Process Engineering for Pollution Control and Waste Minimization 5 potx
Process Engineering for Pollution Control and Waste Minimization_1 pdf
... Pollution Control Act of 1948 and the following Federal Water Pollution Control Act (FWPCA) of 1 956 , which set funds for research and assisted in state pollution control with construction of wastewater ... (6). Clearly, then, minimization is the first choice and the optimal one from an environmental standpoint. However, society demands a certain standard of living, so...
Ngày tải lên: 20/06/2014, 03:20
Process Engineering for Pollution Control and Waste Minimization_2 pot
... real risk reduction and performance improvement when information maintenance and management is required. For more active decision-making processes, the described framework for environmental decision ... toward human needs and use of the environment, and therefore addresses the science, engineering, and management practices which will help to conserve environmental resources fo...
Ngày tải lên: 20/06/2014, 03:20
Process Engineering for Pollution Control and Waste Minimization_3 ppt
... biomass, and water. 2.2 Council Directive on Landfill of Waste The aim of the Directive on landfill of waste is, by way of stringent operational and technical requirements on the waste and landfills, ... from landfilling of waste, during the whole life cycle of the landfill. In principle, each landfill shall be classified in one of the following classes: Landfill for hazardous...
Ngày tải lên: 20/06/2014, 03:20
Process Engineering for Pollution Control and Waste Minimization_4 docx
... Johnson and L. A. Lewis, Land Degradation: Creation and Destruction. Cambridge, MA, and Oxford, U.K. Blackwell, 19 95. 15. Committee on Interior and Insular Affairs to Accompany HR 1 150 0, Surface ... is as fuel for process heat, and over one-fifth (gross) is in the form of electricity for furnaces, electrolytic processes, and electric motors. Most process heat is deliv...
Ngày tải lên: 20/06/2014, 03:20
Process Engineering for Pollution Control and Waste Minimization_5 potx
... These practices should include pollution control and waste minimization. Heat transfer equipment is subjected to fouling and corrosion, which are among the major hurdles for the operation. Fouling ... when feasible, in order to eliminate waste generation. Corrosion protection of heat transfer surfaces is a suggested practice for pollution control and waste minimizat...
Ngày tải lên: 20/06/2014, 03:20
Process Engineering for Pollution Control and Waste Minimization_6 ppt
... 22, 35, 36 Vegetables 37,38 Heavy metals processing 13,39– 45 Oil processing and refineries 46–49 Paint 50 53 Paper 6,21,22 ,54 57 Pesticides 13,18 ,58 –60 Pharmaceutical 61–66 Printing 19,20,67,68 Soap ... may not be present for the desired degradation reaction. 3 COMMON BIOPROCESSES USED FOR WASTE CONTROL 3.1 Suspended Growth The most widely studied and used suspended growt...
Ngày tải lên: 20/06/2014, 03:20
Process Engineering for Pollution Control and Waste Minimization_7 pdf
... pp. 65 73, 1997. 203. J. Adams, T. Pickett, and J. Montgomery, Biotechnologies for Metal and Toxic Inorganic Mining Processes and Waste Solutions. In N. McPherson and R. Nora, (eds.), Randol ... vol. 49, no. 5, pp. 35 40, 1999. 51 . N. V. Men’shutina, A. I. Shamber, V. Men’shikov, and R. Salakhetdinov, Installa- tions for Treatment of Wastewaters and Waste Gases from Pa...
Ngày tải lên: 20/06/2014, 03:20
Process Engineering for Pollution Control and Waste Minimization_8 pot
... zero and develop process flow diagrams for each waste type. A process flow diagram is an overview of the process that generates the waste. Process flow diagrams provide a summary of the processes ... and activities that result in the generation of waste. These diagrams are used to decompose each waste type into specific waste streams. For example, a waste type may be...
Ngày tải lên: 20/06/2014, 03:20
Process Engineering for Pollution Control and Waste Minimization_9 potx
... quantified and the waste streams were prioritized for minimization or prevention action. Process 1 Process 2 Segregate Inflows Path A Path B Process A1 Process B1 Process B2 1 Path A Waste Stream ... 38.7 6,489.0 1989 32 .5 5,7 05. 7 1990 24 .5 4,999.2 1991 28.7 4,411.4 1992 26.0 4,299.2 1993 20.9 3, 754 .6 1994 15. 3 3,134.9 19 95 22.3 2,637.6 1996 18.1 2 ,54 5.3 19...
Ngày tải lên: 20/06/2014, 03:20
Process Engineering for Pollution Control and Waste Minimization_10 pot
... of 5 Years Year Savings per year Cumulative savings 1 $52 5,000 $ 52 5,000 2 300,000 8 25, 000 3 280,000 1,1 05, 000 4 200,000 1,3 05, 000 5 1 25, 000 1,430,000 Copyright 2002 by Marcel Dekker, Inc. All ... adjusted waste generation) − (1994 actual waste generation) = 27 ,50 0 lb (12 ,50 0 kg)− 15, 000 lb (6,804 kg) = 12 ,50 0 lb (5, 680 kg) waste reduction Another way to examine t...
Ngày tải lên: 20/06/2014, 03:20