Mass Transfer in Chemical Engineering Processes Part 11 potx

... Fig. 5. Effect of mass transfer area on performance of MFC. Mass Transfer in Chemical Engineering Processes 240 In order to obtain the best oxidizer in cathode compartment, several oxidizers ... Mass Transfer in Chemical Engineering Processes 260 It may informative to note that the parameter , defined as (-f s )/() s in the formulation, coinc...

Ngày tải lên: 19/06/2014, 08:20

... corrosion in the metallic parts at the interior of the engine. The H 2 S is an inorganic acid that attacks the surface of metals when they are Mass Transfer in Chemical Engineering Processes 116 ... Mass Transfer in Chemical Engineering Processes 138  Amines: Monoethanolamine (MEA), Diethanolamine (DEA) and Methildiethanolamine (MDEA) are organic chemical...

Ngày tải lên: 19/06/2014, 08:20

... Vol. 16, No. 2, pp. 235-242, ISSN 0196-4313. Mass Transfer in Chemical Engineering Processes 286 increasing velocity gradient, as shown in Fig. 1(b). Here, use has been made of a graphite ... were then conducted, in order for further comparisons with experimental results. In this Part 2, it is intended to make use of the information obtained in Part 1, for explo...

Ngày tải lên: 19/06/2014, 08:20

... Wesselingh, J.A., The Maxwell – Stefan approach to mass transfer, Chemical Engineering Science, 52, (1997), 861 – 911 [5] Levenspiel, O., Modeling in chemical engineering, Chemical Engineering ... component in oil and gas phase 13 calculating the P in the PVT cell END 6 judging P 1 -P 2 <δ YES N O 11 judging phase equilibrium YES Mass Transfer...

Ngày tải lên: 18/06/2014, 22:20

... 150 0.0 0.2 0.4 0.6 0.8 1.0 A t /A inf Time (sec) Absorbance (a.u) Wavenumbers (cm -1 ) Fig. 11. Intensity (H2O/AC/PMMA system). Mass Transfer in Chemical Engineering Processes 34 transferred into the ... unsteady-state mass transfer, since the amount of dye in the fiber is continuously increasing. Following, Equation 8, was developed by Hill for describin...

Ngày tải lên: 18/06/2014, 22:20

... if operating conditions are providing efficiency close to maximal. In general, trays are used Mass Transfer in Chemical Engineering Processes 42 3. Mass transfer coefficients determination; ... the analysis of the products obtained during continuous operation, therefore permitting the use of the properties Mass Transfer in Chemical Engineering Processes 4...

Ngày tải lên: 18/06/2014, 22:20

... structured packings. Chemical Engineering and Processing, v. 31, 2, pp. 119 . Xu, Z. P., Afacan, A., Chuang, K. T. (2000). Predicting mass transfer in packed columns containing structured packings. ... Thermal Engineering , 2003, (23),pp. 989-1003. Mass Transfer in Chemical Engineering Processes 66 Lévêque, J., Rouzineau, D., Prévost, M., Meyer, M. (2009). Hydro...

Ngày tải lên: 18/06/2014, 22:20

... binary Mass Transfer in Chemical Engineering Processes 112 Rafajlovska, 1992; Kense, 1970; Rajaraman et al., 1981). Basically, PCO contains pigments carotenoids predominantly capsanthin ... v D vm F Mass Transfer in Chemical Engineering Processes 110 [25] Paixa˜o, A.E.A.; Rocha, S.C.S. Pneumatic drying in diluted phase: Parametric analysis of tube diame...

Ngày tải lên: 19/06/2014, 08:20

... CO 2 /kg amine) Ca (%v) DEA MEA Mass Transfer in Chemical Engineering Processes 162 optimal value of the electric field intensity E opt ≈ 400 V/cm, that results in maximal material disintegration ... Mass Transfer in Chemical Engineering Processes 148 that they depend on their concentration in water. They exhibit a minimum around 20% of volumetric concent...

Ngày tải lên: 19/06/2014, 08:20

... 1 Department of Chemical Engineering, Faculty of Engineering, King Mongkut’s Institute of Technology Ladkrabang, Bangkok, 2 Department of Chemical Engineering, Faculty of Engineering, Chulalongkorn ... were Mass Transfer in Chemical Engineering Processes 184 the concentration of stripping phase at membrane-stripping interface (C s *) and the concentration of tar...

Ngày tải lên: 19/06/2014, 08:20