daewoo matiz 2000-2013 engine exhaust - hệ thống điều khiển khí xả trên xe matiz đời 2000-2013

... (13–20 lb-ft). Tighten the exhaust manifold heat shield bolts to 8–12 NSm (71–106 lb-in). ENGINE EXHAUST 1G–7 DAEWOO M-150 BL2 D12G504B 3. Install the front exhaust pipe to pup-up catalytic con- vertor. Tighten Tighten ... nuts to 25–35 NSm (18–25 lb-ft). 3. Install the exhaust pipe-to-front muffler nuts. Tighten Tighten the nuts to 25–35 NSm (18–25 lb-ft) (a). 1G–8 ENGINE EXHA...

Ngày tải lên: 28/05/2014, 13:09

Ngày tải lên: 26/05/2014, 15:34

... the instru- ment panel temperature indicator. The coolant tempera- ture sensor is located on the distributor case with the ECT sensor on an SOHC engine. ENGINE COOLING 1D–5 DAEWOO M-150 BL2 COMPONENT ... Outlet Hose 20 Hose Bracket 1D–6 ENGINE COOLING DAEWOO M-150 BL2 RADIATOR/FAN D12D4021 1 Radiator Assembly 2 Electric Cooling Fan Assembly ENGINE COOLING 1D–7 DAEWOO M-150 BL2 DI...

Ngày tải lên: 28/05/2014, 13:08

... cap. Firing Order Fig. 3-2 8 Engine Configuration Firing Order V-8 1-8 - 4-3 - 6-5 - 7-2 V-6 1-2 - 3-4 - 5-6 In-line 6 1-5 - 3-6 - 2-4 In-line 4 1-3 - 4-2 Firing Order TOYOTA Technical Training 3-2 4 Section 3 Essentially, ... correction. Over Temperature Fig. 3-1 9 T852f148 Engine Control Systems I - Course 852 3-1 5 Ignition Syst...

Ngày tải lên: 28/03/2014, 09:19

... meeting MIL specifica- tion MIL-A-907) Lubricating oxygen sensor thread cleaning tool when re- conditioning exhaust system threads. S-NT703 S-NT704 S-NT815 S-NT705 AEM488 S-NT779 Revision: July ... Removes and installs engine coolant temperature sen- sor Oxygen sensor thread cleaner i.e.: (J-4389 7-1 8), (J-4389 7-1 2) Reconditioning the exhaust system threads before in- stalling a...

Ngày tải lên: 12/04/2014, 16:06

Ngày tải lên: 27/04/2014, 18:09

... DIAGRAM C24 93 C24 103 C24 126 A24 33 A24 CA2 CA2 9 19 1 3 2 B-W B L L W 5 4 W G IACA VCIA INTAKE AIR CONTROL VALVE ECM EIA IAC+ IAC- IACA VCIA EIA IAC+ IAC- C33 A135688E02 2AZ-FE INTAKE – INTAKE AIR CONTROL SYSTEM IT–3 IT ON-VEHICLE INSPECTION 1. ... in.*lbf) 9.0 (92, 80 in.*lbf) AIR CLEANER CAP SUB-ASSEMBLY NO. 1 ENGINE COVER SUB-ASSEMBLY AIR CLEANER INLET ASSEMBLY AIR CLEANER CASE SUB-AS...

Ngày tải lên: 23/05/2014, 16:34

... OK – ENGINE CONTROLS 1F–291 DAEWOO M-150 BL2 Detonation/Spark Knock (Cont’d) Step Action Value(s) Yes No 12 1. Inspect for carbon buildup inside the engine. 2. Remove the carbon with a top engine ... complete? – System OK – ENGINE CONTROLS 1F–297 DAEWOO M-150 BL2 ROUGH, UNSTABLE, OR INCORRECT IDLE, STALLING Definition: The engine runs unevenly at idle. If the condi- tion is bad...

Ngày tải lên: 28/05/2014, 13:08

... DAEWOO M-150 BL2 SECTION 9O BUMPERS AND FASCIAS TABLE OF CONTENTS Description and Operation 9O-2. . . . . . . . . . . . . . . . . . Bumpers 9O-2. . . . . . . . . . . ... . . . . On-Vehicle Service 9O-4. . . . . . . . . . . . . . . . . . . . . . . . . . Front Bumper Fascia 9O-4. . . . . . . . . . . . . . . . . . . . . . Front Bumper Impact Bar 9O-5. . . . . ... Rear Bumper Fascia 9O-6....

Ngày tải lên: 28/05/2014, 13:07

... Pinion Steering Gear 6D-3. . . . . . . Diagnostic Information and Procedures 6D-4. . . . . Manual Rack and Pinion Steering Gear 6D-4. . . . . . . Straight-Ahead Check 6D-5. . . . . . . . . . ... this section. 6D –18 MANUAL STEERING GEAR DAEWOO M-150 BL2 SPECIAL TOOLS AND EQUIPMENT SPECIAL TOOLS TABLE D105B101 KM–507–B Ball Joint Remover DAEWOO M-150 BL2 SECTION 6D MANUAL STEERING GEAR...

Ngày tải lên: 28/05/2014, 15:29