... methods of exploration, such as SPT, CPT, etc. to establish stratification of the subsurface materials, the profile of the top of bedrock and bedrock quality, depth to groundwater, limits of types of ... Number of Exploration Points and Depth of Exploration (Modified after Sabatini, et al., 2002) Application Minimum Number of Exploration Points and Location of Exploration...
Ngày tải lên: 06/09/2012, 15:57
... lower portion of the shaft. The value of is often considered to vary as a function of S u . Values of for drilled shafts are recommended as shown in Equations 2 and 3, based on the results of back-analyzed, ... diameter of drilled shaft (FT) Z = penetration of shaft (FT) S u = undrained shear strength (KSF) The value of S u should be determined from the results of in-situ...
Ngày tải lên: 29/09/2013, 12:20
SECTION 10 FOUNDATIONS TABLE OF CONTENTS [TO BE FURNISHED WHEN SECTION IS FINALIZED] - DRIVEN PILES
... Table 1 are a function of the center-to-center (CTC) spacing of piles in the group in the direction of loading expressed in multiples of the pile diameter, B. The values of P m in Table 1 were ... RESISTANCE OF PILE GROUPS IN COMPRESSION For pile groups in clay, the nominal axial resistance of the pile group shall be taken as the lesser of: The sum of the individual nomina...
Ngày tải lên: 29/09/2013, 12:20
SECTION 10 FOUNDATIONS TABLE OF CONTENTS [TO BE FURNISHED WHEN SECTION IS FINALIZED] - EXTREME LIMIT STATES
... consolidation settlement of each increment analyzed separately. The total value of S c is the summation of S c for each increment. The magnitude of consolidation settlement depends on the consolidation properties of ... height of the layer. Computations to predict the time rate of consolidation based on the result of laboratory tests 10-60 Figure 10.6.2.4.3-4 – Percentage of...
Ngày tải lên: 29/09/2013, 12:20
SECTION 10 FOUNDATIONS TABLE OF CONTENTS [TO BE FURNISHED WHEN SECTION IS FINALIZED] - FOUNDATIONS
... methods of exploration, such as SPT, CPT, etc. to establish stratification of the subsurface materials, the profile of the top of bedrock and bedrock quality, depth to groundwater, limits of types of ... number of soil layers within zone of stress influence of the footing (DIM) (10.4.6.2.4) (10.6.2.4.2) n h = rate of increase of soil modulus with depth (KSI/ft) (10.4.6.3...
Ngày tải lên: 29/09/2013, 12:20
table of contents
... Tilburg, The Netherlands, the 9 th of July 1996 1 Intelligent Software Agents on the Internet Table of Contents http://www.hermans.org/ag ents Table of Contents ... Intelligent Software Agents on the Internet: an inventory of currently offered functionality in the information society & a prediction of (near-)future developments by ... Hermans __________ "[ ] Agents ar...
Ngày tải lên: 05/10/2013, 13:20
TABLE OF CONTENTS
... adequacy of the information presented, including the number of ideas, the development of ideas, and the depth and specificity of supporting details • COHERENCE: the organization and clarity of the ... objective of the assignment is achieved and the response is appropriate for the intended audience • COHERENCE: organization and clarity of ideas • CONTENT: development of ideas a...
Ngày tải lên: 22/10/2013, 12:15
Tài liệu Next Generation Frame 600 mm Products Table of Contents doc
... of the frame the FCB is to be mounted on Adapter/Connector Type Specific adapter/connector type required in the FCB Pigtail Type Type of pigtail required Number of Pigtail Assemblies Number of ... Minneapolis, Minnesota USA 55440-1101 Specifications published here are current as of the date of publication of this document. Because we are continuously improving our products, ADC...
Ngày tải lên: 10/12/2013, 17:15
Tài liệu Table of Contents doc
... Ta ble of Contents Preface vii 1. Getting Star ted 1 Working in the Unix Environment 1 Syntax of Unix Command Lines 11 Types of Commands 14 The Unresponsive Ter
Ngày tải lên: 11/12/2013, 03:15
Tài liệu Table of contents pdf
... Table of contents Managementhandbook 01 - chapter 01 Page 1 of 2 Table of contents Nr. Designation Pages 01. Table of contents 1 02. Modifications 3 03. Declaration of liability ... Pages 01. Table of contents 1 02. Modifications 3 03. Declaration of liability 3 04. Administration of the manual 1 05. Company portrait 1 06. Introduction 1 07...
Ngày tải lên: 12/12/2013, 00:15