 1 10 0 1K 4K 16K 64 K 256K 1M 16M 4M 64 M 4004 8080 80 86 802 86 i3 86 i4 86 Pentium ® Memory Microprocessor Source: Intel Pentium ® II Pentium ® III 256M Pentium ® Pro FIGURE 3 Moore’s ... quantified and the waste streams were prioritized for minimization or prevention action. Process 1 Process 2 Segregate Inflows Path A Path B...

Ngày tải lên: 20/06/2014, 03:20

26 399 0
Process Engineering for Pollution Control and Waste Minimization_10 pot

Process Engineering for Pollution Control and Waste Minimization_10 pot

... U)r If waste is further processed by physical, chemical, thermal, and/ or biolog- ical processing to recover secondary raw materials and/ or energy, then processed waste is determined by the waste ... particular pollution prevention effort. Production-adjusted measures of pollution prevention account for changes result- ing from pollution prevention efforts. For production-a...

Ngày tải lên: 20/06/2014, 03:20

26 397 0
w